Volume Change Behavior of Fly Ash-Stabilized Clays
Publication: Journal of Materials in Civil Engineering
Volume 19, Issue 1
Abstract
This paper presents, by way of comparison, the effect of fly ash on the volume change of two different types of clay, one a highly plastic expansive clay and the other a nonexpansive clay, also of high plasticity. Expansive clays swell on absorbing water and shrink on drying. Nonexpansive clays undergo large compression at high water contents. The effect of fly ash content on free swell index, swell potential, and swelling pressure of expansive clays was studied. Compression index and secondary consolidation characteristics of both expansive and nonexpansive clays were also determined. Swell potential and swelling pressure, when determined at constant dry unit weight of the sample (mixture), decreased by nearly 50% and, when determined at constant weight of clay, increased by nearly 60% at 20% fly ash content. Compression index and coefficient of secondary consolidation of both the clays decreased by 40% at 20% fly ash content.
Get full access to this article
View all available purchase options and get full access to this article.
References
Acosta, H., Edil, T., and Benson, C. (2003). “Soil stabilization and drying using fly ash.” Geo Engineering Rep. No. 03-03, Dept. of Civil and Environmental Engineering, Univ. of Wisconsin-Madison, Madison, Wis.
Alonso, E. E., Gens, A., and Hight, D. W. (1987). “Special problem soils: General report.” Proc., 9th European Conf. on Soil Mechanics, Vol. 3, Dublin, Ireland, 1087–1146.
Aubeny, C. P., and Lytton, R. L. (2004). “Shallow slides in compacted high plasticity clay slopes.” J. Geotech. Geoenviron. Eng., 130(7), 717–727.
Briaud, J. L., and Zhang, X. (2003). “Shrink test-water content method for shrink and swell predictions.” J. Geotech. Geoenviron. Eng., 129(7), 590–600.
Broms, B., and Boman, P. (1977). “Stabilization of soil with lime–soil columns.” Design handbook, 2nd Ed., Royal Institute of Technology, Stockholm, Sweden.
Chandra, S. (1997). Waste materials used in concrete manufacturing, Noyes, Westwood, N.J.
Chen, F. H. (1988). Foundations on expansive soils, 2nd Ed., Elsevier Scientific, Amsterdam, The Netherlands.
Cokca, E. (1997). “Frost susceptibility properties of soma-B fly ash.” J. Energy Eng., 123(1), 1–10.
Cokca, E. (2001). “Use of class C fly ash for the stabilization of an expansive soil.” J. Geotech. Geoenviron. Eng., 127(7), 568–573.
Desai, I. D., and Oza, B. N. (1997). “Influence of anhydrous calcium chloride on shear strength of expansive soils.” Proc., 1st Int. Symp. on Expansive Soils, HBTI, Kanpur, India.
Dobrowolski, J. A. (1998). Concrete construction handbook, 4th Ed., McGraw-Hill, New York.
Edil, T. B., Berthoueux, P. M., and Vesperman, K. D. (1987). “Fly ash as a potential waste liner.” Proc., Geotechnical Practice for Waste Disposal, R. D. Woods, ed., ASCE, New York, 447–461.
Fredlund, D. G., and Rahardjo, H. (1993). Soil mechanics for unsaturated soils, Wiley, New York.
Gallipoli, D., Gens, A., Sharma, R., and Vaunat, J. (2003). “An elasto-plastic model for unsaturated soil incorporating the effects of suction and degree of saturation on mechanical behavior.” Geotechnique, 53(1), 123–135.
Gens, A., and Alonso, E. E. (1992). “A framework for the behavior of unsaturated expansive clays.” Can. Geotech. J., 29, 1013–1032.
Gourley, C. S., Newill, D., and Shreiner, H. D. (1993). “Expansive soils: TRL’s research strategy.” Proc., 1st Int. Symp. on Engineering Characteristics of Arid Soils, London.
Holtz, W. G., and Gibbs, H. J. (1956). “Engineering properties of expansive clays.” Trans. Am. Soc. Civ. Eng., 121, 641–677.
Hoyos, L. R., Puppala, A. J., and Chainuwat, P. (2004). “Dynamic properties of chemically stabilized sulfate rich clay.” J. Geotech. Geoenviron. Eng., 130(2), 153–162.
Hunter, D. (1988). “Lime-induced heave in sulfate-bearing clay soils.” J. Geotech. Engrg., 114(2), 150–167.
Jennings, J. E. (1963). Discussion on “The heaving of buildings and associated economic consequences with particular reference to orange free state gold fields.” The Civil Engineers, S. A., Vol. 5, 122.
Joshi, R. C., Hettiaratchi, J. P. A., and Achari, G. (1994). “Properties of modified Alberta fly ash in relation to utilization in waste management applications.” Can. J. Civ. Eng., 21, 419–426.
Joshi, R. C., and Lohtia, R. P. (1997). Fly ash in concrete—Production, properties, and uses, Cordon and Research Science, Amsterdam, The Netherlands.
Kaniraj, S. R., and Havanagi, V. G. (2001). “Behavior of cement-stabilized fiber-reinforced fly ash–soil mixtures.” Infant Ment. Health J., 127(7), 574–584.
Kassif, G., Baker, R., and Ovadia, Y. (1973). “Swell pressure relationships at constant suction changes.” Proc., 3rd Int. Conf. on Expansive Soils, Haifa, Israel, 201–208.
