Triaxial Deformation Behavior of Bituminous Mixes
Publication: Journal of Materials in Civil Engineering
Volume 22, Issue 2
Abstract
The triaxial compressive response of bituminous mixes with volume fractions of aggregate in the range 52 to 85% was investigated over a wide range stresses and strain rates. The types of loadings considered include triaxial monotonic constant stress and constant applied strain rate, as well as creep recovery, continuous cyclic, and stress pulse train loadings. The mixes with a “fully dense” aggregate skeleton were found to dilate under all loading conditions and the creep response of the mixes was dependent on both the deviatoric and hydrostatic stresses. By contrast, recovery was found to occur under zero applied deviatoric stresses with the recovery rate only dependent on the “recoverable strain” and independent of any superimposed hydrostatic stress. Continuous and pulse loading cyclic stress-controlled tests showed that the response of the mixes was governed by the mean applied deviatoric stress in the continuous cyclic tests while strain recovery was important in the pulse loading tests. A phenomenological constitutive model was proposed to fit the measured triaxial response of the bituminous mixes and shown to capture the measurements over all the triaxial stress states and loading time histories investigated here. Furthermore, the model was extended to capture the temperature dependence of the mixtures which is governed by the temperature dependence of the bitumen binder.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Support from the Nottingham Asphalt Research Consortium (NARC) is gratefully acknowledged. The writers would also like to thank Shell Bitumen U.K. for supply of the materials studied.
References
Abbas, A. R., Papagiannakis, A. T., and Masad, E. A. (2004). “Linear and nonlinear viscoelastic analysis of the microstructure of asphalt concretes.” J. Mater. Civ. Eng., 16(2), 133–139.
Brown, S. F., and Cooper, K. E. (1980). “A fundamental study of the stress-strain characteristics of a bituminous material.” Proc., Association of Asphalt Paving Technologists, Vol. 49, 476–498.
Brown, S. F., and Snaith, M. S. (1974). “The permanent deformation characteristics of a dense bitumen macadam subjected to repeated loading.” Proc., Association of asphalt Paving Technologists, Vol. 45, 224–252.
Chang, G. K., and Meegoda, N. J. (1993). “Simulation of the behaviour of asphalt concrete using discrete element method.” Proc, 2nd Int. Conf. on Discrete Element Methods, Massachusetts Institute of Technology, Cambridge, Mass., 437–448.
Cheung, C. Y. (1995). “Mechanical behaviour of bitumens and bituminous mixes.” Ph.D. thesis, Cambridge Univ., Engineering Dept.
Cheung, C. Y., and Cebon, D. (1997). “Experimental study of pure bitumens in tension, compression, and shear.” J. Rheol., 41(1), 45–73.
Cheung, C. Y., Cocks, A. C. F., and Cebon, D. (1999). “Isolated contact model of an idealized asphalt mix.” Int. J. Mech. Sci., 41, 767–792.
Collop, A. C., and Khanzada, S. (2001). “Permanent deformation in idealised ‘sand asphalt’ bituminous mixtures.” Road Mater. Pavement Des., 2(1), 7–28.
Collop, A. C., Scarpas, A., Kasbergen, C., and de Bondt, A. (2003). “Development and finite element implementation of stress-dependent elastoviscoplastic constitutive model with damage for asphalt.” Transportation Research Record. 1832, Transportation Research Record, Washington, D.C., 96–104.
Deshpande, V. S., and Cebon, D. (1999). “Steady-state constitutive relationship for idealised asphalt mixes.” Mech. Mater., 31, 271–287.
Deshpande, V. S., and Cebon, D. (2000). “Uniaxial experiments on idealised asphalt mixes.” J. Mater. Civ. Eng., 12(3), 262–271.
German, R. M. (1989). Particle packing characteristics, Metal Powder Industries Federation, Princeton, N.J.
Hills, J. F., and Heukelom, W. (1969). “The modulus and Poisson’s ratio of asphalt mixes.” J. Inst. Pet., 55(541), 27–35.
