Inspection and Repair of Ceramic Tiling within a Building Management System
Publication: Journal of Materials in Civil Engineering
Volume 22, Issue 1
Abstract
This paper is based on an expert system for inspecting adhesive ceramic wall or floor tiling (ACT), which includes all the anomalies that may occur in ACT as well as their most probable causes. To support diagnosis, a classification of in situ inspection and testing methods is presented as well as the files that characterize them. Diagnosis tools are complemented with a correlation matrix anomaly/test method. The repair of anomalies and the elimination of their causes are supported by a classification of the repair techniques, for each one of which a characterization file is presented and by a correlation matrix anomaly/repair technique. The ACT inspection system was validated through a series of standard inspections of 155 ACT cases, also described here. Data concerning inspection, diagnosis, and repair of each anomaly type were condensed into individual anomaly files. The expert system proposed is an essential tool for the implementation of management systems for buildings, paving the way for more objective periodical inspections and for a standardization of their procedures.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers wish to express their gratitude to Fátima Leitão and Marta Porta Nova for their contribution to the inspections to validate the system proposed. The writers also gratefully acknowledge the support of the ICIST Research Institute, IST, Technical University of Lisbon, and of the Foundation for Science and Technology (FCT).
References
Bowman, R. (2007). “Coefficient of restitution as an indication of impact resistance.” CSIRO Division of Building, Construction and Engineering, Australia, ⟨http://www.infotile.com/services/techpapers/32coraus.shtml⟩ (March 31, 2007).
Branco, F. A., and de Brito, J. (2004). Handbook of concrete bridge management, ASCE, Reston, Va.
Campante, E. (2001). “Methodology for diagnosis, repair and prevention of facades ceramic tiling pathology.” Ph.D. thesis, Escola Politécnica da USP, São Paulo, Brazil (in Portuguese).
Dow, C., and Glasser, F. P. (2003). “Calcium carbonate efflorescence on Portland cement and building materials.” Cem. Concr. Res., 33(1), 147–154.
Flores, I. (2002). “Maintenance strategies: envelope elements of current buildings.” MS thesis, Instituto Superior Técnico, Lisbon, Portugal (in Portuguese).
Flores-Colen, I., de Brito, J., and Freitas, V. (2006). “Expedite in situ test techniques for predictive maintenance of rendered façades.” Journal of Building Appraisal, 2(2), 142–156.
Flores-Colen, I., de Brito, J., and Freitas, V. (2008). “Stains in facades’ rendering—Diagnosis and maintenance techniques’ classification.” Constr. Build. Mater., 22(3), 211–221.
Garcia, J., and de Brito, J. (2008). “Inspection and diagnosis of epoxy resin industrial floor coatings.” J. Mater. Civ. Eng., 20(2), 128–136.
Gaspar, P. (2002). “Methodology for service life prediction of external cementitious renders.” MS thesis, Instituto Superior Técnico, Lisbon, Portugal (in Portuguese).
Gaspar, P., and de Brito, J. (2005). “Mapping defect sensitivity in external mortar renders.” Constr. Build. Mater., 19(8), 571–578.
Goldberg, R. (1998). Direct adhered ceramic tile, stone and thin brick facades manual, Laticrete International, Inc., Cincinnati.
Gonçalves, C. (2004). “Non-structural anomalies in current buildings: Development of an inspection, registration and classification support system.” MS thesis, Univ. of Coimbra, Coimbra, Portugal.
Li, Z., Yao, W., Lee, S., Lee, C., and Yang, Z. (2000). “Application of infrared thermography technique in building finish evaluation.” J. Nondestruct. Eval., 19(1), 11–19.
Lo, Y. (2002). “Delamination of external wall finishes of housing.” Proc., 30th IAHS World Congress on Housing-Housing Construction—An Interdisciplinary Task, Vol. 3, Coimbra, Portugal, 1571–1576.
Sá, A. (2005). “Durability of cement adhesives in facades.” MS thesis, Univ. of Porto, Porto, Portugal (in Portuguese).
Silvestre, J. D. (2005). “Support system for inspection and diagnosis of defects in adherent ceramic tiling.” MS thesis, Instituto Superior Técnico, Lisbon, Portugal (in Portuguese).
Silvestre, J. D., and de Brito, J. (2005). “Development of a supporting system for inspection and diagnosis of ceramic wall or floor tiling laid on mortar or adhesive.” Proc., Congress CIB W102–2005: Meeting on Information and Knowledge Management in Building, CIB, Instituto Superior Técnico, Lisbon, Portugal, 269–278.
Silvestre, J. D., and de Brito, J. (2007). “Statistical analysis of defects of tiles’ joints.” Mater. Constr., 57(285), 85–92 (in Spanish).
Silvestre, J. D., and de Brito, J. (2009). “Ceramic tiling inspection system.” Constr. Build. Mater., 23(2), 653–668.
Tan, K. S., Chan, K. C., Wong, B. S., and Guan, L. W. (1996). “Ultrasonic evaluation of cement adhesion in wall tiles.” Cem. Concr. Compos., 18(2), 119–124.
Walter, A., de Brito, J., and Grandão Lopes, J. (2005). “Current flat roof bituminous membranes waterproofing systems—Inspection, diagnosis and pathology classification.” Constr. Build. Mater., 19(3), 233–242.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Apr 10, 2007
Accepted: Mar 11, 2009
Published online: Dec 15, 2009
Published in print: Jan 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.