Performance of Geosynthetic Reinforced Slopes at Failure
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 124, Issue 8
Abstract
A centrifuge testing program was undertaken to investigate the failure mechanisms of geosynthetic reinforced soil slopes and to evaluate the assumptions in their design. Scaling laws were established so that factors of safety in the models would be identical to those in prototype structures. Failure of the models was characterized by well-defined shear surfaces through the toe of the slopes, which is in good agreement with current design methods for reinforced slopes based on limit equilibrium. The moment of failure was defined by a sudden change in the rate of settlements at the crest of the slope. In contrast to the assumption in current design procedures that failure should initiate at the toe of a reinforced slope, failure initiated at midheight of the slopes. Model deformations were found to depend on the backfill properties, but were essentially independent of the tensile strength and spacing of the reinforcements. The test results showed that overlapping reinforcement layers contribute to stability as they failed by breakage instead of by pullout when intersected by the failure surfaces. The experimental results also indicate that stability of the reinforced slopes is governed by the peak shear strength and not by the critical state shear strength of the backfill soil. A new distribution of maximum reinforcement forces with depth, which is consistent with the failure mechanism observed in the models, is proposed for geosynthetic reinforced soil slopes.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Adib, M. E. (1988). “Internal lateral earth pressure in earth walls,” PhD dissertation, Dept. of Civ. Engrg., University of California, Berkeley, Calif.
2.
Allen, T. M., Christopher, B. R., and Holtz, R. D. (1991). “Performance of a 12.6 m high geotextile wall in Seattle, Washington.”Int. Symp. on Geosynthetic-Reinforced Soil Retaining Walls, A. A. Balkema, Rotterdam, The Netherlands, 81–100.
3.
Bonaparte, R., and Schmertmann, G. R. (1987). “Reinforcement extensibility in reinforced soil wall design.”The application of polymeric reinforcement in soil retaining structures, P. M. Jarrett and A. McGown, eds., Nato Advanced Research Workshop, Royal Military College of Canada, Ont., Canada, 409–457.
4.
Christopher, B., Bonczkiewicz, C., and Holtz, R. (1992). “Design, construction and monitoring of full scale test of reinforced soil walls and slopes.”Recent case histories of permanent geosynthetic-reinforced soil retaining walls, F. Tatsuoka and D. Leshchinsky, eds., A. A. Balkema, Tokyo, Japan, 45–60.
5.
Christopher, B. R., et al. (1990). “Design and construction guidelines for reinforced soil structures—volume I.”Rep. No. FHWA-RD-89-043, Federal Highway Administration, U.S. Department of Transportation, Washington, D.C.
6.
Fellenius, W. (1936). “Calculation of the stability of earth dams.”Proc., 2nd Congr. Large Dams, Vol. 4, Washington, D.C., 445–462.
7.
Hird, C. C., Pyrah, I. C., and Russell, D.(1990). “Finite element analysis of the collapse of reinforced embankments on soft ground.”Géotechnique, London, U.K., 40(4), 633–640.
8.
Jaber, M., and Mitchell, J. K. (1990). “Behaviour of reinforced soil walls at limit state.”Performance of reinforced soil structures, A. McGown, K. Yeo, and K. Z. Andrawes, eds., Thomas Telford Ltd., London, U.K., 53–57.
9.
Jewell, R. A.(1991). “Application of revised design charts for steep reinforced slopes.”Geotextiles and Geomembranes, 10, 203–233.
10.
Juran, I., and Christopher, B. R.(1989). “Laboratory model study on geosynthetic reinforced soil retaining walls.”J. Geotech. Engrg., ASCE, 115(7), 905–926.
11.
Lee, K. L., Adams, B. D., and Vagneron, J. J. (1973). “Reinforced earth retaining walls.”J. Soil Mech. and Found. Div., ASCE, 99(10), 745– 764.
12.
Leshchinsky, D., and Boedeker, R. H.(1989). “Geosynthetic reinforced soil structures.”J. Geotech. Engrg., ASCE, 115(10), 1459–1478.
13.
Liang, R. K., Tse, E. C., Kuhn, M. R., and Mitchell, J. K. (1984). “Evaluation of a constitutive model for soft clay using the centrifuge.”Proc., Symp. on Recent Adv. in Geotech. Centrifuge Modeling, University of California, Davis, Calif., 55–70.
14.
McGown, A., Murray, R. T., and Jewell, R. A. (1989). “State-of-the-art report on reinforced soil.”Proc., 12th Int. Conf. Soil Mech. and Found. Engrg., A. A. Balkema, Rotterdam, The Netherlands, 4.
15.
Mitchell, J. K., and Christopher, B. R. (1990). “North American practice in reinforced soil systems.”Des. and Perf. of Earth Retaining Struct., Geotech. Spec. Publ. No. 25, ASCE, June, 322–346.
16.
Mitchell, J. K., Jaber, M., Shen, C. K., and Hua, Z. K. (1988). “Behavior of reinforced soil walls in centrifuge model tests.”Proc., Centrifuge 88, A. A. Balkema, Rotterdam, The Netherlands, 259–271.
17.
San, K., Leshchinsky, D., and Matsui, T.(1994). “Geosynthetic reinforced slopes: Limit equilibrium and finite element analysis.”Soils and Found., Tokyo, Japan, 34(2), 79–85.
18.
Schmertmann, G. R., Chouery-Curtis, V. E., Johnson, R. D., and Bonaparte, R. (1987). “Design charts for geogrid-reinforced soil slopes.”Proc., Geosynthetics'87 Conf., New Orleans, La., 108–120.
19.
Schofield, A.(1980). “Cambridge geotechnical centrifuge operations.”Géotechnique, 30(3), 227–268.
20.
Shen, C., Kim, Y., Bang, S., and Mitchell, J. K.(1982). “Centrifuge modeling of lateral earth support.”J. Geotech. Engrg. Div., ASCE, 108(9), 1150–1164.
21.
Zienkiewicz, O. C., and Taylor, R. L. (1991). The finite element method, 4th Ed., Vol. 2, McGraw-Hill Book Co. Inc., New York, N.Y.
22.
Zornberg, J. G. (1994). “Performance of geotextile-reinforced soil structures,” PhD dissertation, Dept. of Civ. Engrg., University of California, Berkeley, Calif.
23.
Zornberg, J. G., and Mitchell, J. K. (1994). “Finite element prediction of the performance of an instrumented geotextile-reinforced wall.”Proc., 8th Int. Conf. of the Int. Assn. for Comp. Methods and Adv. in Geomechanics (IACMAG'94), Vol. 2, A. A. Balkema, Rotterdam, The Netherlands, 1433–1438.
24.
Zornberg, J. G., Mitchell, J. K., and Sitar, N.(1997a). “Testing of reinforced soil slopes in a geotechnical centrifuge.”ASTM Geotech. Testing J., 20(4), 470–480.
25.
Zornberg, J. G., Sitar, N., and Mitchell, J. K. (1997b). “Failure of steep reinforced soil slopes.”Proc., Geosynthetics '97 Conf., Vol. 1, Long Beach, Calif., 55–72.
26.
Zornberg, J. G., Sitar, N., and Mitchell, J. K.(1998). “Limit equilibrium as basis for design of geosynthetic reinforced slopes.”J. Geotech. and Geoenvironmental Engrg., ASCE, 124(8), 684–698.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 124 • Issue 8 • August 1998
Pages: 670 - 683
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: Aug 1, 1998
Published in print: Aug 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.