Identification of a Distribution of Stiffness Reduction in Reinforced Concrete Slab Bridges Subjected to Moving Loads
Publication: Journal of Bridge Engineering
Volume 14, Issue 5
Abstract
The method for identifying arbitrary stiffness reduction in damaged reinforced concrete slab bridges under moving loads is proposed and dynamic signals measured at several points are used as response data to reflect the properties of the moving loads sensitivity. In particular, the change in stiffness in each element before and after damage, based on the system identification method, is described and discussed by using a modified bivariate Gaussian distribution function. The proposed method in this work is more feasible than the conventional element-based damage detection method from the computational efficiency because the procedure of finite-element analysis coupled with microgenetic algorithm using six unknown parameters irrespective of the number of elements are considered. The validity of the technique is numerically verified using a set of dynamic data obtained from a simulation of the actual bridge modeled with a three-dimensional solid element. The numerical calculations show that the proposed technique is a feasible and practical method that can prove the exact location of a damaged region as well as inspect the complex distribution of deteriorated stiffness, although there is a modeling error between actual bridge results and numerical model results as well as a measurement error like uncertain noise in the response data.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work is financially supported by the Korea Ministry of Construction and Transportation (MOCT) (05 Base Construction Grant No. UNSPECIFIEDD04-01), and the writers also thank MIDAS Information Technology Co. Ltd. for the service provided under the license.
References
Abu-Lebedh, G., and Benekothal, R. F. (1999). “Convergence variability and population sizing in micro-genetic algorithms.” Comput. Aided Civ. Infrastruct. Eng., 14, 321–334.
Au, F. T. K., Cheng, Y. S., Tham, L. G., and Bai, Z. Z. (2003). “Structural damage detection based on a micro-genetic algorithm using incomplete and noisy modal test data.” J. Sound Vib., 259(5), 1081–1094.
Bathe, K. J. (1996). The finite element procedures in engineering analysis, Prentice-Hall, Englewood Cliffs, N.J., 768–785.
Bu, J. Q., Law, S. S., and Zhu, X. Q. (2006). “Innovative bridge condition assessment from dynamic response of a passing vehicle.” J. Eng. Mech., 132(12), 1372–1379.
Buda, G., and Caddemi, S. (2007). “Identification of concentrated damages in Euler-Bernoulli beams under static loads.” J. Eng. Mech., 133(8), 942–956.
Carroll, D. L. (1996). “Chemical laser modeling with genetic algorithms.” AIAA J., 34(2), 338–346.
Chou, J. H., and Ghaboussi, J. (2001). “Genetic algorithms in structural damage detection.” Comput. Struct., 79, 1335–1353.
Devroye, L. (1986). Non-uniform random variate generation, Springer, New York.
Friswell, M. I., Penny, J. E. T., and Garvey, S. D. (1998). “A combined genetic and eigensensitivity algorithm for the location of damage in structures.” Comput. Struct., 69, 547–556.
Goldberg, D. E. (1989a). “Sizing populations for serial and parallel genetic algorithms.” Proc., 3rd Conf. on Genetic Algorithms, Morgan Kaufmann Publishers, San Francisco, 5, 29–37.
Goldberg, D. E. (1989b). Genetic algorithms in search, optimization and machine learning, Addison-Wesley, Reading, Mass.
Hassiotis, S., and Jeong, G. D. (1995). “Identification of stiffness reductions using natural frequencies.” J. Eng. Mech., 121(10), 1106–1113.
Hentz, S., Daudeville, L., and Donzé, F. V. (2004). “Identification and validation of a discrete element model for concrete.” J. Eng. Mech., 130(6), 709–719.
Krawczuk, M. (2002). “Application of spectral beam finite element with a crack and iterative search technique for damage detection.” Finite Elem. Anal. Design, 38, 537–548.
Krishnakumar, K. (1989). “Micro-genetic algorithms for stationary and non-stationary function optimization.” Proc. SPIE, 1196, 289–296.
Lee, S. Y., Park, T., and Voyiadjis, G. Z. (2008). “Detection of stiffness reductions in concrete decks with arbitrary damage shapes using incomplete dynamic measurements.” J. Eng. Mech., 134(7), 567–577.
Lee, S. Y., and Wooh, S. C. (2005). “Waveform-based identification of structural damage using the combined fem and microgenetic algorithms.” J. Struct. Eng., 131(9), 1464–1472.
Mares, C., and Surace, C. (1996). “An application of genetic algorithms to identify damage in elastic structures.” J. Sound Vib., 195, 195–215.
Marwala, T. (2000). “Damage identification using committee of neural networks.” J. Eng. Mech., 126(1), 43–50.
MIDAS. (2006). Civil analysis reference manual, civil (v7.12 Release No.1), Midas Information Technology, Livonia, Mich.
Pandey, A. K., Biswas, M., and Samman, M. M. (1991). “Damage detection from changes in curvature mode shapes.” J. Sound Vib., 145(2), 321–332.
Di Paola, M. D., and Bilello, C. (2004). “An integral equation for damage identification of Euler-Bernoulli beams under static loads.” J. Eng. Mech., 130(2), 225–234.
Ross, S. (2002). A first course in probability, 6th Ed., Prentice-Hall, Englewood Cliffs, N.J., 279–281.
Rus, G., Lee, S. Y., Chang, S. Y., and Wooh, S. C. (2006). “Optimized damage detection of steel plates from noisy impact test.” Int. J. Numer. Methods Eng., 68, 707–727.
Rus, G., Lee, S. Y., and Gallego, R. (2005). “Defect identification in laminated composite structures by BEM from incomplete static data.” Int. J. Solids Struct., 42, 1743–1758.
Sanayei, M., and Scampoli, S. F. (1991). “Structural element stiffness identification from static test data.” J. Eng. Mech., 117(5), 1021–1036.
Stubbs, N., Kim, J. T., and Farrar, C. R. (1995). “Field verification of a nondestructive damage localization and severity estimation algorithm.” Proc., 13th IMAC, SPIE, Bethel, Conn., 1, 210–218.
Suh, M. W., Shim, M. B., and Kim, M. Y. (2000). “Crack identification using hybrid neuro-genetic technique.” J. Sound Vib., 238(4), 617–635.
Vestroni, F., and Capecchi, D. (2000). “Damage detection in beam structures based on frequency measurements.” J. Eng. Mech., 126(7), 761–768.
Yang, J. N., and Pan, S. (2007). “Least-squares estimation with unknown excitations for damage identification of structures.” J. Eng. Mech., 133(1), 12–21.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Nov 1, 2007
Accepted: Feb 17, 2009
Published online: Aug 14, 2009
Published in print: Sep 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.