Optimization of Concrete Drying Temperature for Monomer Impregnation
Publication: Journal of Materials in Civil Engineering
Volume 6, Issue 1
Abstract
The optimum drying temperature of concrete prior to monomer impregnation was investigated. Mortar cubes were cast, dried at different temperatures between room temperature and 316°C (600°F), and impregnated with monomer and polymerized in situ. The cubes were then vacuum‐saturated and their resistivities were measured. The cubes were cut and dried to 104°C (220°F), and the influence of drying temperature on the degree of impregnation was evaluated using a mercury porosimeter and a scanning electron microscope‐energy dispersive spectroscope. Companion cubes were subjected to ponding‐drying cycles in a sodium chloride solution, and the ingress of chloride was determined from powdered samples. Results were used to optimize the drying temperature of concrete for monomer impregnation. The results demonstrated that monomer impregnation of concrete to a desired depth can be achieved at a lower temperature than previously believed.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Browne, R. D. (1980). “Mechanisms of corrosion of steel in concrete in relation to design, inspection and repair of offshore and coastal structures.” Performance of concrete in a marine environment (SP‐65), B. M. Malhorta, ed., Am. Concr. Inst., Detroit, Mich., 169–204.
2.
“Cement; lime; gypsum.” (1989). ASTM C‐109‐88 (Annual book of ASTM standards, section 4), ASTM, Philadelphia, Pa., Oct.
3.
Dias, W. P. S., Khoury, G. A., and Sullivan, P. J. E. (1990). “Shrinkage of hardened cement paste at temperatures up to 670 C (1238 F).” ACI Mater. J., 87(3), 204–209.
4.
“Durability of concrete bridge decks.” (1969). Report No. 5, Portland Cement Assoc., Chicago, Ill., 46.
5.
“Durability of concrete bridge decks.” (1970). Final Report, Portland Cement Assoc., Chicago, Ill., 35.
6.
Dutta, T. (1991). “Evaluation of the effectiveness of deep polymer impregnation as a corrosion abatement technique for overlaid bridge decks,” MS thesis, Virginia Polytechnic Institute and State University, Blacksburg, Va.
7.
Lea, F. C., and Stradling, R. E. (1922). “The resistance to fire of concrete and reinforced concrete.” Engrg., 114(2959), 341–344.
8.
Manning, D. G. (1985). “Detecting defects and deterioration in highway structures.” Nat. Cooperative Highway Res. Program, Synthesis of Highway Practice 118, Transp. Res. Board, Nat. Res. Council, Washington, D.C.
9.
Manson, J. A., Chen, W. F., Vanderhoff, J. W., Mehta, H. C., Cady, P. D., Kline, D. E., and Blankenhom, P. R. (1978). “Use of polymers in highway concrete.” Nat. Cooperative Highway Res. Program 190, Transp. Res. Board, Nat. Res. Council, Washington, D.C.
10.
Parrott, L. J., Hansen, W., and Berger, R. L. (1980). “Effect of first drying upon the pore structure of hydrated alite paste.” Cement and Concr. Res., 10(5), 647–655.
11.
Patel, R. G., Parrot, L. J., Martin, J. A., and Killoh, D. C. (1985). “Gradients of microstructure and diffusion properties in cement paste caused by drying.” Cement and Concr. Res., 15(2), 343–356.
12.
Tremper, B., Beaton, J. L., and Stratfull, R. F. (1985). “Causes and repair of deterioration to a California bridge due to corrosion of reinforcing steel in a marine environment, Part II: Fundamental factors causing corrosion.” Highway Res. Bulletin 182, Transp. Res. Board, Nat. Res. Council, Washington, D.C., 18–41.
13.
Vassie, P. R. (1980). “A survey of site tests for the assessment of corrosion in reinforced concrete.” LR 953, Transp. and Road Res. Lab., Crowthorne, Berkshire, England.
14.
Weyers, R. E., and Cady, P. D. (1984a). “Application: Deep grooving—A method for impregnating concrete bridge decks.” Transp. Res. Record, 962, 19–21.
15.
Weyers, R. E., and Cady, P. D. (1984b). “Development: Deep grooving—A method for impregnating concrete bridge decks.” Transp. Res. Record, 962, 14–18.
Information & Authors
Information
Published In
Copyright
Copyright © 1994 American Society of Civil Engineers.
History
Received: May 3, 1993
Published online: Feb 1, 1994
Published in print: Feb 1994
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.