Interface Shear Stress in Overlaid Concrete Pavements
Publication: Journal of Transportation Engineering
Volume 120, Issue 2
Abstract
Shear stresses at the interface between an existing concrete pavement and an overlay are calculated using the finite‐element method for different loading conditions. The effects of vertical wheel loads, temperature loading, and wheel braking forces are considered. Perfect bonding between the overlay and the pavement is assumed. The pavement‐overlay slab is modeled using thin plate elements for calculating the stresses due to the vertical wheel load and temperature gradient. In analysis for stresses due to wheel braking loads, the slab is modeled with solid elements. The results are checked against Cerrutti's closed‐form solution in the case of horizontal wheel braking. The computed shear stresses at the pavement‐overlay interface for typical values of pavement and overlay thicknesses, wheel loads, and thermal gradients are compared to reported values of shear strength of laboratory‐prepared overlaid specimens. The shear stresses at the interface are found to be small in relation to the interfacial bond strength of laboratory‐prepared overlaid specimens. The findings suggest that debonding in overlay construction in the field is likely to be caused by stress concentrations due to local defects.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Betterton, R. M., Knutson, M. J., and Marks, V. J. (1985). “Fibrous portland cement concrete overlay research in Greene County, Iowa.” Transp. Res. Record 1040, Transportation Research Board (TRB), Washington, D.C., 1–7.
2.
Cheung, Y. K., Kim, I. P., and Zienkiewicz, O. C. (1968). “Slab bridges with arbitrary shape and support conditions—a general method of analysis based on finite elements.” Proc., Instn. Civ. Engrs., London, England, 40(1), 9–46.
3.
Cleland, D. J., Naderi, M., and Long, A. E. (1986). “Bond strength of patch repair mortars for concrete.” Adhesion between polymer and concrete, Chapman & Hall, London, England, 235–244.
4.
Concrete roads, design and construction. (1956). Road Research Laboratory, Ministry of Transport, London, England.
5.
Faraggi, V., Jofre, C., and Kramer, C. (1987). “Combined effect of traffic loads and thermal gradients on concrete pavement design.” Transp. Res. Record 1136, Transportation Research Board (TRB), Washington, D.C., 108–118.
6.
Frederick, D. (1957). “Thick rectangular plates on an elastic foundation.” Trans. ASCE, Vol. 122, 1069–1085.
7.
Huang, Y. H., and Wang, S. T. (1974). “Finite element analysis of rigid pavements with partial subgrade contact.” Transp. Res. Record 485, Transportation Research Board (TRB), Washington, D.C., 39–54.
8.
Hutchinson, R. L. (1982). Resurfacing with portland cement concrete; NCHRP synthesis of highway practice 99. Transportation Research Board (TRB), Washington, D.C.
9.
Love, A. E. H. (1927). A treatise on the mathematical theory of elasticity. 4th Ed., Cambridge University Press, London, England.
10.
McGhee, K. H., and Ozyildirim, C. (1992). “Construction of a thin bonded portland cement concrete overlay using accelerated paving techniques.” 71st Annu. Transp. Res. Bound Meeting: Preprint, Paper No. 920346, Transportation Research Board (TRB), Washington, D.C.
11.
A policy on the geometric design of rural highways. (1954). American Association of State Highway Officials (AASHO), Washington, D.C.
12.
Reinhardt, H. W. (1982). “Length influence on bond shear strength of joints in composite precast slabs.” Int. J. Cement Composites and Lightweight Concrete, 14(3), 139–143.
13.
Richardson, J. M., and Armaghani, J. M. (1987). “Stress caused by temperature gradient in portland cement concrete pavements.” Transp. Res. Record 1121, Transportation Research Board (TRB), Washington, D.C., 7–13.
14.
Saucier, F., Bastien, J., Pigeon, M., and Fafard, M. (1991). “A combined shear‐compression device to measure concrete to concrete bonding.” Experimental Techniques, 15(5), 50–55.
15.
Sinno, R., and Furr, H. (1970). “Bonded concrete overlays.” J. Struct. Div., ASCE, 96(8), 1627–1638.
16.
Timoshenko, S., and Woinowsky‐Krieger, S. (1959). Theory of plates and shells. 2nd Ed., McGraw‐Hill Int., New York, N.Y.
17.
Wall, J. S., and Shrive, N. G. (1988). “Factors affecting bond between new and old concrete.” ACI Mat. J., 85(2), 117–125.
18.
Wildermuth, B. (1980). “An assessment of the Hansen's review team's report on Singapore transport and urban development option.” Rep., Wilbur Smith and Associates.
Information & Authors
Information
Published In
Copyright
Copyright © 1994 American Society of Civil Engineers.
History
Received: Nov 23, 1992
Published online: Mar 1, 1994
Published in print: Mar 1994
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.