Physical and Chemical Behavior of Four Cement-Treated Aggregates
Publication: Journal of Materials in Civil Engineering
Volume 19, Issue 10
Abstract
Cement-treated aggregate (CTA) is commonly used to provide a stable base for pavements that are placed over weak soil subgrades. Because CTA reduces the thickness of the aggregate required to provide a durable base by approximately one-half, using it as a bearing layer for pavement can limit the quantity of unsuitable soil that must be excavated and removed, and can reduce the erodability of the stabilized soils. However, the field performance of CTA is variable, even when prepared according to set standards. This laboratory-based investigation explored the effects of fines content, cement content, mineralogy, pH, and freeze/thaw cycling on the unconfined compressive strength of cement-treated aggregate. The mineralogy of the base aggregate was found to make a significant difference in the strength of the CTA, with strength increasing in the following order: mica, limestone, and diabase. The granite aggregate yielded variable results, but the strengths were generally on the order of those determined for the diabase aggregate. The pH of the samples also correlated well, with the measured strengths increasing as the pH increased. As was anticipated, increasing the cement content increased the measured unconfined compressive strength of cylinders that were not subjected to freeze/thaw cycling. The same basic trend was observed in cylinders that were subjected to freeze/thaw cycling; however, the increase was less pronounced in the cylinders that were subjected to physical abrasion during thaw cycles. The fines content did not significantly influence the unconfined compressive strength of the cylinders that were not subjected to freeze/thaw cycling; however, the fines content appeared to confer a protective effect to the durability of the cylinders that were subjected to freeze/thaw. For the freeze/thaw test conditions (with and without physical abrasion), the unconfined compressive strength increased as the fines content was increased.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers thank Arthur Wagner, Bill Ordel, Michael Burton, and Marshall Davis for their assistance with the laboratory portion of this investigation.
References
Chew, S. H., Kamruzzaman, A. H. M., and Lee, F. H. (2004). “Physicochemical and engineering behavior of cement treated clays.” J. Geotech. Geoenviron. Eng., 130(7), 696–706.
Hernandez-Martinez, F. G., and Al-Tabbaa, A. (2004). Laboratory strength correlations for cement-treated peat, ASCE, Reston, Va., 1403–1411.
Lee, F.-H., Lee, Y., Chew, S.-H., and Yong, K.-Y. (2005). “Strength and modulus of marine clay–cement mixes.” J. Geotech. Geoenviron. Eng., 131(2), 178–186.
Lim, S., and Zollinger, D. G. (2003). “Estimation of the compressive strength and modulus of elasticity of cement-treated aggregate base materials.” Transportation Research Record. 1837, Transportation Research Board, Washington, D.C., 30.
Majumder, B. K., Das, A., and Pandey, B. B. (1999). “Cement-treated marginal aggregates for roads.” J. Mater. Civ. Eng., 11(3), 257–265.
Mohammad, L. N., Raghavandra, A., and Huang, B. (2000). “Laboratory performance evaluation of cement-stabilized soil base mixtures.” Transportation Research Record. 1721, Transportation Research Board, Washington, D.C., 19.
Puppala, A. J., Griffin, J. A., Hoyos, L. R., and Chomtid, S. (2004). “Studies on sulfate-resistant cement stabilization methods to address sulfate-induced soil heave.” J. Geotech. Geoenviron. Eng., 130(4), 391–402.
Scullion, T., and Harris, P. (1998). “Forensic evaluation of three failed cement-treated base pavements.” Transportation Research Record. 1611, Transportation Research Board, Washington, D.C., 10.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Jan 11, 2006
Accepted: Jun 9, 2006
Published online: Oct 1, 2007
Published in print: Oct 2007
Notes
Note. Associate Editor: Manoochehr Zoghi
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.