Reuse of Incinerator Fly Ash in Soft Soil Stabilization
Publication: Journal of Materials in Civil Engineering
Volume 15, Issue 4
Abstract
One of the ways in which highly urbanized cities cope with increasing amounts of municipal solid waste (MSW) generated by the population is incineration. As land is a very precious commodity and landfills are fast dwindling in most highly urbanized cities, the disposal of the ash generated from MSW incineration poses increasingly difficult problems for the municipalities. A viable solution to the disposal problems would be the reuse of MSW ash for civil engineering applications. A research study of the properties of the incinerator fly ash derived from MSW incineration indicated that fly ash is a potential source of jet-grouting admixture for soil improvement. The fly ash exhibits a likelihood of pozzolanic reaction due to its chemical composition and physical characteristics. The use of fly ash as an admixture in the stabilization of a soft marine clay resulted in stabilized samples with an improved strength more than 75 times that of the untreated clay. Incorporation of fly ash also improved drainage property by at least one order of magnitude and reduced both the plasticity and compression indices by about 69 and 23%, respectively. Leachate investigation conducted on the fly ash–stabilized soils indicated that chromium was well-below the World Health Organization drinking water limit, while nickel and lead were in excess of the limits. The nickel and lead leachate concentrations diminished to below the acceptable drinking water limits over a period of about 130 and 110 days, respectively.
Get full access to this article
View all available purchase options and get full access to this article.
References
Abdul-Rashid, R., and Frantz, G.(1992). “MSW incinerator ash as aggregate in concrete and masonry.” J. Mater. Civ. Eng., 4(4), 353–368.
ASTM. (1998). “Standard test method for unconfined compressive strength of cohesive soil.” D 2166-91, Annual Book of ASTM Standards, 04.08, West Conshohocken, Pa.
Broms, B. B. (1987). “Stabilization of soft clay in South-east Asia.” Proc., Int. Geotechnical Seminar—Case Histories in Soft Clay, Nanyang Technological Institute, Singapore, 163–198.
British Standards Institute (BSI). (1975). “Method of test for soils for civil engineering.” BS1377, London.
Digioia Jr., A. M., Meyers, J. F., and Niece, J. E. (1977). “Design and construction of bituminous fly ash disposal sites.” Geotechnical practice for disposal of solid waste materials, ASCE, New York, 267–284.
Edil, T. B., Berthouex, P. M., and Vesperman, K. D. (1987). “Fly ash as a potential waste liner.” Proc., Geotechnical Practice for Waste Disposal, R. D. Woods, ed., ASCE, New York, 447–461.
Francis, C. W., and White, G. H.(1987). “Leaching of toxic metals from incinerator ashes.” J. Water Pollut. Control Fed., 59(11), 979–986.
Goh, A. T. C., and Tay, J. H.(1993). “Municipal solid-waste incinerator fly ash for geotechnical applications.” J. Geotech. Eng., 119(5), 811–825.
Gray, D. H., and Lin, Y. K.(1972). “Engineering properties of compacted fly ash.” J. Soil Mech. Found. Div., Am. Soc. Civ. Eng., 98(4), 361–380.
Harmernik, J. D., and Frantz, G. C. (1991). “Strength of concrete containing municipal solid waste fly ash.” ACI Mater. J., 88-56.
James, G. M. (1980). “Physiochemical investigation of shale slaking.” PhD thesis, Univ. of California, Berkeley, Calif.
Kiser, J. V. L. (1997). “The state-of-the-art in municipal solid waste combustion in the United States.” Municipal solid wastes—Problemsand solutions, R. E. Landreth and P. A. Rebers, eds., CRC Press, Boca Raton, Fla., 135–145.
Orlov, D. S. (1992). Soil chemistry, Balkema, Rotterdam, The Netherlands.
Parker, D. G., Thornton, S. I., and Cheng, C. W. (1977). “Permeability of fly ash stabilized soils.” Geotechnical Practice for Disposal of Solid Waste Materials, Tash Committee, ASCE, New York, 63–70.
Poran, C. J., and Ahtchi-Ali, F.(1989). “Properties of solid waste incinerator fly ash.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 115(8), 1118–1133.
Raymond, S.(1961). “Pulverised fly ash as embankment material.” Proc., Inst. Civ. Eng., London, 19, 515–536.
Schoenberger, R. J., and Fungaroli, A. A.(1971). “Incinerator-residue-fill site investigation.” J. Soil Mech. Found. Div., Am. Soc. Civ. Eng., 97(10), 1431–1443.
Sherwood, P. T., and Ryley, M. D. (1986). “The use of pulverised fuel ash in road construction.” RRL Rep. No. 49, Ministry of Transport, Road Research Laboratory, London.
Tan, L. C., Choa, V., and Tay, J. H.(1997). “The influence of pH on mobility of heavy metals from municipal solid waste incinerator fly ash.” Environ. Monit. Assess., 44, 275–284.
Tay, J. H., and Cheong, H. K.(1991). “Use of ash derived from refuse incineration as a partial replacement of cement.” Cem. Concr. Compos., 13, 171–175.
Tay, J. H., Tam, C. T., and Chin, K. K.(1982). “Utilization of incinerator residue in concrete.” Conserv. Recycl., 5(2/3), 107–112.
Tyrrell, M. E., and Field, I. L. (1970). “Structural products made from high-silica fractions of municipal incinerator residues.” Proc., 2nd Waste Utilization Symp., Chicago, 356–360.
Walter, C. E.(1976). “Practical refuse recycling.” J. Environ. Eng. Div. (Am. Soc. Civ. Eng.), 102(1), 139–148.
World Health Organization (WHO). (1993). Revision of the WHO guidelines for drinking water quality, Geneva.
Information & Authors
Information
Published In
Journal of Materials in Civil Engineering
Volume 15 • Issue 4 • August 2003
Pages: 335 - 343
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Oct 2, 2001
Accepted: Jul 17, 2002
Published online: Jul 15, 2003
Published in print: Aug 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.