Load Rating of Masonry Arch Bridges: Refinements
Publication: Journal of Bridge Engineering
Volume 9, Issue 3
Abstract
In a paper previously published by the first writer, a procedure for load-rating masonry arch bridges was introduced. The procedure uses the Load Factor Method of the 1994 American Association of State Highway and Transportation Officials Manual for the Condition Evaluation of Bridges, applied to a frame analysis model of a masonry arch spanning from abutment to abutment. The procedure is based on the assumption of the arch barrel having no tensile strength. The objective of this technical note is to complement the initial procedure by enabling the assessing engineer to exercise discretion in deciding whether or not a small value of tensile strength should be allowable in determining a suitable rating for masonry arch bridges. In addition the initially proposed strength values, which are considered overly conservative, are increased. The introduction of these refinements will allow a more accurate assessment of the nation’s stock of stone masonry bridges.
Get full access to this article
View all available purchase options and get full access to this article.
References
Baker, I. O. (1907). A treatise on masonry construction, 9th Ed., Wiley, New York.
Boothby, T. E.(2001). “Load rating of masonry arch bridges.” J. Bridge Eng., 6(2), 79–86.
Boothby, T. E., Domalik, D. E., and Dalal, V.(1998). “Service load response of masonry arch bridges.” J. Struct. Eng., 124(1), 17–23.
Boothby, T. E., and Roberts, B. (2001). “Transverse strength of masonry arch bridges.” Proc., 8th North American Masonry Conf., (CD-Rom), The Masonry Society, Boulder, Colo.
Chetto, C. S., and Henderson, W.(1957). “Masonry arch bridges: a study.” Proc. Inst. Civ. Eng., Struct. Build., 7, 723–758.
Crisfield, M. A. (1985). “Finite element and mechanism methods for the analysis of masonry and brickwork arches.” Research Rep. No. 19, Transport and Road Research Laboratory Dept. of Transport, TRL, Crowthorne, U.K.
Davey, N. (1953). “Tests on road bridges.” Research Paper 16, National Building Studies, Her Majesty’s Stationery Office, London.
Department of Transport. (1997). Design manual for roads and bridges, Vol. 3, Sec. 4, Part 4, London.
Fanning, P. J., and Boothby, T. E.(2001). “Three-dimensional modelling and full-scale testing of stone arch bridges.” J. Comput. Struct., 79(29–30), 2645–2662.
Fanning, P. J., and Boothby, T. E.(2003). “Experiment-based assessment of masonry arch bridges.” Proc. Inst. Civ. Eng. Bridge Eng., 156(BE3), 109–116.
Hendry, A. W., Davies, S. R., Royles, R., Ponniah, D. A., Forde, M. C., and Komeyli-Birjandi, K. (1986). “Load test to collapse on a masonry arch bridge at Bargower, Strathclyde.” Contractor Rep. No. 26, Transport and Road Research Laboratory Dept. of Transport, TRL, Crowthorne, U.K.
Hughes, T. G., and Blackler, M. J.(1997). “A review of U.K. masonry arch assessment methods.” Proc. Inst. Civ. Eng., Struct. Build., 122, 305–315.
Molins, C., and Roca, P. (1998). “Load capacity of multi-arch bridges.” Arch bridges, A. Sinopoli, Ed., Balkema, Rotterdam, The Netherlands, 213–222.
Ng, K. N., Fairfield, C. A., and Sibbald, A.(1999). “Finite element analysis of masonry arch bridges.” Proc. Inst. Civ. Eng., Struct. Build., 134, 119–127.
Pippard, A. J. S., and Ashby, R. J.(1939). “An experimental study of the voussori arch.” Proc. Inst. Civ. Eng., Struct. Build., 10, 383–403.
Pippard, A. J. S., and Chitty, L. (1951). “A study of the voussoir arch.” Research Paper 11, National Building Studies, Her Majesty’s Stationery Office, London.
Towler, K. D. S. (1985). “The non-linear finite element analysis of Bridgemill Masonry Arch Bridge.” Masonry Int., J. Br. Masonry Soc., Vol. 5.
Trautwine, J. C. (1919). The civil engineer’s pocket-book, 20th Ed., 2nd issue, Philadelphia.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: Mar 29, 2002
Accepted: Nov 13, 2003
Published online: Apr 15, 2004
Published in print: May 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.