Numerical Modeling of the Long-Term Behavior of Passive Fire Protection Mortars Applied on Concrete Tunnels
Publication: Journal of Materials in Civil Engineering
Volume 19, Issue 6
Abstract
Experiences show that the design of overlay mortars is a complicated matter as far as long-term durability and dimensional stability are concerned. In many cases, applied mortars crack or delaminate a few years after application. The same is true for passive fire protection mortars (PFP mortars). The mortar must remain crack free and must not delaminate during the planned service life, that means the fire protection requirements must be combined with the durability requirements. In this paper, an approach based on a numerical model is used to forecast the long-term behavior of PFP mortars. By means of this model, the time-dependent humidity, temperature, stress, and strain distributions, as well as the crack formation can be calculated in a realistic way. The minimal adhesive strength between overlay and substrate which is necessary to prevent delamination during the planned service life has been calculated. Material properties and climatic boundary conditions have been taken into account. The results allow the tailored optimization of PFP mortars.
Get full access to this article
View all available purchase options and get full access to this article.
References
Argyris, J. H., Warnke, E. P., and Willam, K. J. (1977). “Berechnungen von temperatur- und feuchtefeldern in massivbauten nach der methode der finiten elemente.” Deutscher Ausschuss für Stahlbeton, Heft, 278.
Bazant, Z. P., and Najjar, L. J. (1972). “Nonlinear water diffusion in nonsaturated concrete.” Mater. Constr. (Paris), 5(25), 3–20.
Bazant, Z. P., and Oh, B. H. (1983). “Crack band theory for fracture of concrete.” Mater. Constr. (Paris), 16, 155–172.
Cornelisson, H. A. W. (1984). “Fatigue failure of concrete in tension.” Heron, J. Witteveen, ed., Stevin-Laboratory and Institute TNO, Delft, The Netherlands, 29(4).
Femmasse. (2004). “Finite element software FEMMASSE.” Module MLS, femmasse b.v., Geldermalsen, The Netherlands.
Hillerborg, A., Modéer, M., and Petersson, P. E. (1976). “Analysis of crack formation and crack growth in concrete by means of fracture mechanics and finite elements.” Cem. Concr. Res., 6, 773–782.
Hsu, T. C. (1981). “Fatigue of plain concrete.” J. Am. Concr. Inst., 78(4), 292–305.
Martinola, G. (2000a). “Zementgebundene beschichtungen zum Schutz und zur instandsetzung von stahlbetonbauwerken.” Int. Zeitschrift für Bauinstandsetzen und Denkmalpflege, 6(3), 243–272.
Martinola, G. (2000b). “Rissbildung und ablösung zementgebundener beschichtungen auf beton.” Dissertation ETH Zürich, Dissertation ETH No. 13520 [Appeared also as Building Materials Rep., No. 12 (2001), Aedificatio Publishers, Freiburg].
Martinola, G., Sadouki, H., and Wittmann, F. H. (2001). “Numerical model for minimizing the risk of damage in a repair system.” J. Mater. Civ. Eng., 13(2), 121–129.
Roelfstra, P. E., Salet, A. M., and Kuiks, J. E. (1994). “Defining and application of stress-analysis-based temperature difference limits to prevent early-age cracking in concrete structures.” Proc., Int. Rilem Symp. No. 25: Thermal Cracking in Concrete at Early Age, Munich, 273–280.
Roelfstra, P. E., and Wittmann, F. H. (1986). “Numerical method to link strain softening with failure of concrete.” Fracture toughness and fracture energy of concrete, F. H. Wittmann, ed., Elsevier, Amsterdam, The Netherlands, 163–175.
Rots, J. G. (1988). “Computational modeling of concrete fracture.” Ph.D. thesis, Delft Univ. of Technology, The Netherlands.
Rüsch, H. (1960). “Researches toward a general flexural theory for structural concrete.” J. Am. Concr. Inst., 57, 1–28.
Schieß, P., Rucker, P., Wiegrink, K. H., and Hiller, E. (2003). “Temperaturspannungsentwicklung in jungem Beton—Modellierung und Berechnung auf der basis von versuchen.” Beton, 7–8, 355–359.
Wittmann, F. H. (1995). “Influence of drying induced damage on the hygral diffusion coefficient.” Proc., FraMCoS-2, F. H. Wittmann, ed., Aedificatio Publishers, Freiburg, 1519–1525.
Wittmann, F. H., and Martinola, G. (2003). “Decisive properties of durable cement-based coatings for reinforced concrete structures.” Int. J. Restoration Buildings Monuments, 9(3), 235–264.
Wittmann, X., Sadouki, H., and Wittmann, F. H. (1989). “Numerical evaluation of drying test data.” Trans., 10th Int. Conf. on Structural Mechanics in Reactor Technology, Q, 71–79.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Oct 10, 2005
Accepted: Sep 12, 2006
Published online: Jun 1, 2007
Published in print: Jun 2007
Notes
Note. Associate Editor: Kiang Hwee Tan
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.