Sizing Municipal Storage Tanks Based on Reliability Criteria
Publication: Journal of Water Resources Planning and Management
Volume 134, Issue 6
Abstract
Municipal storage tanks are used to balance differences in supply and demand. Tanks have traditionally been sized based on deterministic criteria for balancing, fire, and emergency storage components. In this paper a stochastic analysis method is proposed to model both the deterministic and probabilistic components of consumer demand, fire demand, and pipe failures in water distribution systems. The method estimates a number of tank reliability criteria as functions of tank capacity, which provide a site-specific way of determining the required tank capacity based on user-defined reliability criteria. The method is illustrated by applying it to a “typical” water supply system. It was found that the tank failure duration follows a Weibull distribution. The tank failure rate was found to be very sensitive to tank capacity and can be described with an exponential distribution. It is proposed that one failure in under seasonal peak conditions is used as a design criterion for tank sizing. In many cases this will result in substantially smaller tanks than is currently specified by design guidelines.
Get full access to this article
View all available purchase options and get full access to this article.
References
Alvisi, S., Franchini, M., and Marinelli, A. (2003). “A stochastic model for representing drinking water demand at residential level.” Water Resour. Manage., 17(3), 197–222.
Aly, A. H., and Wanakule, N. (2004). “Short-term forecasting for urban water consumption.” J. Water Resour. Plann. Manage., 130(5), 405–410.
Billings, R. B., and Agthe, D. E. (1999). “Closure of ‘State-space versus multiple regression for forecasting urban water demand’.” J. Water Resour. Plann. Manage., 125(4), 241–242.
Bougadis, J., Adamowski, K., and Diduch, R. (2005). “Short-term municipal water demand forecasting.” Hydrolog. Process., 19(1), 137–148.
Boulos, P. F., Lansey, K. E., and Karney, B. W. (2004). Comprehensive water distribution systems analysis handbook for engineers and planners, MWH Soft, Pasadena, Calif.
Brière, F. G. (2000). Distribution et collecte des eaux, Presses Internationales Polytechnique, Montréal.
Buchberger, S., and Wu, L. (1995). “Model for instantaneous residential water demands.” J. Hydraul. Eng., 121(3), 232–256.
Ciottony, A. (1983). “Computerized data management in determining causes of water main failure.” Proc., 12th Int. Symp. on Urban Hydrology, Hydraulics and Sediment Control, Univ. of Kentucky, Lexington, Kentucky, 323–329.
Clark, R., Stafford, C., and Goodrich, J. (1982). “Water distribution systems: A spatial and cost evaluation.” J. Water Resour. Plng. and Mgmt. Div., 108(3), 243–256.
Clark, R. M., Abdesaken, F., Boulos, P. F., and Mau, R. E. (1996). “Mixing in distribution system storage tanks: Its effect on water quality.” J. Environ. Eng., 122(9), 814–821.
CSIR. (2000). “Chapter 9: Water Supply (2003 revision).” Guidelines for human settlement planning and design, CSIR Building and Construction Technology, Pretoria.
Damelin, E., Shamir, U., and Arad, N. (1972). “Engineering and economic evaluation of the reliability of water supply.” Water Resour. Res., 4(8), 861–877.
Eisenbeis, P. (1994). “Modélisation statistique de la prévision des défaillances sur les conduites d’eau potable.” Série Équipements pour l’ eau et ’environnement No. 17, Cemagref, Bordeaux, France (in French).
Fishman, S. F. (1995). Monte Carlo: Concepts, algorithms and applications, Springer, New York.
Goulter, I., and Coals, A. (1986). “Quantitative approaches to reliability assessment in pipe networks.” J. Transp. Eng., 112(3), 287–301.
Goulter, I., Davidson, J., and Jacobs, D. (1993). “Predicting water-main breakage rates.” J. Water Resour. Plann. Manage., 119(4), 419–436.
Guercio, R., and Xu, Z. (1997). “Linearized optimization model for reliability-based design of water systems.” J. Hydraul. Eng., 123(11), 1020–1026.
Haarhoff, J., and van Zyl, J. E. (2002). “Sizing of bulk water supply systems with a probabilistic method.” Rep. No. 985/1/02, Water Research Commission, Pretoria.
