Seismic Design Forces. I: Rigid Nonstructural Components
Publication: Journal of Structural Engineering
Volume 132, Issue 10
Abstract
The paper examines the seismic design force formulas that are currently prescribed in the 2003 NEHRP Provision for the design of nonstructural components in buildings, and presents new formulas to improve the these recommendations. The current code provisions are building independent and overly conservative, especially for the design of nonstructural components in tall buildings. This conservatism can be reduced by utilizing the information about the fundamental period of the building. New force formulas that depend on the building period are proposed. The proposed formulas are intended to avoid more involved analyses. They are validated by a comprehensive numerical study of several buildings of different periods analyzed for an ensemble of recorded earthquake acceleration time histories.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was sponsored by Multidisciplinary Center for Earthquake Engineering Research at the State University of New York, Buffalo through a grant with National Science Foundation. This support is gratefully acknowledged. Discussions and encouragement by T. T. Soong of the State University of New York when he was the group leader of this project at MCEER are also greatly appreciated. The technical assistance provided by Saurabh S. Bisht and Rildova of the Department of Engineering Science and Mechanics at Virginia Tech in the preparation of the paper is also appreciated.
References
Applied Technology Council (ATC). (1978). “Tentative provisions for the development of seismic regulations for buildings.” ATC Rep. No. 3-06, Palo Alto, Calif.
ASCE. (2003). “Minimum design loads for buildings and other structures.” SEI/ASCE 7-02, Reston, Va.
Blume, J. A., Newmark, N. M., and Corning, L. H. (1961). “Design of multistory reinforced concrete buildings for earthquake motions.” Portland Cement Association, Skokie, Ill.
Building Seismic Safety Council (BSSC). (1986). “NEHRP recommended provisions for the development of seismic regulations for new buildings.” 1985 Ed., FEMA-95, Federal Emergency Management Agency, Washington, D.C.
Building Seismic Safety Council (BSSC). (1995). NEHRP recommended provisions for the development of seismic regulations for new buildings, 1994 Ed., FEMA-222A, Federal Emergency Management Agency, Washington, D.C.
Building Seismic Safety Council (BSSC). (1998). NEHRP recommended provisions for the development of seismic regulations for new buildings, 1997 Ed., Part 1: Provisions, FEMA 302, Federal Emergency Management Agency, Washington, D.C.
Building Seismic Safety Council (BSSC). (2003). NEHRP recommended provisions for the development of seismic regulations for new buildings, 2003 Ed., Parts 1 and 2, FEMA 450, Federal Emergency Management Agency, Washington, D.C.
Drake, R. M., and Bachman, R. E. (1995). “A study to validate the in-structure response accelerations in the 1994 NEHRP provisions design force equations for architectural, mechanical, and electrical components.” National Center for Earthquake Engineering Research, Buffalo, N.Y.
Drake, R. M., and Bachman, R. E. (1996). “NEHRP provisions for 1994 for nonstructural components.” J. Archit. Eng., 2(1), 26–31.
Goel, R. K., and Chopra, A. K. (1997). “Period formulas for moment-resistant frame buildings.” J. Struct. Eng., 123(11), 1454–1461.
Goel, R. K., and Chopra, A. K. (1998). “Period formulas for concrete shear wall buildings.” J. Struct. Eng., 124(4), 426–433.
International Code Council (ICC). (2003). International building code, Whittier, Calif.
Miranda, E., and Taghavi, S. (2005). “Approximate floor acceleration demands in multistory buildings. I: Formulation.” J. Struct. Eng.,131(2), 203–211.
Singh, M. P., and Maldonado, G. O. (1991). “An improved response spectrum method for calculating seismic design response. Part 1: Classically damped structures.” Earthquake Eng. Struct. Dyn., 20, 621–635.
Singh, M. P., Moreschi, L. M., and Suarez, L. E. (1998). “Simplified methods for calculating seismic forces for nonstructural components.” Proc., ATC-29-1 Seminar on Seismic Design, Retrofit and Performance of Nonstructural Components, San Francisco.
Singh, M. P., Moreschi, L. M., Suarez, L. E., and Matheu, E. E. (2005). “Seismic design forces. II: Flexible nonstructural components.” J. Struct. Eng., 132(10), 1533–1542.
Soong, T. T., Chen, G., Wu, Z., Zhang, R. H., and Grigoriu, M. (1993). “Assessment of the 1991 NEHRP provisions for nonstructural components and recommended revisions.” Technical Rep. No. NCEER-93-0003, National Center for Earthquake Engineering Research, State Univ. of New York, Buffalo, N.Y.
Taghavi, S., and Miranda, E. (2005). “Approximate floor acceleration demands in multistory buildings. II: Applications.” J. Struct. Eng., 131(2), 212–220.
Villaverde, R. (1997). “Seismic design of secondary structures: State of the art.” J. Struct. Eng., 123(8), 1011–1019.
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: May 10, 2005
Accepted: Dec 5, 2005
Published online: Oct 1, 2006
Published in print: Oct 2006
Notes
Note. Associate Editor: Reginald DesRoches
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.