Micromechanical Modeling of Steady-State Deformation in Asphalt
Publication: Journal of Materials in Civil Engineering
Volume 16, Issue 2
Abstract
A micromechanical model for the steady-state deformation of idealized asphalt mixes is presented. Triaxial compression tests were conducted on idealized asphalt mixes and the volumetric and deviatoric strains were measured. The specimens were observed to dilate under compressive stresses and the deformation behavior was seen to be dependent on the hydrostatic as well as the deviatoric stresses. A simple model for the nonlinear viscous steady-state behavior of idealized mixes is presented based on a “shear box” analogy. Predictions of the model are seen to agree well with experimental measurements for a wide range of conditions. An upper bound is calculated for the steady-state deformation rates within a plane strain half space comprising the idealized asphalt mix subject to a uniform pressure over a finite contact strip. The deformation rate varies nonlinearly with the applied load and is strongly dependent on the hydrostatic stress. Further, the deformation rate is seen to be a maximum at a position about half a contact length below the surface of the half space. These findings are in general agreement with wheel tracking experiments on these idealized mixes.
Get full access to this article
View all available purchase options and get full access to this article.
References
Anon. (1989). “Bitumens for building and civil engineering. Part 1. Specification of bitumens for road purposes.” BS 3690, British Standards Institution, London.
Brown, S. F., Stock, A. F., and Pell, P. S.(1980). “The structural design of asphalt pavements by computer.” J. Inst. Highway Eng.,27(3), 2–10.
Cheung, C. Y., and Cebon, D.(1997). “Experimental study of pure bitumen in tension, compression and shear.” J. Rheol., 41(1), 45–73.
Cheung, C. Y., Cocks, A. C. F., and Cebon, D.(1999). “Isolated contact model for an idealized asphalt mix.” Int. J. Mech. Sci., 41, 767–792.
Collop, A. C., Cebon, D., and Hardy, M. S. A.(1995). “Viscoelastic approach to rutting in flexible pavements.” J. Transp. Eng., 121(1), 82–93.
Collop, A. C., and Khanzada, S.(2001). “Permanent deformation in idealized sand asphalt bituminous mixtures.” Int. J. Road Mater. Pavement Design, 2(1), 7–28.
Deshpande, V. S. (1997). “Steady-state deformation behavior of bituminous mixes.” PhD thesis, Univ. of Cambridge, Cambridge, U.K.
Deshpande, V. S., and Cebon, D.(1999b). “Models of particle reinforced nonlinear-viscous composite.” J. Eng. Mech., 125(3), 255–262.
Deshpande, V. S., and Cebon, D.(1999a). “Steady-state constitutive relationship for idealized asphalt mixes.” Mech. Mater., 31(4), 271–287.
Deshpande, V. S., and Cebon, D.(2000). “Uniaxial experiments on idealized asphalt mixes.” J. Mater. Civ. Eng., 12(3), 262–271.
Drucker, D. C.(1953). “Coulomb friction, plasticity and limit loads.” J. Appl. Mech., 53, 57–65.
Fröhlich, H., and Sack, R.(1946). “Theory of the rheological properties of dispersions.” Proc. R. Soc. London, Ser. A, 185, 415–430.
Hashin, Z.(1962). “The elastic moduli of heterogeneous materials.” J. Appl. Mech., 29, 143–150.
Hills, J. F.(1973). “The creep of asphalt mixes.” J. Inst. Pet., 59(570), 247–262.
Johnson, K. L. (1985). Contact mechanics, Cambridge Univ. Press, Cambridge, U.K.
Lubliner, J. (1990). Plasticity theory, Maxwell Macmillan International, New York.
Monismith, C. L., Sousa, J., and Lysme, J. (1988). “Modern pavement design technology including dynamic load conditions.” Proc., SAE Conf. on Vehicle/Pavement Interaction, SAE, Indianapolis.
Rothenburg, L., Bogobowicz, A., Haas, R., Jung, F. W., and Kennepohl, G. (1992). “Micromechanical modelling of asphalt concrete in connection with pavement rutting problems.” Proc., 7th Int. Conf. on the Structural Design of Asphalt Pavements, Univ. of Michigan, Road Research Laboratory, Ann Arbor, Mich. 476–498.
Suquet, P. M.(1993). “Overall potentials and extremal surfaces of power law or ideally plastic composites.” J. Mech. Phys. Solids, 41(6), 981–1002.
van der Poel, C.(1958). “On the rheology of concentrated suspensions.” Rheol. Acta, 1, 198–205.
Williams, M. L., Landel, R. F., and Ferry, J. D.(1955). “The temperature dependence of relaxation mechanisms in amorphous polymers and other glass-forming liquids.” J. Am. Chem. Soc., 77, 3701–3707.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: May 8, 2002
Accepted: Apr 29, 2003
Published online: Mar 15, 2004
Published in print: Apr 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.