Homwongs, C., Sastir, T., and Foster, III, J. W. (1994). “Adaptive forecasting of hourly municipal water consumption.” J. Water Resour. Plann. Manage., 120(6), 888–905.
Jain, A., Varshney, A. K., and Joshi, U. C. (2001). “Short-term water demand forecast modelling at IIT Kanpur using artificial neural networks.” Water Resour. Manage., 15(5), 299–321.
Kettler, A., and Goulter, I. (1985). “An analysis of pipe breakage in urban water distribution networks.” Can. J. Civ. Eng., 12(2), 286–293.
Kretzmann, H. A., and van Zyl, J. E. (2004). “Stochastic analysis of water distribution systems.” World Water and Environmental Resources Congress, 1–10.
Kwietniewski, M., and Roman, M. (1997). “Establishing performance criteria of water supply systems reliability.” Aqua, 46(3), 181–184.
le Gat, Y., and Eisenbeis, P. (2000). “Using maintenance records to forecast failures in water networks.” Urban Water, 3(2), 173–181.
Lewis, E. (1996). Introduction to reliability engineering, Wiley, New York.
Maidment, D., Miaou, S.-P., and Crawford, M. (1985). “Transfer function models for daily urban water use.” Water Resour. Res., 21(4),425–432.
Mays, L. W. (2004). Water resource systems management tools, McGraw-Hill, New York.
Nel, D., and Haarhoff, J. (1996). “Sizing municipal water storage tanks with Monte Carlo simulation.” Aqua, 45(4), 203–212.
O’Day, D. (1983). “Analyzing infrastructure condition—A practical approach.” Civ. Eng. (N.Y.), 53(4), 39–42.
Pelletier, G., and Townsend, R. D. (1996). “Optimization of the regional municipality of Ottawa-Carleton’s water supply system operations. I: Model development.” Can. J. Civ. Eng., 23(2), 347–357.
Rossman, L. (2000). “EPANET users’ manual.” EPA-600/R-94/057, Environmental Protection Agency, Risk Reduction Engineering Laboratory, Cincinnati.
Røstum, R. (2000). “Statistical modelling of pipe failures in water networks.” Norwegian Univ. of Science and Technology, Trontheim, Norway.
Shinstine, D. S., Ahmed, I., and Lansey, E. (2002). “Reliability/availability analysis of municipal water distribution networks: Case studies.” J. Water Resour. Plann. Manage., 128(2), 140–151.
Shvartser, L., Shamir, U., and Feldman, M. (1993). “Forecasting hourly water demands by pattern recognition approach.” J. Water Resour. Plann. Manage., 119(6), 611–627.
Sullivan, J. (1982). “Maintaining aging systems—Boston’s approach.” J. Am. Water Works Assoc., 76(11), 554–559.
van Zyl, J., and Haarhoff, J. (1997). “South African fire water guidelines and their impact on water supply system cost.” J. South African Institution of Civil Engineering, 39(1), 49–53.
van Zyl, J. E., Borthwick, J., and Hardy, A. (2003). “OOTEN: An object-oriented programmers toolkit for Epanet.” CCWI and WATERSAVE Int. Conf. (Supplementary Proc.), Imperial College London, U.K.
Wagner, J., Shamir, U., and Marks, D. (1988). “Water distribution reliability: Simulation methods.” J. Water Resour. Plann. Manage., 114(3), 276–294.
Walski, T., and Pelliccia, A. (1982). “Economic analysis of water main breaks.” J. Am. Water Works Assoc., 74(3), 140–147.
Walski, T. M., Chase, D. V., and Savic, D. A. (2001). Water distribution modelling, Haestad, Waterbury, Conn.
Xu, C., Goulter, I., and Tickle, K. S. (1998). “Probabilistic hydraulic models for assessing capacity reliability of aging water distribution infrastructure.” HydraStorm ’98, 165–170.
Yang, S., Hsu, N., Louie, P., and Yeh, W. (1996). “Water distribution network reliability: connectivity analysis.” J. Infrastruct. Syst., 2(2), 54–64.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Mar 28, 2007
Accepted: Feb 22, 2008
Published online: Nov 1, 2008
Published in print: Nov 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.