Runout Analysis of Slurry Flows with Bingham Model
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 128, Issue 12
Abstract
In this paper, the Lagrangian finite element method is formulated along with the Bingham model for simulating natural transient slurry flows. The numerical model thus developed is validated with available experimental results. As well, a back-analysis of the dynamic behavior of the 1997 Lai Ping Road landslide in Hong Kong is conducted. Correlating well with field observations, the modeling results are satisfactory in terms of predicting the hazard areas of the debris trail during runout and the debris distribution on deposition fan. The present method is also able to demonstrate the multidirectional sliding features of natural slurry flows. It is noteworthy that the availability of high quality data on site topography is crucial for modeling such a gravity-driven flow. A knowledge of dynamic runout information is useful in estimating landslide mobility, potential hazard areas, and debris impact loads, and in evaluating the effectiveness of counter measures in the debris released area, in relation to downslope property development.
Get full access to this article
View all available purchase options and get full access to this article.
References
Bingham, E. C., and Green, H.(1919). “Paint, a plastic material and not a viscous liquid; the measurement of its mobility and yield value.” Proc. Am. Soc. Test. Mater., Pt. II, 19, 640–664.
Chen, H., and Lee, C. F.(2000). “Numerical simulation of debris flows.” Can. Geotech. J., 37, 146–160.
Coussot, P.(1994). “Steady, laminar, flow of concentrated mud suspensions in open channel.” J. Hydraul. Res., 32(4), 535–559.
Coussot, P. (1997). Mudflow rheology and dynamics, A. A. Balkema, Rotterdam, The Netherlands, 156–157.
Dent, D. J., and Lang, T. E.(1983). “A biviscous modified Bingham model of snow avalanche motion.” Ann. Glaciol., 4, 42–46.
Geotechnical Engineering Office (GEO). (1998). Report on The Lai Ping Road Landslide of 2 July, 1997, for the Hong Kong Government, Geotechnical Engineering Office.
Herschel, W. H., and Bulkley, R.(1926). “Measurement of consistency as applied to rubber-benzene solutions.” Proc. Am. Soc. Test. Mater., Pt. II, 26, 621–633.
Hungr, O.(1995). “A model for the runout analysis of rapid flow slides, debris flows, and avalanches.” Can. Geotech. J., 32, 610–623.
Hutchinson, J. N.(1986). “A sliding-consolidation model for flow slides.” Can. Geotech. J., 23, 115–126.
Iverson, R. M.(1997). “The physics of debris flows.” Rev. Geophys., 35(3), 245–296.
Jeyapalan, J. K., Duncan, J. M., and Seed, H. B.(1983). “Investigation of flow failures of tailings dams.” J. Geotech. Eng., 109(2), 172–189.
Johnson, A. M. (1970). Physical processes in geology, Freeman, Cooper & Company, 431–459.
Mainali, A., and Rajaratnam, N.(1994). “Experimental study of debris flows.” J. Hydraul. Eng., 120(1), 104–123.
Miao, T. D., Liu, Z. Y., Niu, Y. H., and Ma, C. W.(2001). “A sliding block model for the runout prediction of high-speed landslides.” Can. Geotech. J., 38, 217–226.
O’Brien, J. S., and Julien, P. Y. (1985). “Physical properties and mechanics of hyperconcentrated sediment flows.” Proc., ASCE Specialty Conf. on the Delineation of Landslides, Floods and Debris Flow Hazards in Utah, ASCE, New York, 260–279.
O’Brien, J. S., and Julien, P. Y.(1988). “Laboratory analysis of mudflow properties.” J. Hydraul. Eng., 114(8), 877–887.
O’Brien, J. S., and Julien, P. Y. (1997). “On the importance of mudflow routing.” Proc., 1st Int. Conf. on Debris-Flow Hazards, Mitigation: Mechanics, Prediction and Assessment, ASCE, Reston, Va., 677–686.
Savage, S. B.(1984). “The mechanics of rapid granular flows.” Adv. Appl. Mech., 24, 289–366.
Savage, S. B., and Hutter, K.(1989). “The motion of a finite mass of granular material down a rough incline.” J. Fluid Mech., 199, 177–215.
Takahashi, T.(1981). “Debris flow.” Annu. Rev. Fluid Mech., 13, 57–77.
Takahashi, T. (1991). Debris flow, A. A. Balkema, Rotterdam, The Netherlands.
Tattersall, G. H., and Banfill, P. F. G. (1983). The rheology of fresh concrete, Pitman, Boston.
van Kessel, T., and Kranenburg, C.(1996). “Gravity current of fluid mud on sloping bed.” J. Hydraul. Eng., 122(12), 710–717.
Varnes, D. J. (1978). “Slope movement types and processes.” Special Rep. No. 176:11-33, Landslide, analysis and control, Transportation Research Board, National Academy of Sciences, Washington, D.C.
Wildemuth, C. R., and Williams, M. C.(1985). “A new interpretation of viscosity and yield stress in dense slurries: coal and other irregular particles.” Rheol. Acta, 24, 75–91.
Information & Authors
Information
Published In
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Jun 27, 2001
Accepted: Apr 20, 2002
Published online: Nov 15, 2002
Published in print: Dec 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.