Assessment of Concrete Pavement Blowups
Publication: Journal of Transportation Engineering
Volume 123, Issue 2
Abstract
The assessment is based on the analyses of pavement blowups presented by the writer and his coworkers Dallis and Shade. The introduction reviews briefly the various early attempts to clarify the blowup phenomenon. The next section describes the blowup mechanism, the adopted criterion of the “safe temperature increase,” and an outline of the analytical methodology this presentation is based on. The third section contains the analytical solutions for three typical pavement problems, the description of steps for their numerical evaluation as well as a list of the used pavement parameters, and a graphical presentation of the obtained results. The fourth and fifth sections contain a discussion of the practical implications of the presented results for concrete pavement design, as well as for assessing pavement blowups after years of service. Also presented are a number of specific pavement problems and suggestions of full-scale tests for the determination of the identified pavement parameters.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Andrews, R. D. (1978). “Buckling of concrete—a review.”Supplementary Rep. 430, Transport and Road Research Laboratory, Crowthorne, England.
2.
Bergstrom, S. G. (1950). “Temperature stresses in concrete pavements.”Proc., Swedish Cement and Concrete Res. Inst. at the Royal Inst. of Technol., Stockholm, Sweden.
3.
Bowers, D. F. (1966). “A study of the failures occurring in the concrete pavements of the Connecticut Turnpike and roads of similar design.” Connecticut State Highway Department.
4.
Burke, M. P. (1972). “The world's most expensive pavement expansion joints.”Ohio Transp. Engrg. Conf., The Ohio State Univ., Columbus, Ohio.
5.
Chia, W. S., and McCullough, B. F. (1986). “Field evaluation of subbase friction characteristics.”Res. Rep. 459-5, Ctr. for Transp. Res., Univ. of Texas at Austin, Austin, Tex.
6.
Darter, M. I., and Barenberg, E. J. (1976). “Zero-maintenance pavement; results of field studies on the performance requirements and capabilities of conventional pavement systems.”Ofc. of R&D Rep. FHWA-RD-76-105, Federal Highway Administration, p. 52.
7.
El-Aini, Y. M. (1976). “Effect of foundation stiffness on track buckling.”J. Engrg. Mech. Div., ASCE, 102(3).
8.
ENR. (1925). “Repair of concrete blowups in Delaware.” No. 95, 432–433.
9.
Foxworthy, P. T. (1973). “Statewide survey of blowups in resurfaced concrete pavements.”Interim Rep., Joint Hwy. Res. Proj., Purdue Univ. and Indiana State Hwy. Commission.
10.
Gardiner, D. E., and Chamberlain, W. P. (1968). “Pressure relief joints for rigid pavements.”New York State Dept. of Transp. Res. Rep.
11.
Graham, M. D. (1967). “Summary of 1966 rigid pavement blowup survey.”Res. Proj. No. 245, New York State Department of Public Works.
12.
Gress, D. L. (1976). “Blowups on resurfaced concrete pavements.”Joint Hwy. Res. Proj., Rep. No. JHRP-76-25, Purdue Univ., West Lafayette, Ind.
13.
Gress, D. L. (1976). “Pavement blowups and resurfacing,” PhD dissertation, Purdue Univ., West Lafayette, Ind.
14.
Hensley, M. J. (1966). “The study of pavement blowups.”Arkansas State Hwy. Dept., Res. Proj. 10.
15.
Hveem, F. N. (1958). “Types and causes of failure in highway pavements.”Hwy. Res. Board Bull. 187, 1–52.
16.
Kawaguchi, M. (1969). “Thermal buckling of continuous pavement.”Trans. JSCE 1, Japanese Society for Civil Engineers, Tokyo, Japan, 331–344.
17.
Kawaguchi, M. (1972). “Thermal buckling of concrete pavements with joints.”Trans. JSCE 4, Japanese Society for Civil Engineers, Tokyo, Japan, 6–7.
18.
Kelley, E. F. (1939). “Application of the results of research to the structural design of concrete pavements.”Public Roads, Vol. 20, 83–126.
19.
Kerr, A. D. (1973). “Model study of vertical track buckling.”High Speed Ground Transp. J., Vol. 7, 351–368.
20.
Kerr, A. D.(1978). “Thermal buckling of straight tracks: fundamentals, analyses and preventive measures.”Proc., Am. Railway Engrg. Assn., 80, 16–47.
21.
Kerr, A. D.(1994). “Blowup of concrete pavement adjoining a rigid structure.”Int. J. Non-Linear Mechanics, 29(3), 387–396.
22.
Kerr, A. D., and Dallis, W. A. Jr.(1984). “Blowup of concrete pavements.”J. Transp. Engrg., 111(1), 33–53.
23.
Kerr, A. D., and Shade, P. J. (1984). “Analysis of concrete pavement blowups.”Acta Mechanica, Vol. 52, 201–224.
24.
Levi, R., and Perrin. (1947). “Les risques de soulevement des pistes et des roies ferrees,”Inst. d. Batiment et d. Trav. Public, Circ. Series I, No. 36.
25.
National Cooperative Hwy. Res. Program. (1973). “Design, construction and maintenance of Portland cement concrete pavement joints.” Highway Research Board, Synthesis of Highway Practice, No. 19.
26.
Nussbaum, P. J., and Lokken, E. C. (1977). “Design and construction of concrete pavements.”Proc., Int. Conf. on Concrete Pavement Des., Purdue Univ., West Lafayette, Ind.
27.
Richards, A. M. (1976). “Causes, measurement and prevention of pavement forces leading to blowups.”Univ. of Akron Res. Rep. OHIO-DOT-10-76, 131 pgs.
28.
Stabilini, L. (1965). “Über die maximale Länge der monolithischen Beläge für Strassen und Flugplätze.”Stahlbau und Baustatik—Aktuelle Probleme, H. Grengg, W. Pelikan, and F. Reinitzhuber, eds., Springer-Verlag, Vienna, Austria, 20–30 (in German).
29.
Stott, J. P., and Brook, K. M. (1968). “Report on a visit to U.S.A. to study blowups in concrete roads.”Road Res. Lab., Rep. LR 128, British Ministry of Transport.
30.
Teller, L. W., and Sutherland, E. C. (1935). “Observed effects of variations in temperature and moisture on the size, shape and stress resistance of concrete pavement slabs.”Public Roads, Vol. 16, 169–197.
31.
Wesevich, J. W., McCullough, B. F., and Burns, N. H. (1987). “Stabilized subbase friction study for concrete pavements.” Ctr. for Transp. Res., Res. Rep. 459-1, Univ. of Texas at Austin, Austin, Tex.
32.
Woods, K. B., Sweet, H. S., and Shelburne, T. E. (1945). “Pavement blowups correlated with source of coarse aggregate.”Proc., Hwy. Res. Board No. 25.
Information & Authors
Information
Published In
Copyright
Copyright © 1997 American Society of Civil Engineers.
History
Published online: Mar 1, 1997
Published in print: Mar 1997
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.