Evaluation of Pyrolisis LDPE Modified Asphalt Paving Materials
Publication: Journal of Materials in Civil Engineering
Volume 21, Issue 10
Abstract
The main objective of this research is to investigate the potential use of pyrolisis low density polyethylene (LDPE) as a modifier in hot mix asphalt paving mixtures. Five different blends including conventional mix were subjected to binder testing such as rheological tests, as well as to some other tests related to the homogeneity of the system. Optimum asphalt content was obtained by Marshall method and used in all the modified mixes. The engineering properties, including Marshall stability, indirect tensile strength, and compressive strength were determined. Research results indicate that modified binders showed higher softening point, keeping the values of ductility at minimum range of specification of , and caused a reduction in percentage loss of weight due to heat and air (i.e., increase durability of original asphalt). The results indicated that the inclusion of pyrolisis LDPE with asphalt concrete mixtures gave a quite satisfactory result in terms of stability and other Marshall properties, increase in indirect tensile, and compressive strength.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers extend their appreciation to the Bituminous Laboratory, College of Engineering, Mosul University, for technical assistance and the various companies that provided materials used in this study. Special thanks go to the Dean of Engineering College, Professor M. T. Al-Layla, Chairman of the Civil Engineering Department, Professor B. J. Al-Selifany, Mr. A. A Osamma, and M. Ibrahim without whom this study would not have been successful.
References
Aksoy, A., Samiloglu, K., Tayfur, S., and Ozen, H. (2005). “Effects of various additives on the moisture damage sensitivity of asphalt mixtures.” Constr. Build. Mater., 19, 11–18.
Al-Dubabe, I. A., Al-Abdul Wahhab, H. I., Asi, I. M., and Mohammed, F. A. (1998). “Polymer modification of Arab asphalt.” J. Mater. Civ. Eng., 10(3), 161–167.
Al-Ghannam, K. A. A. (1996). “Study on the rheological properties of asphalt, effect of modification process on the homogeneity of the system.” Ph.D. thesis, Univ. of Mosul, Mosul, Iraq.
Al-Hadidy, A. I. (2001). “Influence of polyethylene and sulfur wastes on characteristics of asphalt paving materials.” MS thesis, Al-Mustansiriyah Univ., Baghdad, Iraq.
Al-Hadidy, A. I. (2006). “Evaluation of pyrolisis polypropylene modified asphalt paving materials.” J. Al-Rafidian Eng., Mosul-Iraq, 14(2), 36–50.
ASTM. (2005). “Standard specification.” ASTM 04-03, West Conshohoken, Pa.
Brown, E. R., and Cooley, L. A. (1999). “Designing stone matrix asphalt mixtures for rut-resistant pavements.” Rep. No. 425, Washington, D.C.
Brown, E. R., Haddock, J. E., Mallick, R. B., and Lynn, T. A. (1997). “Development of a mixture design procedure for stone matrix asphalt (SMA).” NCAT Report No. 97–3, National Center for Asphalt Technology, Auburn, Ala.
Cawsey, D. C., and Raymond-Williams, R. K. (1990). “Stripping of macadams performance tests with different aggregates.” J. Highways and Transportation, July, 16–21.
Chiu, C.-T., and Lu, L.-C. (2007). “A laboratory study on stone matrix asphalt using ground tire rubber.” Constr. Build. Mater., 21, 1027–1033.
Cliff, N. (1998). Asphalt surfacing: A guide to asphalt surfacing and treatments used for the surface course of road pavements, E & FN Spon, An Imprint of Routledge, London, and New York, 74–76.
Cooly, L. A., and Brown, E. R. (2003). “Potential of using stone matrix asphalt (SMA) for thin overlays.” Rep. No. 03–01, National Center for Asphalt Technology, Auburn Univ., Ala.
Crawford, R. J. (1987). Plastic engineering, 2nd Ed., Wiley, New York, 22.
Denning, J. H., and Garswell, J. (1981). “Improvement rolled asphalt surfacing by the addition of organic polymers.” Rep. No. 989, Transport and Road Research Laboratory, Crowthome, Berkshire, U.K.
Fredw, B., Jr. (1971). Textbook of polymer science, 2nd Ed., Wiley, New York.
Highway Technet. (1998). “Stone upon stone put to the test.” Federal Highway Administration, U.S. Department of Transportation Technology Application.
Ibrahim, M. A. (2006). “Laboratory comparison study for the use of stone matrix asphalt in hot weather climates.” Constr. Build. Mater., 20, 982–989.
Jenkins, A. D. (1972). “Polymeric science.” Materials science handbook, Vol. 1, North-Holland, Amsterdam, London.
Lobna, A. S. (1992). “Studies of the changing of rheological properties of asphalt.” MS thesis, Univ. of Mosul, Mosul, Iraq.
Lottman, R. (1978). “Pressure moisture-induced damage to asphaltic concrete.” Rep. No. 192, National Cooperative Highway Research Program, Transportation Research Board, Washington, D.C.
Lottman, R., and Dennis, L. G. (1970). “Pressure-induced stripping in asphaltic concrete.” J. Transportation Research Board, 340, 13–25.
McGennis, R. B. Machemehl, R. B., and Kennedy, T. W. (1981). “Stripping and moisture damage in asphalt mixtures.” TRB Research Rep. No. 253–1, Center for Transportation Research, Bureau of Engineering Research, Univ. of Texas, Austin, Tex.
Milkowski, W. (1985). “Catalytic modification of road asphalt by polyethylene.” J. Transp. Eng., 111(1), 54–72.
Mohammed, A. A. (1993). Chemistry of polymers, Univ. of Mosul, Mosul, Iraq.
Putman, B. J., and Amirkhanian, S. N. (2004). “Utilization of waste fibers in stone matrix asphalt mixtures.” Resour. Conserv. Recycl., 42, 265–274.
State Cooperation of Road and Bridges (SCRB). (1999). “Hot mix asphalt concrete pavements.” Section R9, Iraqi standard specification, Baghdad-Iraq.
Swaminathan, C. G., and Nair, K. P. (1958). “A laboratory investigation on the stripping of bituminous binder from a coated road stone in the pressure of water.” J. Indian Road Congress, 22(3).
Yang, H. H. (1993). Pavement analysis and design, Prentice-Hall, Englewood Cliffs, N.J.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Apr 20, 2007
Accepted: Feb 9, 2009
Published online: Sep 15, 2009
Published in print: Oct 2009
Notes
Note. Associate Editor: Shin-Che Huang
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.