Field Instrumentation and Performance Monitoring of Rigid Pavements
Publication: Journal of Transportation Engineering
Volume 118, Issue 3
Abstract
This paper reviews some of the past instrumentation and performance measuring used by the U.S. Army Corps of Engineers to develop its rigid‐pavement design procedures, and it will consider two areas where future studies could improve our understanding of rigid pavement performance. Results of instrumental model tests and full‐scale traffic tests gave confidence in the Westergaard edge‐loaded analytical model to calculate design stresses. This model has been the backbone of the design concept for more than 40 years, and it continues to serve the Corps well. Also, performance measurements of joints developed the concept of joint load transfer that allowed more economical design of pavements and that also defined standards of joint design. There are still challenges facing the Corps, where instrumentation and performance measurements in the field can help develop better design standards. The actual effects of temperature and moisture gradients on rigid‐pavement performance and bonding in rigid‐pavement overlays remain poor and could be improved by field measurements.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Barenberg, E. J., and Smith, R. E. (1979). “Longitudinal joint systems in slip‐formed rigid pavements. Vol. I—Literature survey and field inspection.” Report No. FAA‐RD‐4‐I, Department of Transportation, Federal Aviation Administration, Washington, D.C.
2.
“Considerations for design of concrete structures subjected to fatigue loading.” (1986). ACI 215R‐74 (Revised 1986), American Concrete Institute, Detroit, Mich.
3.
Final report on the dynamic loadings on concrete test slab‐Wright field slab tests. (1943). Ohio River Division Laboratory, U.S. Army Corps of Engineers, Mariemont, Ohio.
4.
Grau, R. W. (1979). “Evaluation of drilled and grouted‐in‐place dowels for load transfer of portland cement concrete, Tyndall Air Force Base, Florida.” Tech. Report GL‐79‐11, U.S. Army Engineer Waterways Experiment Station, Vicksburg, Miss.
5.
Ledbetter, R. H. (1976). “Pavement response to aircraft dynamic loads; Compendium.” Tech. Report S‐75‐11, Vol. III, U.S. Army Engineer Waterways Experiment Station, Vicksburg, Miss.
6.
Lockbourne no. 1 test track, final report. (1946). Ohio River Division Laboratory, U.S. Army Corps of Engineers, Mariemont, Ohio.
7.
Lockbourne no. 2 modification multiple wheel study. (1950). Ohio River Division Laboratory, U.S. Army Corps of Engineers, Mariemont, Ohio.
8.
Mellinger, F. (1963). “Structural design of concrete overlays.” J. Am. Concr. Inst., 60(2), 225–237.
9.
Mellinger, F. M., and Carlton, P. F. (1955). “Application of models to design studies of concrete airfield pavements.” Proc., Highway Research Board, 34, 57–64.
10.
Pickett, G., and Ray, G. K. (1951). “Influence charts for concrete pavements.” Trans., ASCE, 116, 49–73.
11.
Rollings, R. S. (1988a). “Design and construction of roller compacted concrete pavements.” 14th Australian Road Research Board Conf., Australian Road Research Board, Vermont South, Victoria, Australia, 454–466.
12.
Rollings, R. S. (1988b). “Design of overlays for rigid airport pavements.” DOT/FAA/PM‐87/19, Federal Aviation Administration, Washington, D.C.
13.
Rollings, R. S. (1986), “Field performance of fiber reinforced concrete airfield pavements.” DOT/FAA/PM‐86/26, Federal Aviation Administration, Washington, D.C.
14.
Rollings, R. S. (1981). “Corps of engineers design procedures for rigid airfield pavement.” 2nd Int. Conf. on Concrete Pavement Design, Purdue University, West Lafayette, Ind., 185–198.
15.
Sale, J., and Hutchinson, R. (1959). “Development of rigid pavement design criteria for military airfields.” J. Air Transp. Div., ASCE, 85(3), 129–151.
16.
“Small scale model study to determine minimum horizontal dimensions for ‘infinite’ slab behavior.” Tech. Report No. 4‐32, Ohio River Division Laboratory, U.S. Army Corps of Engineers, Cincinnati, Ohio.
17.
Westergaard, H. M. (1948). “New formulas for stresses in concrete pavements of airfields.” Trans., ASCE, 113, 435–444.
18.
Westergaard, H. M. (1926a). “Stresses in concrete pavements computed by theoretical analyses.” Public Roads, 7(2), 25–35.
19.
Westergaard, H. M. (1926b). “Analysis of stresses in concrete pavements due to variations of temperature.” Proc., Highway Research Board, 201–215.
Information & Authors
Information
Published In
Copyright
Copyright © 1992 ASCE.
History
Published online: May 1, 1992
Published in print: May 1992
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.