Resilient Modulus Prediction Models Based on Analysis of LTPP Data for Subgrade Soils and Experimental Verification
Publication: Journal of Transportation Engineering
Volume 133, Issue 9
Abstract
Resilient modulus value of a subgrade soil is the primary property needed for pavement design and analysis. It is the elastic modulus based on the recoverable strain under repeated loads, and depends on several factors including soil properties, soil type, and state of stresses. This paper presents prediction equations developed using regression analysis for six AASHTO soil types (A-1-b, A-3, A-2-4, A-4, A-6, and A-7-6) for estimating . Data extracted from the Long-Term Pavement Performance Information Management System (LTPP IMS) database for 258 test specimens (approximately 3,870 values) collected in 19 states in New England and the nearby regions in the United States and two provinces in Canada were used in this study. A generalized constitutive model that captures the effect of both bulk stress and octahedral shear stress was used to predict the of subgrade soils by developing regression equations that relate the coefficients to the soil physical properties. The prediction models developed were verified for four types of soils collected in the New England region by independent laboratory tests. It was observed that values from the prediction models compared well with the laboratory values for the majority of the soil types.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research work reported herein was performed under the Project NETC 02-3 sponsored by the New England Transportation Consortium. The financial support from the Consortium is gratefully acknowledged. The writers are thankful to Connecticut Department of Transportation and Vermont Agency of Transportation for their help in the collection of soil samples for laboratory tests and to Long Term Pavement Performance (LTPP) Technical Support Services Contractor, Oak Ridge, Tennessee for providing the LTPP information management system (IMS) data CDs. Sincere thanks are also due to Braun Intertec Corporation, MN for conducting the laboratory tests. This paper was prepared in cooperation with the New England Transportation Consortium, does not constitute a standard, specification, or regulation. The contents of this paper reflect the views of the writers, who are responsible for the facts and the accuracy of the data presented herein. The contents do not necessarily reflect the views of the New England Transportation Consortium or the Federal Highway Administration.
References
AASHTO. (1993). AASHTO guide for design of pavement structures, Washington, D.C.
Chatterjee, S., and Price, B. (1977). Regression analysis by example, Wiley, New York.
Chen, X., Ender, P., Mitchell, M., Eyben, R., and Wells, C. (2004). “Regression with SAS.” UCLA Academy Technology Services, Univ. of California, Los Angeles, http://www.ats.ucla.edu/stat/sas/webbooks/reg (May 10, 2004).
George, K. P. (2004). “Prediction of resilient modulus from soil index properties.” Rep. No. FHWA/MS-DOT-RD-04-172, The Univ. of Mississippi, Univ., Miss.
LTPP IMS. (2003). Long term pavement performance information management system (LTPP IMS) data, release 15.0 (January 2003 upload) (CD ROM), provided by LTPP Technical Support Services Contractor, Oak Ridge, Tenn.
Malla, R., and Joshi, S. (2005). “Resilient modulus prediction models for some New England subgrade soils.” Proc., 2005 Joint ASCE/ASME/SES Conf. on Mechanics and Materials (McMat 2005), Baton Rouge, La.
Malla, R., and Joshi, S. (2006). “Establish subgrade support values for typical subs in New England.” NETCR-57, Final NETC 02–3 Project Rep., New England Transportation Consortium, Fall River, Mass.
May, R. W., and Witczak, M. W. (1981). “Effective granular modulus to model pavement responses.” Transportation Research Record. 810, TRB, National Research Council, Washington, D.C., 1–9.
Mohammad, L. N., Huang, B., Puppala, A. J., and, Allen, A. (1999). “Regression model for resilient modulus of subgrade soils.” Transportation Research Record. 1687, TRB, National Research Council, Washington, D.C., 47–54.
Montgomery, D., and Peck, E. (1992). Introduction to linear regression, Wiley, New York.
NCHRP. (2003). “2002 design guide, design of new and rehabilitated pavement structures.” Draft review copy of Project Rep., NCHRP 1-37A (submitted by ARA, Inc., ERES Consultants Division), National Research Council, Transportation Research Board, Washington, D.C.
NCHRP. (2004). “Guide for mechanistic-empirical design of new and rehabilitated pavement structures.” Final Rep. NCHRP 1-37A (submitted by ARA, Inc., ERES Consultants Division), National Research Council, Transportation Research Board, Washington, D.C., ⟨http://www.trb.org/mepdg/guide.htm⟩ (November 21, 2006).
Rauch, A. F. (1997). “Appendix D. Methods of multiple linear regression analysis.” An empirical method for predicting surface displacements due to liquefaction-induced lateral spreading in earthquakes, Virginia Polytechnic Institute and State Univ., Blacksburg, Va.
Santha, B. L. (1994). “Resilient modulus of subgrade soils: Comparison of two constitutive equations.” Transportation Research Record. 1462,TRB, National Research Council, Washington, D.C., 79–90.
SAS. (2002–2003 ). SAS 9.1.3, help and documentation, SAS Institute Inc., N.C.
Smart, A. L., and Humphrey, D. N. (1999). “Determination of resilient modulus for Maine roadway soil.” Tech. Rep. No. ME 96-10, Maine DOT, Bureau of Planning, Transportation Research Division.
Uzan, J. (1985). “Characterization of granular material.” Transportation Research Record. 1022, TRB, National Research Council, Washington, D.C., 52–59.
Von Quintus, H., and Killingsworth, B. (1998). “Analysis relating to pavement material characterizations and their effects on pavement performance.” Rep. No. FHWA-RD-97-085, FHWA, U.S. DOT, Washington, D.C.
Yau, A., and Von Quintus, H. (2002). “Study of laboratory resilient modulus test data and response characteristics: Final report.” Rep. No. FHWA-RD-02-051, FHWA, U.S. DOT, Washington, D.C.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Nov 9, 2005
Accepted: Sep 18, 2006
Published online: Sep 1, 2007
Published in print: Sep 2007
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.