Revised Design Parameters for Vertical Curves
Publication: Journal of Transportation Engineering
Volume 124, Issue 4
Abstract
A Policy on Geometric Design of Highways and Streets, by the American Association of State Highway and Transportation Officials (AASHTO), exhibited severe disparities between its recommended procedures for the computation of braking distances on grades and the design controls of vertical curves. The braking distances it advocated for the design of vertical curves are fully consistent with flat terrains. The grades of the tangents only influenced the curvatures needed to achieve braking distances and thus stopping sight distances on flat grades. A vehicle traveling on a crest vertical curve of Type II, or a sag vertical curve of Type IV, experienced at no time a flat grade. Types II and IV vertical curves join tangents with identical grade orientations. This study pinpoints the inconsistencies of the previous procedures and proposes conciliatory procedures. A new methodology computes simultaneously the worst grades of braking initiation, the associated braking and stopping sight distances, and the resulting minimum rates of vertical curvature. The new methodology can result in longer and flatter curves than currently utilized given the design parameters recommended by AASHTO. The writers recommend the calibration of design parameters of vertical curves for the new methodology prior to implementation and guard against the blind acceptance of longer vertical curves. The inconsistencies by AASHTO may have misrepresented various design parameters.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Farber, E. I. (1982). “Driver eye-height trends and sight distance on vertical curves.”Transp. Res. Rec. 855, Trans. Res. Bd., Washington, D.C., 27–33.
2.
Garber, N., and Hoel, L. (1988). Traffic and highway engineering. West Publishing Co., St. Paul, Minn.
3.
Hickerson, T. F. (1964). Route location and design. McGraw-Hill Inc., New York, N.Y.
4.
Khasnabis, S., and Tadi, R. R. (1990). “Sight distance requirements for symmetrical- and unsymmetrical-crest vertical curves.”Transp. Res. Rec. 1280, Transp. Res. Bd., Washington, D.C., 227–235.
5.
Olson, P. L., Cleveland, D. E., Fancher, P. S., Kotyniuk, L. P., and Schneider, L. W. (1984). “Parameters affecting stopping sight distance.”Rep. No. NCHRP 270, Nat. Cooperative Hwy. Res. Program, Washington, D.C.
6.
Policy on geometric design of highways and streets. (1994). Am. Assn. of State Hwy. and Transp. Officials, Washington, D.C.
Information & Authors
Information
Published In
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: Jul 1, 1998
Published in print: Jul 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.