Area-Rated Rational Coefficients for Portland Cement Pervious Concrete Pavement
Publication: Journal of Hydrologic Engineering
Volume 11, Issue 3
Abstract
Surface area specific runoff coefficients were measured for nonclogged Portland cement pervious concrete systems according to the rational method. The systems were simulated with pervious concrete blocks with porosities ranging from 16 to 27% placed over sand subbases. Rainfall was simulated in a flume setup with surface slopes ranging from 2 to 10%. There was negligible runoff for typical rainfall events under frequency in South Carolina. Runoff rates were also simulated for a combination of direct rainfall and additional stormwater runoff from adjacent areas. The results obtained are important for the design of pervious concrete runoff management systems.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers would like to thank members of the Carolina Ready Mixed Concrete Association, Dr. C. Pierce, Dr. J. Flora, Kevin Pulis, and Avery Fox for their contributions. The writers are grateful for funding from the Center for Manufacturing and Technology at the University of South Carolina.
References
Akan, A. O., and Houghtalen, R. J. (2003). “Urban hydrology, hydraulics and stormwater quality.” Rainfall for designing urban drainage systems, Wiley, Hoboken, N.J., 5–22.
American Society for Testing and Materials (ASTM). (2000). “ASTM D2434-38 standard test method for permeability of granular soils (constant head).” ASTM book of standards, section 4—Construction, vol. 04(08), Soil and Rock (1).
Becciu, G., and Paoletti, A. (2000). “Moments of runoff coefficient and peak discharge estimation in urban catchments.” J. Hydrologic Eng., 5(2), 197–205.
Das, B. M. (2002). “Principles of geotechnical engineering.” Hydraulic conductivity, 5th Ed., Brooks/Cole, Pacific Grove, Calif., 143–147.
Davies, J. W., Pratt, C. J., and Scott, M. A. (2002). “Laboratory study of permeable pavement systems to support hydraulic modeling.” Proc., Global Solutions for Urban Drainage, 9th Int. Conf. on Urban Drainage, ASCE, Reston, Va.
Environmental Protection Agency (EPA). (2004). “Post-construction stormwater management in new development and redevelopment.” ⟨http://cfpub.epa.gov/npdes/stormwater/menuofbmps/post.cfm⟩ (Aug. 4, 2004).
Garg, S. K. (1999). “Irrigation engineering and hydraulic structures.” Hydrology, 15th Ed., Khanna, New Delhi, India, 231–430.
Gopalakrishnan, G. (1995). “Estimation of annual runoff coefficients using a continuous simulation model.” Proc., Waterpower ’95 Int. Conf. on Hydropower, San Francisco, ASCE, Reston, Va., 2741–2753.
Gregory, R. L., and Arnold, C. E. (1932). “Runoff—Rational runoff formulas.” Trans. Am. Soc. Civ. Eng., 96, 1038.
Hunt, B., Stevens, S., and Mayes, D. (2002). “Permeable pavement use and research at two sites in eastern North Carolina.” Proc., Global Solutions for Urban Drainage, 9th Int. Conf. on Urban Drainage,ASCE, Reston, Va.
Lawrence, A. I., Marsalek, J. B., Ellis, J. B., and Urbonas, B. (1996).“Stormwater detention and BMPs.” J. Hydraul. Res., 34(6), 719–813.
Singh, V. P. (1992). Elementary hydrology, Prentice-Hall, Englewood Cliffs, N.J., 540.
South Carolina Department of Transportation (SCDOT). (2004). “ Rainfall intensity values utilized by South Carolina Dept. of Transportation.” ⟨http://www.dot.state.sc.us/doing/pdfs/rainfall_intensity_chart.pdf⟩ (Aug. 4, 2004).
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: Aug 30, 2004
Accepted: Sep 14, 2005
Published online: May 1, 2006
Published in print: May 2006
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.