Kumar, V. (1996). “Fly ash utilization: A mission mode approach.” Ash ponds and ash disposal systems, Narosa Publishing House, New Delhi, India.
Lee, C., Lou, I., Shieh, W., and Sheu, S. (2000). “Evaluation of the effectiveness of slag and fly ash in preventing expansion due to AAR in Taiwan.” Proc., 11th Int. Conf. on Alkali–Aggregate Reaction in Concrete, Centre de Recherche Interuniversitaire sur le Beton (CRIB), Québec, 703–712.
Lu, N., and Lykos, W. (2004). Unsaturated soil mechanics, Wiley, New York.
Lytton, R. (1994). “Prediction of movement in expansive clays.” Proc., Settlement, 94 Geotechnical Special Publication, No. 40, ASCE, New York, 1827–1845.
Malhotra, V. M., and Mehta, P. K. (1996). Pozzolanic and cementitious materials, Gordan and Breach, Amsterdam, The Netherlands.
McKeen, R. G. (1988). “Soil characterization using suction measurements.” Proc., 25th Paving and Transportation Conf., Univ. of New Mexico, Albuquerque, N.M.
Mesri, G., and Godlewski, P. M. (1977). “Time and stress compressibility interrelationship.” J. Geotech. Engrg. Div., 103, 5, 417–430.
Mitchell, J. K., and Dermatas, D. (1992). “Soil improvement: State of the art.” Proc., 10th Int. Conf. on Soil Mechanics and Foundation Engineering, Stockholm, Sweden, 57.
Nelson, D. J., and Miller, J. D. (1992). Expansive soils: Problems and practice in foundation and pavement engineering, Wiley, New York.
Nevels, J. B., Jr. (2001). “Longitudinal cracking of a bicycle trail due to drying shrinkage.” Geotechnical special publication, no. 115, ASCE, Reston, Va.
Petry, M. T., and Little, N. D. (1992). “Update on sulfate-induced heave in treated clays: problematic sulphate levels.” Transportation Research Record. 1362, Transportation Research Board, Washington D. C., 51–55.
Phani kumar, B. R. (2000). “Use of fly ash in treating problematic expansive soils.” Proc., Workshop on Environmental Geotechnology, Indian Geotechnical Society, Hyderabad Chapter, India, 36–39.
Phani kumar, B. R., and Sharma, R. S. (2004). “Effect of fly ash on engineering properties of expansive soils.” J. Geotech. Geoenviron. Eng., 130(7), 764–767.
Rao, A. S. (1984). “A study of swelling characteristics and behavior of expansive soils.” Ph.D. thesis, Kakatiya Univ., Warangal, India.
Raymond, G. P., and Wahls, H. E. (1976). “Estimating one-dimensional consolidation including secondary compression of clay loaded from overconsolidated to normally consolidated state.” Special Rep. No. 163, Transportation Research Board, Washington, D.C., 17–23.
Rees, S. W., and Thomas, H. R. (1993). “Simulating seasonal ground movement in unsaturated clay.” J. Geotech. Engrg., 119(7), 1127–1143.
Rollings, M. P., and Rollings, R. S. (1996). Geotechnical materials in construction, McGraw-Hill, New York.
Rollings, R. S., Burkes, J. P., and Rollings, M. P. (1999). “Sulfate attack on cement-stabilized sand.” J. Geotech. Geoenviron. Eng., 125(5), 364–372.
Sankar, N. B. (1989). “Use of lime-soil piles for in-situ stabilization of black cotton soils.” Proc., Indian Geotechnical Conf., Vol. 1, 149–153.
Seed, H. B., Woodward, R. J., and Lundgren, R. (1962). “Prediction of swelling potential for compacted clays.” J. Soil Mech. and Found. Div., 88(3), 53–87.
Sharma, R. S. (1996). “Geo-environmental aspects of fly ash utilization and disposal.” Ash ponds and ash disposal systems, Narosa Publishing House, New Delhi, India, 347–357.
Sharma, R. S. (1998). “Mechanical behavior of unsaturated highly expansive clays.” Ph.D. thesis, Univ. of Oxford, Oxford, U.K.
Sharma, R. S., and Wheeler, S. J. (2000). “Behavior of an unsaturated highly expansive clay during cycles of wetting and drying.” Proc., Asian Conf. Unsaturated Soils, Singapore, 721–726.
Shon, C. S., Sarkar, S. L., and Zollinger, D. G. (2004). “Testing the effectiveness of Class C and Class F fly ash in controlling expansion due to alkali-silica reaction using modified ASTM C 1260 test method.” J. Mater. Civ. Eng., 16(1), 20–27.
Sridharan, A., Pandian, N. S., and Rajasekhar, C. (1996). “Geotechnical characterization of pond ash.” Ash ponds and ash disposal systems, Narosa Publishing House, New Delhi, India, 97–110.
Van Olphen, H. (1977). An introduction to clay colloid chemistry, Wiley, New York.
Walsh, K., Houston, W. N., and Houston, S. L. (1993). “Evaluation of in-place wetting using soil suction measurements.” J. Geotech. Engrg., 119(5), 862–873.
Wheeler, S. J., Sharma, R. S., and Buisson, M. S. R. (2003). “Coupling of hydraulic hysteresis and stress-strain behavior in unsaturated soils.” Geotechnique, 53(1), 41–54.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Feb 11, 2005
Accepted: Jul 29, 2005
Published online: Jan 1, 2007
Published in print: Jan 2007
Notes
Note. Associate Editor: Hilary I. Inyang
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.