Structural Performance Monitoring of an Unstabilized Fly Ash-Based Road Subbase
Publication: Journal of Transportation Engineering
Volume 132, Issue 12
Abstract
Beneficial utilization of stabilized fly ash as a structural layer in pavement construction is a common practice in the United States. At the same time, application of untreated and unstabilized fly ash in such cases is relatively rare. One such application was demonstrated at an Industry Access Truck Route in the state of Illinois. Approximately of F-fly ash, compacted in place, was used to construct the subbase for the wide and long road. The entire road was built into three control sections, i.e., AC1, fly ash, and AC2. Control Section AC1 was long and was built on fine sand subgrade; the fly ash control section was long and was built on silty/clayey subgrade using fly ash as subbase; Control Section AC2 was long and was built on clayey subgrade. This paper presents the long-term postconstruction structural performance results of the fly ash control section, as compared to Control Sections AC1 and AC2. Falling weight deflectometer studies performed on the truck route have indicated all the sections of the truck route to be performing satisfactorily. The fly ash control section in particular has exhibited very good structural performance.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (1993). AASHTO guide for design of pavement structures, Washington, D.C.
Chugh, Y. P., Hance, C., and Mohanty, S. (2003). “Development and demonstration of coal combustion byproducts based road subbase: Meredosia access truck route.” Proc., 28th Int. Conf. on Coal Utilization and Fuel Systems, Clearwater, Fla.
Chugh, Y. P., Hance, C., and Mohanty, S. (2004). “Performance assessment of a fly ash based road subbase in Illinois using falling weight deflectometer.” Proc., Pittsburgh Coal Conf., Osaka, Japan.
Chugh, Y. P., and Mohanty, S. (2003). Development and Demonstration of Coal Combustion Byproducts Based Road Subbase, Final Project Technical Rep., submitted to Illinois Clean Coal Institute, Carterville, Ill.
Chugh, Y. P., and Mohanty, S. (2004). “Construction and assessment of high carbon coal combustion byproduct based road subbase.” Proc., 6th Int. Conf., on Clean Technologies for the Mining Industry, Concepcion, Chile.
Chugh, Y. P., Mohanty, S., Carty, R., and Bryant, M. (2005). “Post-construction environmental monitoring of a fly ash based road subbase.” Proc., World of Coal Ash Conf., Lexington, Ky.
Kroeger, E. B., and Chugh, Y. P. (2002). “Development and demonstration of CCP based road subbase.” Proc., 2002 Annual Meeting of Society for Mining, Metallurgy, and Exploration, Inc., Phoenix, Paper 02-140.
Mohanty, S. (2003). “Engineering and demonstration of a fly ash based road subbase.” MS thesis, Dept. of Mining and Mineral Resources Engineering, Southern Illinois Univ., Carbondale, Ill.
Rahim, A., and George, K. P. (2003). “Falling weight deflectometer for estimating subgrade elastic moduli.” J. Transp. Eng., 129(1), 100–107.
Von Quintus, H. L., and Killingsworth, B. M. (1998). “Comparison of laboratory and in-situ determined elastic layer moduli.” Proc., 76th Annual Meeting of the Transportation Research Board, Washington, D.C.
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: Dec 12, 2005
Accepted: May 18, 2006
Published online: Dec 1, 2006
Published in print: Dec 2006
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.