Tension Control Bolts: Strength and Installation
Publication: Journal of Bridge Engineering
Volume 3, Issue 1
Abstract
Tension control bolts are a type of alternative design fastener, permitted by the Research Council on Structural Connections. The bolt has a splined end that extends beyond the threaded portion of the bolt and an annular groove between the threaded portion of the bolt and the splined end. The special wrench required to install these bolts has two coaxial chucks—an inner chuck that engages the splined end and an outer chuck that envelopes the nut. The two chucks turn opposite to one another to tighten the bolt. At some point, the torque developed by the friction between the nut and bolt threads and at the nut-washer interface equals the shear resistance of the bolt material at the annual groove. The splined end of the bolt then shears off at the groove. If the system has been properly manufactured and calibrated, bolt pretension is achieved at this point. Factors that control the pretension are material strength, thread conditions, the diameter of the splined end, and the surface conditions at the nut-washer-joint interface. The program reported here investigated the pretension of production tension control bolts as it varies from manufacturer to manufacturer and under different aging, weathering, and thread conditions.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Kulak, G. L., and Birkemoe, P. C. (1993). “Field studies of bolt pretension.”J. Constr. Steel Res., 25(1 & 2), 95–106.
2.
Kulak, G. L., Fisher, J. W., and Struik, J. H. A. (1987). Guide to design criteria for bolted and riveted joints, 2nd Ed., Prentice-Hall, Englewood Cliffs, N.J.
3.
“LRFD bridge design specifications—SI units, 1st Ed.” (1994). Am. Assoc. of State Hwy. and Transp. Officials, Washington, D.C.
4.
“LRFD specification for structural joints using ASTM A325 or A490 bolts.” (1988). Res. Council on Struct. Connections, Am. Inst. of Steel Const., Chicago, Ill.
5.
“LRFD specification for structural steel buildings.” (1993). Am. Inst. of Steel Const., Chicago, Ill.
6.
“Recommended practice for testing of thread compound for rotary shouldered connections.” (1992). American Petroleum Institute, New York, N.Y.
7.
“Standard specification for structural bolts, steel, heat-treated, 120/105 ksi minimum tensile strength.” (1992). A325-92a, Am. Soc. for Testing and Materials, Philadelphia, Pa.
8.
Undershute, S. T., and Kulak, G. L. (1994). “Strength and installation characteristics of tension-control bolts.”Struct. Engrg. Rep. 201, Dept. of Civ. Engrg., Univ. of Alberta, Edmonton, Canada.
Information & Authors
Information
Published In
Journal of Bridge Engineering
Volume 3 • Issue 1 • February 1998
Pages: 15 - 20
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: Feb 1, 1998
Published in print: Feb 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.