Assessment of Three Simulation Models for Diamond Interchange Analysis
Publication: Journal of Transportation Engineering
Volume 130, Issue 3
Abstract
The performance of three traffic analysis tools: CORSIM, SIMTRAFFIC, and SYNCHRO was investigated for application to diamond interchanges. Actuated signal operation was implemented for different ramp spacings and traffic patterns. The performance differences were discussed for three performance measures: Cycle length, average delay, and total stops. Our research showed that the two microscopic models (CORSIM and SIMTRAFFIC) produced similar performance, but the macroscopic program SYNCHRO provided different performance trends. It was found that SYNCHRO 4 and SIMTRAFFIC produced different phase splits for the same input data. Therefore, there is a possibility that estimated delay (or stops) performance could vary depending on the model selected. Our results also indicate that SYNCHRO 4 apparently does not reflect some progression effects properly, thus the application of SYNCHRO 4 for diamond interchanges should be used with caution. Either SIMTRAFFIC or CORSIM used in conjunction with hardware-in-the-loop simulation should be used for analysis of actuated diamond interchanges. It was also found that SIMTRAFFIC tended to model queue spillback conditions more restrictively at the upstream intersection than did CORSIM or SYNCHRO.
Get full access to this article
View all available purchase options and get full access to this article.
References
Benekohal, R. F., and Abu-Lebdeh, G. (1994). “Variability analysis of traffic simulation outputs: Practical approach for TRAF-NETSIM.” Transportation Research Record 1457, Transportation Research Board, Washington, D.C., 198–207.
Chang, G. L., and Kanaan, A.(1990). “Variability assessment for TRAF-NETSIM.” J. Transp. Eng., 116(5), 636–657.
Eagle Traffic Control Systems. (1996). EPAC300 Actuated Controller Unit Product: Manual PIM-177, Austin, Texas.
Engelbrecht, R. J., Poe, C. M., and Balke, K. N. (1999). “Development of a distributed hardware-in-the-loop simulation system for transportation networks.” Proc., 78th Transportation Research Board Annual Meeting, Washington, D.C.
Highway Capacity Manual (HCM). (1997). Transportation Research Board, National Research Council, Washington, D.C.
Highway Capacity Manual (HCM). (2000). Transportation Research Board, National Research Council, Washington, D.C.
Husch, D., and Albeck, J. (1999). Synchro 4.0 User Guide, Trafficware, Albany, Calif.
International Telephone and Telegraph (ITT) Industries. (2001). CORSIM User’s Guide Version 5, Colorado Springs, Colo.
Koonce, P. J., Urbanik, T., and Bullock, D. (1999). “Evaluation of diamond interchange signal controller settings by using hardware-in-the-loop.” Transportation Research Record 1683, Transportation Research Board, Washington D.C., 59–66.
Mendenhall, W., Scheaffer, R. L., and Wackerly, D. D. (1986). Math-ematical statistics with application, 3rd Ed., Duxbury Press, Boston.
Messer, C. J., and Bonneson, J. A. (1997). “Capacity analysis of interchange ramp terminals.” National Cooperative Highway Research Program Rep. 347, Transportation Research Board, Washington, D.C.
Munjal, P. K. (1971). “An analysis of diamond interchange signalization.” Highway Research Record 349, Highway Research Board, Washington, D.C., 47–64.
Rathi, A. K., and Venigalla, M. M. (1992). “Variance reduction applied to urban network traffic simulation.” Transportation Research Record 1365, Transportation Research Board, Washington, D.C., 133–146.
Ross, S. M. (1991). A course in simulation, Macmillan, New York.
SAS Institute Incorporated. (1988). SAS/STAT user’s guide, Release 6.03 Edition, Cary, N.C.
Selinger, M. J., and Sharp, W. H. (2000). “Comparison of SPUI andTUDI interchange alternatives with computer simulation modeling.” Institute of Transportation Engineers 2000 Annual Meeting (CD-Rom), Institute of Transportation Engineers, Nashville, Tenn.
TRANSYT-7F. (1998). Users guide: Methodology for optimizing signal timing, Vol. 4, Univ. of Florida, Gainesville, Fla.
Venglar, S., Koonce, P., and Urbanik, T. (1998). PASSER III-98 application and user’s guide, Texas Transportation Institute, Texas A&M Univ., College Station, Tex.
Washburn, S., and Larson, N. (2001). “Signalized intersection delay estimation: Case study comparison of TRANSYT-7F, Synchro, and HCS.” Proc., 80th Annual Meeting of the Transportation Research Board, (CD-Rom), National Research Council, Washington, D.C.
Yang, X. K.(2001). “Comparison among computer packages in providing timing plans for Iowa arterial in Lawrence, Kansas.” J. Transp. Eng., 127(4), 311–318.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: May 7, 2002
Accepted: Jun 12, 2003
Published online: Apr 15, 2004
Published in print: May 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.