Sampling Disturbance Effects in Normally Consolidated Clays
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 128, Issue 12
Abstract
The effects of sampling disturbance are investigated by performing single element triaxial tests in which specimens of normally consolidated resedimented Boston blue clay are disturbed according to the “perfect sampling approach” (PSA) and the “ideal sampling approach” (ISA). The effects of PSA and ISA disturbance on the compression and undrained shear behavior of the soil are quantified by comparison with the intact behavior. The results indicate that the release of shear stress associated with PSA disturbance causes a modest change in the engineering properties of the soil. The effects of ISA disturbance are, on the other hand, very significant and increase systematically with the amplitude of the strain imposed. An increase in disturbance causes a decrease in the compression ratio, a decrease in the undrained strength, and an increase in the strain at failure and the recompression ratio, but has a minor effect on the preconsolidation pressure. These effects derive from the decrease in effective stress and from the damage to the soil fabric that occur as a result of sampling. The loss in undrained strength is primarily controlled by the decrease in effective stress and the post-disturbance strength ratio may be related to the “induced” overconsolidation ratio through a SHANSEP equation.
Get full access to this article
View all available purchase options and get full access to this article.
References
Atkinson, J. H., Allman, M. A., and Boese, R. J.(1992). “Influence of laboratory sample preparation procedures on the strength and stiffness of intact Bothkennar soil recovered using the Laval sampler.” Géotechnique, 42(2), 349–354.
Baligh, M. M.(1985). “Strain path method.” J. Geotech. Eng., 111(9), 1108–1136.
Baligh, M. M., Azzouz, A. S., and Chin, C.-T.(1987). “Disturbances due to ‘ideal’ tube sampling.” J. Geotech. Eng., 113(7), 739–757.
Becker, D. E., et al. (1987). “Work as a criterion for determining in situ and yield stresses in clays.” Can. Geotech. J., 24(4), 549–564.
Bjerrum, L. (1973). “Problems of soil mechanics and construction on soft clays: OSA report.” Proc., 8th Int. Conf. on Soil Mechanics and Foundation Engineering, Moscow, USSR, 3, 111–159.
Budhu, M., and Wu, C. S.(1992). “Numerical analysis of sampling disturbances in clay soils.” Int. J. Numer. Analyt. Meth. Geomech., 16, 467–492.
Cauble, D. F. (1993). “The behavior of resedimented Boston blue clay at OCR4 in cyclic and post-cyclic undrained direct simple shear.” MS thesis, Dept. of Civil and Environmental Engineering, Massachusetts Inst. of Technology, Cambridge, Mass.
Clayton, C. R. I., Hight, D. W., and Hopper, R. J.(1992). “Progressive destructuring of Bothkennar clay: Implications for sampling and reconsolidation procedures.” Géotechnique, 42(2), 219–239.
Hight, D. W., et al. (1992). “Disturbance of the Bothkennar clay prior to laboratory testing.” Géotechnique, 42(2), 199–217.
Hird, C. C., and Hajj, A. R.(1995). “A simulation of tube sampling effects on the stiffness of clays.” Geotech. Test. J., 18(1), 3–14.
Hvorslev, M. J. (1949). “Subsurface exploration and sampling of soils for civil engineering purposes.” Report on a research project of ASCE, U.S. Army Engineer Experiment Station, Vicksburg, Miss.
Jamiolkowski, M., et al. (1985). “New developments in field and laboratory testing of soils.” Proc., 11th Int. Conf. on Soil Mechanics and Foundation Engineering, San Francisco, 1, 57–153.
Ladd, C. C., and Foott, R.(1974). “New design procedure for stability of soft clays.” J. Geotech. Eng., 100(7), 763–786.
Ladd, C. C., and Lambe, T. W. (1963). “The strength of undisturbed clay determined from undrained tests.” Symp. on Laboratory Shear Testing of Soils, ASTM, STP No. 361, 342–371.
Ladd, C. C., et al. (1999). “Engineering properties of Boston blue clay from special testing program.” Proc., Special Geotechnical Testing: Central Artery/Tunnel Project in Boston, Massachusetts, GSP 91, GeoCongress ’98, ASCE, Boston, 1–24.
La Rochelle, P., et al. (1981). “Causes of sampling disturbance and design of a new sampler.” Can. Geotech. J., 18(1), 52–66.
Mesri, G., and Godlewski, P. M.(1977). “Time and stress-compressibility interrelationship.” J. Geotech. Eng., 103(5), 417–430.
Noorany, I., and Poormand, I.(1973). “Effect of sampling on compressibility of soft clay.” J. Soil Mech. Found. Div., Am. Soc. Civ. Eng., 99(12), 1184–1188.
Noorany, I., and Seed, H. B.(1965). “In-situ strength characteristics of soft clays.” J. Soil Mech. Found. Div., Am. Soc. Civ. Eng., 91(2), 49–80.
O’Neill, D. (1985). “Undrained strength anisotropy of an overconsolidated tixotropic clay.” MS thesis, Dept. of Civil Engineering, Massachusetts Inst. of Technology, MIT, Cambridge, Mass.
Santagata, M. C. (1994). “Simulation of sampling disturbance in soft clays using triaxial element tests.” MS thesis, Dept. of Civil and Environmental Engineering, Massachusetts Inst. of Technology, Cambridge, Mass.
Santagata, M. C. (1998). “Factors affecting the initial stiffness and stiffness degradation of cohesive soils.” PhD thesis, Dept. of Civil and Environmental Engineering, Massachusetts Inst. of Technology, Cambridge, Mass.
Santagata, M. C., Germaine, J. T., and Ladd, C. (1999). “Initial stiffness of RBBC measured in the triaxial apparatus.” Proc., 2nd Int. Symp. on Pre-Failure Defomation Characteristics of Geomaterials, Torino, Italy, Vol. 1, 27–34.
Schmertmann, J. H.(1955). “The undisturbed consolidation behavior of clay.” Trans. Am. Soc. Civ. Eng., 120, 1201–1227.
Sheahan, T. C., and Germaine, J. T.(1992). “Computer automation of conventional triaxial equipment.” Geotech. Test. J., 15(4), 311–322.
Siddique, A., Clayton, C. R. I., and Hopper, R. J.(1999). “The effects of varying centerline tube sampling disturbance on the behavior of reconstituted clay.” Geotech. Test. J., 22(3), 245–256.
Sinfield, J. V. (1994). “An experimental investigation of sampling disturbance effects in resedimented Boston blue clay.” MS thesis, Dept. of Civil and Environmental Engineering, Massachusetts Inst. of Technology, Cambridge Mass.
Skempton, A. W., and Sowa, V. A.(1963). “The behaviour of saturated clays during sampling and testing.” Géotechnique, 23(4), 269–290.
Terzaghi, K., Peck, R. B., and Mesri, G. (1996). Soil mechanics in engineering practice, 3rd Ed., Wiley, New York.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 128 • Issue 12 • December 2002
Pages: 997 - 1006
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Apr 12, 2000
Accepted: Apr 24, 2002
Published online: Nov 15, 2002
Published in print: Dec 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.