Monitoring of Steel Railway Floor Beams Prestressed by Steel Plates
Publication: Journal of Bridge Engineering
Volume 11, Issue 6
Abstract
Steel cables and tendons are commonly used in reinforcing steel beams as well as in concrete beams. However, the structural detail of cable anchors in steel beams tends to be complicated, and the effect on reducing live load stresses is not significant because of the relatively small stiffness of cables and tendons. On the contrary, by using high strength steel plates instead of cables and tendons, structural detail of the anchor area becomes simpler, and live load stresses as well as dead load stresses can be reduced in steel beams because of the relatively large stiffness of steel plates. In this study, the steel plate prestressing method is applied to beam specimens and intermediate floor beams of a steel railway through girder bridge. The behavior of the reinforcing steel plates and reinforced steel beams is monitored during prestressing and live loading, in order to assess the effects of prestressing and reinforcement. The study confirmed that these effects are beneficial to the performance of steel railway floor beams.
Get full access to this article
View all available purchase options and get full access to this article.
References
Japan Society of Steel Construction (JSSC). (1993). “Recommendations for fatigue design of steel structures.” (in Japanese).
Sakano, M., Hori, A., Namiki, N., Yamada, F., Tanaka, T., Yamamoto, S., and Horikawa, N. (2000). “Effect of pre-stressed steel plate on steel beam.” Proc., 7th Symp. on Repair and Rehabilitation of Steel Structures, JSSC, 57–64 (in Japanese).
Sakano, M., and Namiki, H. (2001). “Post tensioning of steel beam using high strength steel plate.” Current and future trends in bridge design, construction and maintenance, Vol. 2, Hong Kong, 292–298.
Sakano, M., Namiki, H., Horikawa, N., Yamamoto, S., and Osakada, Y. (2002). “Reinforcement of steel beams using high-strength steel plates with prestressing.” Proc., 1st Conf. on Bridge Maintenance, Safety and Management (CD-ROM), Barcelona, Spain.
Tsukamoto, H., and Motegi, H. (2000). “Reinforcement of steel girder.” Kawada Technical Rep. 19, 106–107 (in Japanese).
Yatsuzuka, M., Kashiwagi, R., Yamada, K., Natori, T., and Watanabe, Y. (1996). “Strengthening of existing plate girder bridge by pre-stressing tendons.” Bridge Found. Eng., 15–24 (in Japanese).
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: Dec 9, 2004
Accepted: Nov 15, 2005
Published online: Nov 1, 2006
Published in print: Nov 2006
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.