Corrosion Cracking in Relation to Bar Diameter, Cover, and Concrete Quality
Publication: Journal of Materials in Civil Engineering
Volume 4, Issue 4
Abstract
Concrete cover, concrete quality, and bar size have a significant effect on corrosion initiation and corrosion cracking. This paper attempts to quantify the effect of these three parameters in providing corrosion protection to reinforcing steel. It is found that the cover‐to‐bar‐diameter (c/d) ratio is a more definitive protection parameter against corrosion cracking than either cover or bar diameter separately. In view of the importance of c/d ratio, clear cover specifications without consideration of the bar size leads to inadequate and misleading design for corrosion protection, especially in concrete where internal chlorides are present in concrete from the time of manufacturing, making the corrosion propagation time prior to cracking an important phase in the service life of structures. A concept of corrosion cracking resistance factor, or c/dw incorporating cover, bar diameter, and concrete quality either in terms of strength or water‐cement ratio (w) has been developed to quantify the relative corrosion protection provided by a particular set of detailing and strength parameters.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Al‐Sulaimani, G. J., Kaleemullah, M., Basunbul, I. A., and Rasheeduzzafar,. (1990). “Influence of corrosion and cracking on bond behavior and strength of reinforced concrete members.” ACI Struct. J., 87(2), 220–231.
2.
Atimtay, E., and Ferguson, P. M. (1974). “Early chloride corrosion of reinforced concrete—a test report.” Mater. Perform., 13(12), 18–21.
3.
Beeby, A. W. (1983). “Cracking, cover, and corrosion of reinforcement.” Concr. Int., 5(2.), 35–40.
4.
Browne, R. D. (1980). “Mechanisms of corrosion of steel in concrete in relation to design, inspection, and repair of offshore and coastal structures.” Performance of concrete in marine environment, ACISP‐65, American Concrete Institute, Detroit, Mich., 169–204.
5.
Crumpton, C. F., Pattengill, M. G., and Badgley, W. A. (1969). Bridge deck deterioration study‐part 8. State highway committee of Kansas, Topeka, Kans.
6.
(Durability of concrete bridge decks—a cooperative study.” (1965–1969). Reports 1‐5, Portland Cement Association, Skokie, Ill.
7.
Goto, S., and Roy, D. M. (1981). “The effect of w/c ratio and curing temperature on the permeability of hardened cement paste.” Cem. Concr. Res., 11(4), 575–580.
8.
Mehta, P. K., and Manmohan, D. (1980). “Pore size distribution and permeability of hardened cement paste.” Proc. 7th Int. Congress on Chemistry of Cement, III, 1–6.
9.
Powers, T. C., Copeland, L. E., Hayes, J. C., and Mann, H. M. (1954). “Permeability of Portland cement paste.” J. Amer. Concrete Inst., Proc., 51, 285–298.
10.
Rasheeduzzafar, and Dakhil, F. H. (1980). “Field studies on the durability of concrete construction in a high chloride‐sulphate environment.” Int. J. Housing Sci., 4(3), 203–232.
11.
Rasheeduzzafar, Dakhil, F. H., and Al‐Gahtani, A. S. (1982). “The deterioration of concrete structures in the environment of the Middle East.” Arabian J. Sci. and Engrg., 7(3), 191–209.
12.
Rasheeduzzafar, Dakhil, F. H., and Al‐Gahtani, A. S. (1984). “The deterioration of concrete structures in the environment of the Middle East.” ACIJ. Proc., 81(1), 13–20.
13.
Rasheeduzzafar, Dakhil, F. H., and Al‐Gahtani, A. S. (1985). “Corrosion of reinforcement in concrete structures in the Middle East.” Concrete Int., 7(9), 48–55.
14.
Ravindrarajah, R., and Ong, K. (1987). “Corrosion of steel in concrete in relation to bar diameter and cover thickness.” Concrete Durability, Katherine and Bryant Mather Int. Conf. ACI SP‐100, Vol. 2, American Concrete Institute, 1667–1677.
15.
Tuutti K. (1980). “Service life of structures with regard to corrosion of embedded steel.” Performance of Concrete in Marine Environment, ACI SP‐65, American Concrete Institute, Detroit, Mich., 223–236.
16.
Tyler, I. L. (1960). “Lone‐time study of cement performance in concrete; chapter 12—concrete exposed to sea water and fresh water.” J. Amer. Concrete Int., Proc., 57(9), 825–836.
17.
Wakeman, C. M., Dockweiler, E. V., Stover, H. E., and Whiteneck, L. L. (1958). “Use of concrete in marine environments.” J. Amer. Concrete Inst., Proc., 54(10), 841–856.
Information & Authors
Information
Published In
Copyright
Copyright © 1992 ASCE.
History
Published online: Nov 1, 1992
Published in print: Nov 1992
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.