Speed Changes in the Vicinity of Horizontal Curves on Two-Lane Rural Roads
Publication: Journal of Transportation Engineering
Volume 133, Issue 4
Abstract
In some situations, the horizontal alignment of a road, particularly circular curves, are designed for reduced speeds compared to their adjacent sections to reduce costs and to avoid compromising the qualities of historical districts and areas of special value. Thus far, there is no sufficient research on driver behavior in the vicinity of curves with reduced standards. Speed transition behavior should be considered in designing spirals or tangent-to-curve sections where there is a difference in the design speed between the curve and the adjacent tangents. Driver behavior before and after horizontal curves was investigated and speed models for transition sections were developed. These models could be used to design transition sections and to assess the design consistency of two-lane rural roads. The results indicated that 66% of the speed reduction and 72% of the speed increase occurs on the tangents preceding and following the curves, respectively. In addition, the mean deceleration rate and the mean acceleration rate are 0.033 and , respectively; or approximately 0.732 and , respectively, for a reduction.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the Joint Transportation Research Program administered by the Indiana Department of Transportation and Purdue University.
References
AASHTO. (2004). A policy on geometric design of highways and streets, Washington, D.C.
Bonneson, J. (2000). “Kinematic approach to horizontal curve transition design.” Transportation Research Record. 1737, Transportation Research Board, Washington, D.C., 1–8.
Bonneson, J. (2001). “Controls for horizontal curve design.” Trans-portation Research Record. 1751, Transportation Research Board, Washington, D.C., 82–89.
Craus, J., and Polus, A. (1977). “Aspects of spiral transition curve design.” Transportation Research Record. 631, Transportation Research Board, Washington, D.C., 1–4.
Figueroa, A., and Tarko, A. (2005). “Speed factors on two-lane rural highways in free-flow conditions.” Transportation Research Record. 1912, Transportation Research Board, Washington, D.C., 39–46.
Fitzpatrick, K., et al. (1999). “Speed prediction for two-lane rural highways.” Report No. FHWA-RD-99-171, Federal Highway Administration, Washington, D.C.
Fitzpatrick, K., and Collins, J. (2000). “Speed-profile model for two-lane rural highways.” Transportation Research Record. 1737, Transportation Research Board, Washington, D.C., 42–49.
Fitzpatrick, K., Carlson, P., Brewer, M., Wooldridge, M., and Miaou, S. (2003). “Design speed, operating speed, and posted speed practices.” NCHRP Rep. No. 504, Transportation Research Board, Washington, D.C.
Hassan, Y., Gibreel, G., and Easa, S. (2000). “Evaluation of highway consistency and safety: Practical application.” J. Transp. Eng., 126(3), 193–201.
Krammes, R. (2000). “Design speed and operating speed in rural highway alignment design.” Transportation Research Record. 1701, Transportation Research Board, Washington, D.C., 68–75.
Lamm, R., Psarianos, B., and Mailaender, T. (1999). Highway design and traffic safety engineering handbook, McGraw-Hill, New York.
Leisch, J. E., and Leisch, J. P. (1977). “New concepts in design-speed application.” Transportation Research Record. 631, Transportation Research Board, Washington, D.C., 4–14.
Lyles, R. (1982). “Advisory and regulatory speed signs for curves: Effective or overused?” ITE J., 52(8), 20–22.
Misaghi, P., and Hassan, Y. (2005). “Modeling operating speed and speed differential on two-lane rural roads.” J. Transp. Eng., 131(6), 408–418.
Nicholson, A. (1998). “Superelevation, side friction, and roadway consistency.” J. Transp. Eng., 124(5), 411–418.
Ottesen, J., and Krammes, R. (2000). “Speed-profile model for a design-consistency evaluation procedure in the United States.” Transportation Research Record. 1701, Transportation Research Board, Washington, D.C., 76–85.
Tarris, J., Poe, C., Mason, J., Jr., and Goulias, K. (1996). “Predicting operating speeds on low-speed urban streets: Regression and panel analysis approaches.” Transportation Research Record. 1523, Transportation Research Board, Washington, D.C., 46–54.
Washington, S., Karlaftis, M., and Mannering, F. (2003). Statistical and econometric methods for transportation data analysis, Chapman & Hall/CRC, Boca Raton, Fla.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Mar 14, 2006
Accepted: Sep 18, 2006
Published online: Apr 1, 2007
Published in print: Apr 2007
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.