Uncertainty in Back Analysis of Slopes: Kettleman Hills Case History
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 124, Issue 12
Abstract
A theoretical approach is described for back analysis to determine shear strengths from slope failures. This approach systematically accounts for uncertainties encountered in practice, including uncertainties in empirical information, laboratory test results, field measurements, and the slope stability model used in the back analysis. The approach is applied to a slope failure in the Kettleman Hills landfill to demonstrate its use. Insight is gained from this case history concerning uncertainties in (1) calculated factors of safety from two-dimensional, limit equilibrium methods and (2) mobilized strengths in strain-softening materials.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Ang, A. H-S., and Tang, W. H. (1975). Probability concepts in engineering planning and design. Vol. I, Basic principles. John Wiley & Sons, New York.
2.
Byrne, R. J., Kendall, J., and Brown, S. (1992). “Cause and mechanism of failure, Kettleman Hills landfill B-19, unit IA.”Proc., ASCE Spec. Conf. on Performance and Stability of Slopes and Embankments, Vol. 2, ASCE, Reston, Va., 1188–1215.
3.
Chandler, R. J.(1977). “Back analysis techniques for slope stabilization works: A case record.”Geotechnique, 27(4), 479–495.
4.
Duncan, J. M., Byrne, P., Wong, K. S., and Mabry, P. (1978). “Strength, stress-strain and bulk modulus parameters for finite element analyses of stresses and movements in soil masses.”Rep. No. UCB/GT/78-02, University of California, Berkeley, Calif.
5.
Duncan, J. M., and Stark, T. D. (1992). “Soil strengths from back analysis of slope failures.”Stability and Performance of Slopes and Embankments—II, Geotechnical Special Publication No. 31, Berkeley, Calif., 890–904.
6.
Duncan, J. M., and Wright, S. G.(1980). “The accuracy of equilibrium methods of slope stability analysis.”Engrg. Geology, 16(1), 5–17.
7.
Fredlund, D. G., and Krahn, J.(1977). “Comparison of slope stability analysis methods.”Can. Geotech. J., Ottawa, Canada, 14(3), 429–439.
8.
Gilbert, R. B., Liu, C.-N., Wright, S. G., and Trautwein, S. J. (1995). “A double shear test method for measuring interface strength.”Proc., Geosynthetics '95, IFAI, Nashville, Tenn., 1017–1030.
9.
Gilbert, R. B., Long, J. H., and Moses, B. E.(1996). “Analytical model of progressive slope failure in waste containment systems.”Int. J. Numer. and Analytical Methods in Geomech., 20(1), 35–56.
10.
Honjo, Y. (1991). “A statistical procedure to match subjective and objective information in geotechnical inverse analysis.”Proc., Int. Conf. on Applications of Statistics and Probability, 9–16.
11.
Janbu, N., L. Bjurrum, and Kjaernsli, B. (1956). “Veiledning ved Løsning av Fundamenteringsoppgaver—2. Stabilitetsberegning for Fyllinger, Skj;oeringer og Naturlige Skråninger [soil mechanics applied to some engineering problems—chapter 2. Stability calculations for embankments, cuts and natural slopes].”Publication 16, Norwegian Geotechnial Instiutute, Oslo, Norway, 17–26.
12.
Janbu, N. (1973). “Slope stability computations.”Embankment-dam engineering—Casagrande volume, R. C. Hirschfeld and S. J. Pouros, eds., John Wiley and Sons, New York, 47–86.
13.
Leonards, G. A.(1982). “Investigation of failures.”J. Geotech. Engrg., ASCE, 108(2), 187–246.
14.
Leroueil, S., and Tavenas, F. (1981). “Pitfalls of back-analyses.”Proc., 10th Int. Conf. on Soil Mech. and Found. Engrg., 185–190.
15.
Luckman, P. G., Der Kiureghian, A., and Sitar, N. (1987). “Use of stochastic stability analysis for Bayesian back calculation of pore pressures acting in a cut at failure.”Proc., Int. Conf. on Applications of Statistics and Probability in Soil and Struct. Engrg.
16.
Matsuo, M., and Asaoka, A.(1982). “Bayesian calibration of embankment safety under earthquake loading.”Struct. Safety, Amsterdam, The Netherlands, 1, 53–65.
17.
McCoy, B. F. (1996). “The development of a quasi three-dimensional slope stability method,” MS thesis, University of Texas at Austin, Austin, Tex.
18.
Mitchell, J. K., Seed, R. B., and Seed, H. B.(1990). “Kettleman Hills waste landfill slope failure. I: Linear system properties.”J. Geotech. Engrg., ASCE, 116(4), 647–668.
19.
Morgenstern, N. R., and Price, V. E.(1965). “The analysis of the stability of general slip surfaces.”Géotechnique, London, 15(1), 79–93.
20.
Seed, R. B., Mitchell, J. K., and Seed, H. B.(1990). “Kettleman Hills waste landfill slope failure. II: Stability analyses.”J. Geotech. Engrg., ASCE, 116(4), 669–690.
21.
Spencer, E.(1967). “A method of analysis of the stability of embankments assuming parallel inter-slice forces.”Géotechnique, London, 17(1), 11–26.
22.
Stark, T. D., and Poeppel, A. R. (1994). “Landfill liner interface strengths from torsional ring shear tests.”J. Geotech. Engrg., ASCE, 120(3), 597– 615.
23.
Tang, W. H. (1984). “Principles of probabilistic characterization of soil properties.”Proc., Symp. Probabilistic Characterization of Soil Properties, ASCE, Reston, Va., 74–89.
24.
Vanmarcke, E. H.(1977). “Reliability of earth slopes.”J. Geotech. Engrg. Div., ASCE, 103(11), 1247–1265.
Information & Authors
Information
Published In
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: Dec 1, 1998
Published in print: Dec 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.