Reliability/Availability Analysis of Municipal Water Distribution Networks: Case Studies
Publication: Journal of Water Resources Planning and Management
Volume 128, Issue 2
Abstract
Reliability/availability analyses are performed on two large-scale municipal water distribution networks in the Tucson Metropolitan Area in Arizona. Reliability is defined as the probability of satisfying nodal demands and pressure heads for various possible pipe failures (breaks) in the water distribution system at any given time. An existing reliability model based on a minimum cut-set method is linked to a steady-state simulation model that implicitly solves the continuity and energy equations. The results from the simulation model are used in the reliability model to define minimum cut sets and determine the values of system and nodal reliability. Availability is the proportion of time the system adequately satisfies the demands upon it. This more practical measure combines hydraulic and mechanical availability in a form that defines the proportion of the time that the system will satisfactorily fulfill its function. In addition to a simple discrete failure relationship with absolute failure if pressure heads fall below a prescribed minimum, hydraulic availability is modeled with a continuous increasing acceptability with higher pressures. Comparisons of results illustrate the similarities and differences in the design of each system under varying operating conditions. Design alternatives to improve reliability are discussed.
Get full access to this article
View all available purchase options and get full access to this article.
References
Bao, Y., and Mays, L. W.(1990). “Model for analysis of water distribution systems reliability.” J. Hydraul. Eng., 116(9), 1119–1137.
Billinton, R., and Allan, R. N. (1983). Reliability evaluation of engineering systems: Concepts and techniques, Pitman, London.
Cullinane, M. J. (1985). “Reliability evaluation of water distribution system components.” Proc., Specialty Conf. on Hydraulics and Hydrology in the Small Computer Age, ASCE, New York, 353–358.
Cullinane, M. J. (1986). “Hydraulic reliability of urban water distribution systems.” Proc., Water Forum 1986: World Water Issues in Evolution, ASCE, New York, 1264–1271.
Cullinane, M. J., Lansey, K. E., and Mays, L. W.(1992). “Optimization-availability-based design of water-distribution networks.” J. Hydraul. Eng., 118(3), 420–441.
Duan, N., and Mays, L. W.(1990). “Reliability analysis of pumping systems.” J. Hydraul. Eng., 116(2), 230–248.
Duan, N., Mays, L., and Lansey, K. E.(1990). “Optimal reliability-based design and analysis of pumping systems for water distribution systems.” J. Hydraul. Eng., 116(2), 249–268.
Fujiwara, O., and De Silva, A. U.(1990). “Algorithm for reliability-based optimal design of water networks.” J. Environ. Eng., 116(3), 575–587.
Fujiwara, O., and Tung, H. D.(1991). “Reliability improvement for water distribution networks through increasing pipe size.” Water Resour. Res., 27(7), 1395–1402.
Goulter, I. C., and Bouchart, F.(1990). “Reliability-constrained pipe network model.” J. Hydraul. Eng., 116(2), 211–229.
Goulter, I. C., and Coals, A.(1986). “Quantitative approaches to reliability assessment in pipe networks.” J. Transp. Eng. 112(3), 287–301.
Lansey, K. E., Duan, N., Mays, L. W., and Tung, Y.(1989). “Water distribution system design under uncertainties.” J. Water Resour. Plan. Manage., 115(5), 630–645.
Mays, L. W., ed. (1989). Reliability analysis of water distribution systems, ASCE, New York.
Mays, L. W., ed. (2000). Water distribution systems handbook, McGraw-Hill, New York.
Ross, S. M. (1985). Introduction to probability models, Academic, New York.
Shamir, U., and Howard, C. D. (1981). “Water supply reliability theory.” J. Am. Water Works Assoc., 73(7), 379–384.
Shinstine, D. S. (1999). “Reliability analysis using the minimum cut-set method for three water distribution systems.” MS thesis, Univ. of Arizona, Tucson, Ariz.
Su, Y.-C., Mays, L. W., and Lansey, K. E.(1987). “Reliability-based optimization model for water distribution systems.” J. Hydraul. Eng., 113(12), 1539–1556.
Tung, Y.-K. (1985). “Evaluation of water distribution network reliability.” Proc., ASCE Hydraulics Specialty Conf., ASCE, New York, 359–364.
Wagner, J. M., Shamir, U., and Marks, D.(1988). “Water distribution reliability: Simulation methods.” J. Water Resour. Plan. Manage., 114(3), 276–294.
Wood, D. J. (1980). User’s manual—Computer analysis of flow in pipe networks including extended period simulation, Dept. of Civil Engineering, Univ. of Kentucky, Lexington, Ky.
Information & Authors
Information
Published In
Journal of Water Resources Planning and Management
Volume 128 • Issue 2 • March 2002
Pages: 140 - 151
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Jul 28, 2000
Accepted: Jan 12, 2001
Published online: Mar 1, 2002
Published in print: Mar 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.