Huang, B., Mohammad, L., and Wathugala, G. (2002). “Development of a thermo-viscoplastic constitutive model for HMA mixtures.” Electron J. Assoc. Asph. Paving Technol., 71, 594–618.
Huang, B., Mohammad, L., and Wathugala, G. (2004). “Application of a temperature dependent viscoplastic hierarchical single surface model for asphalt mixtures.” J. Mater. Civ. Eng., 16(2), 147–154.
Huang, Y. H. (1967). “Stresses and displacements in viscoelastic layered systems under circular loaded areas.” Proc., 2nd Int. Conf. on the Structural Design of Asphalt Pavements, 225–244.
Lee, H., and Kim, Y. R. (1998). “Viscoelastic constitutive model for asphalt concrete under cyclic loading.” J. Eng. Mech., 124(1), 32–40.
Long, F. M. (2001). “Permanent deformation of asphalt concrete pavements: A nonlinear viscoelastic approach to mix analyses and design.” Ph.D. thesis, Univ. of California, Berkeley.
Lytton, R., Uzan, J., Fernando, E. G., Roque, R., Hiltunen, D. and Stoffels, S. M. (1993). “Development and validation of performance prediction models and specifications for asphalt binders and paving mixes.” Technical Rep. No. SHRP-A-357, Strategic Highway Research Program, National Research Council.
Murali Krishnan, J., and Rajagopal, K. R. (2004). “Thermodynamic framework for the constitutive modeling of asphalt concrete: Theory and applications.” J. Mater. Civ. Eng., 16(2), 155–166.
Murali Krishnan, J., and Rao, L. C. (2000). “Air void reduction of asphalt concrete using mixture theory.” Int. J. Eng. Sci., 38, 1331–1354.
Nijboer, L. J. (1948). Plasticity as a factor in the design of dense bituminous road carpets, Elsevier Science, New York.
Ossa, E. A. (2004). “Deformation behaviour of bitumen and bituminous mixes.” Ph.D. thesis, Cambridge Univ., Engineering Dept.
Ossa, E. A., Deshpande, V. S., and Cebon, D. (2004a). “Triaxial deformation behaviour of bituminous mixes.” Technical Rep. CUED/C-MICROMECH/TR.96.
Ossa, E. A., Deshpande, V. S., and Cebon, D. (2004b). “Uniaxial monotonic and cyclic behaviour of bituminous mixes.” Technical Rep. CUED/C-MICROMECH/TR.95.
Ossa, E. A., Deshpande, V. S., and Cebon, D. (2005). “Phenomenological model for the monotonic and cyclic behaviour of pure bitumen.” J. Mater. Civ. Eng., 17(2), 188–197.
Ramsamooj, D. V., Ramadan, J., and Lin, G. S. (1998). “Model prediction of rutting in asphalt concrete.” J. Transp. Eng., 124(5), 448–446.
Schapery, R. A. (1984). “Correspondence principles and a generalised J integral for large deformation and fracture analysis of viscoelastic media.” Int. J. Fract., 25, 195–223.
Von Quintus, H. L., Scherocman, J. A., Hughes, C., and Kennedy, T. (1991). “Asphalt aggregate mixture analysis system.” Technical NCHRP Rep. No. 338, Transportation Research Board, Washington, D.C.
Whiteoak, D. 1990. The Shell bitumen handbook, Shell Bitumen, U.K.
Zhao, Y., and Kim, Y. R. (2003). “Time-temperature superposition for asphalt mixtures with growing damage and permanent deformation in compression.” Transportation Research Record. 1832, Transportation Research Board, Washington, D.C., 161–172.
Zhu, H., and Nodes, J. E. (2000). “Contact based analysis of asphalt pavement with the effect of aggregate angularity.” Mech. Mater., 32, 193–202.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Aug 11, 2006
Accepted: May 7, 2009
Published online: Jan 15, 2010
Published in print: Feb 2010
Notes
Note. Associate Editor: Gordon D. Airey
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.