Probabilistic Evaluation of Design Iceberg Collision
Publication: Journal of Cold Regions Engineering
Volume 4, Issue 2
Abstract
A probabilistic model has been developed for the selection of a design iceberg collision with an offshore structure. The design event is selected on the basis of global sliding force, which is likely to determine whether or not structural failure will occur during an iceberg collision. Hydrodynamic effects, including iceberg added mass, wave‐induced oscillatory iceberg motions, and the modification of currents by the presence of a structure, are considered in the evaluation of iceberg velocity and location of impact against a structure. A time‐stepping model is subsequently used for evaluating forces induced by ice crushing and friction during a collision. The application of the model to the selection of a design iceberg collision event is illustrated through two examples. Among the various parameters influencing collision severity, it appears that eccentricity of impact has a relatively small influence on design load levels. Wave‐induced oscillatory motions are shown to be significant for small icebergs.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bass, D., Gaskill, H., and Riggs, N. (1985). “Analysis of iceberg impacts with gravity base structures at hibernia.” Proc. 4th Int. Symp. on Offshore Mech. and Arctic Engrg., American Society of Mechanical Engineers, 2, 255–259.
2.
Blevins, R. D. (1984). Applied fluid dynamics handbook. Van Nostrand Reinhold, New York, N.Y.
3.
Brooks, L. D. (1985). “Iceberg dimensions.” Proc. Workshop on Ice Scouring (Tech. Memorandum No. 136), Associate Committee on Geotechnical Research, National Research Council of Canada, 148–154.
4.
Dunwoody, A. B. (1983). “The design ice island for impact against an offshore structure.” Proc. 15th Offshore Tech. Conf. (Paper No. OTC 4550), Houston, Tex., 2, 325–330.
5.
Duthinh, D., and Marsden, S. (1986). “Iceberg impact load on a gravity based structure.” Proc. 4th Int. Conf. on Cold Regions Engrg., ASCE, 82–92.
6.
El‐Tahan, M., and Davis, H. L. (1985). “Correlation between iceberg draft and above water dimensions.” Proc. Workshop on Ice Scouring (Tech. Memorandum No. 136), Associated Committee on Geotechnical Research, National Research Council of Canada, 130–147.
7.
Forland, K. A., and Tatinclaux, J.‐C. (1984). “Laboratory investigation of the kinetic friction coefficient of ice.” Proc. 1984 IAHR Ice Symp., International Association for Hydraulic Research, 19–28.
8.
Isaacson, M. (1987). “Ice mass motions near an offshore structure.” J. Offshore Mech. and Arctic Engrg., 109(2), 206–210.
9.
Isaacson, M., and McTaggart, K. A. (1989). “Development of an iceberg collision reliability model incorporating hydrodynamic effects.” Proc. 8th Int. Symp. On Offshore Mech. and Arctic Engrg., American Society of Mechanical Engineers, 4, 293–299.
10.
Isaacson, M., and McTaggart, K. A. (1990). “Influence of hydrodynamic effects on iceberg collisions.” Can. J. Civ. Engrg., 17, June.
11.
LeBlond, P. H., Calisal, S. M., and Isaacson, M. (1982). “Wave spectra in Canadian waters.” Canadian Contractor Report of Hydrography and Ocean Sci. No. 6, Marine Envir. Data Services Branch, Dept. of Fisheries and Oceans, Ottawa, Canada.
12.
Lever, J. H., Reimer, E., and Diemand, D. (1988). “A model study of the waveinduced motion of small icebergs and bergy bits.” J. Offshore Mech. and Arctic Engrg., 110(1), 101–107.
13.
Lever, J. H., and Sen, D. (1987). “A method to upgrade iceberg velocity statistics to include wave‐induced motion.” J. Offshore Mech. and Arctic Engrg., 109(3), 278–286.
14.
Madsen, H. O., Krenk, S., and Lind, N. C. (1986). Methods of structural safety. Prentice‐Hall, Englewood Cliffs, N.J.
15.
McTaggart, K. A. (1989). “Hydrodynamics and risk analysis of iceberg impacts with offshore structures,” thesis presented to the University of British Columbia, at Vancouver, Canada, in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
16.
Pearson, D. E., and Ro, C.‐U. (1984). “Iceberg trajectory speed evaluation for the Labrador Sea.” Proc. 9th Can. Symp. on Remote Sensing, St. John's, Canada, 85–90.
17.
“A review of ice information for eastern Canada.” (1985). Report submitted to the Royal Commission on the Ocean Ranger Marine Disaster, NORDCO Limited, St. John's, Canada.
18.
Salvalaggio, M. A., and Rojansky, M. (1986). “The importance of wave‐driven icebergs impacting an offshore structure.” Proc. 18th Offshore Tech. Conf. (Paper No. OTC 5086), Houston, Tex., 1, 29–38.
19.
Sanderson, T. J. O. (1987). “A pressure‐area curve for ice.” 3rd state‐of‐the‐art report, T. J. O. Sanderson, ed., U.S. Army Cold Regions Res. and Engrg. Lab., Hanover, N.H., 75–98.
20.
Sarpkaya, T., and Isaacson, M. (1981). Mechanics of wave forces on offshore structures. Van Nostrand Reinhold, New York, N.Y.
21.
Thoft‐Christensen, P., and Baker, M. J. (1982). Structural reliability theory and its applications. Springer‐Verlag, Berlin, West Germany.
Information & Authors
Information
Published In
Journal of Cold Regions Engineering
Volume 4 • Issue 2 • June 1990
Pages: 85 - 101
Copyright
Copyright © 1990 ASCE.
History
Published online: Jun 1, 1990
Published in print: Jun 1990
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.