Evaluation of Drift Demands for the Seismic Performance Assessment of Frames
Publication: Journal of Structural Engineering
Volume 131, Issue 7
Abstract
This study presents an evaluation of drift demands and their associated uncertainties for nondeteriorating regular moment resisting frame structures subjected to ordinary ground motions (i.e., without near-fault effects). The only source of uncertainty considered is the uncertainty due to differences in the frequency content of the ground motions. The information presented in this study is deemed to be useful for preliminary design and seismic performance assessment in which the performance targets of interest are those related to damage and loss of function (downtime). Thus, the focus is on ductility levels that are not so large that they cause significant cyclic deterioration in the components of the structural system. The dependence of drift demands (the maximum roof drift, the average of maximum story drifts, and the maximum story drift over the height) on relative ground motion intensity, fundamental period, and number of stories is investigated.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The study on which this paper is based has been funded by the NSF sponsored Pacific Earthquake Engineering Research (PEER) Center. This financial support is gratefully acknowledged.
References
Aydinoglu, M. N. (2001). “Inelastic seismic response analysis based on story pushover curves including P-delta effects.” Rep. No. 2001/1, KOERI, Dept. of Earthquake Engineering, Bogazici Univ., Istanbul, Turkey.
Bernal, D. (1987). “Amplification factors for inelastic dynamic P-delta effects in earthquake analysis.” Earthquake Eng. Struct. Dyn., 15(5), 635–651.
Chopra, A. K., Goel, R. K., and Chintanapakdee, C. (2003). “Statistics of single-degree-of-freedom estimate of displacement for pushover analysis of buildings.” J. Struct. Eng., 129(4), 459–469.
Fajfar, P. (2000). “A nonlinear analysis method for performance-based seismic design.” Earthquake Spectra, 16(3), 573–592.
Federal Emergency Management Agency (FEMA). (2000a). “Prestandard and commentary for the seismic rehabilitation of buildings.” FEMA 356, Federal Emergency Management Agency, Washington, D.C.
Federal Emergency Management Agency (FEMA). (2000b). “NEHRP recommended provisions for seismic regulations for new buildings and other structures.” FEMA 368, Federal Emergency Management Agency, Washington, D.C.
Gupta, A., and Krawinkler, H. (1999). “Seismic demands for performance evaluation of steel moment resisting frame structures.” Rep. No. 132, John A. Blume Earthquake Engineering Center, Dept. of Civil Engineering, Stanford Univ., Stanford, Calif.
Gupta, A., and Krawinkler, H. (2000). “Dynamic P-delta effects for flexible inelastic steel structures.” J. Struct. Eng., 126(1), 145–154.
Ibarra, L. F. (2003). “Global collapse of frame structures under seismic excitations.” PhD dissertation, Dept. of Civil and Environmental Engineering, Stanford Univ., Stanford, Calif.
Krawinkler, H., Medina, R., and Alavi, B. (2003). “Seismic drift and ductility demands and their dependence on ground motions.” Eng. Struct., 25(5), 637–653.
Krawinkler, H., and Miranda, E. (2004). “Chap. 9: Performance-based earthquake engineering.” Earthquake engineering: From engineering seismology to performance-based engineering, CRC Press, Boca Raton, Fla.
Medina, R. A., and Krawinkler, H. (2004). “Seismic demands for nondeteriorating frame structures and their dependence on ground motions,” PEER Rep. No. 2003/15, Pacific Earthquake Engineering Research Center, Univ. of California, Berkeley, Calif.
Miranda, E. (1999). “Approximate seismic lateral deformation demands in multistory buildings.” J. Struct. Eng., 125(4), 417–425.
Prakash, V., Powell, G. H., and Campbell, S. (1993). “DRAIN-2DX: Basic program description and user guide.” Rep. No. UCB/SEMM-93/17, Univ. of California, Berkeley, Calif.
Seneviratna, G. D. P. K., and Krawinkler, H. (1997). “Evaluation of inelastic MDOF effects for seismic design.” Rep. No. 120, John A. Blume Earthquake Engineering Center, Dept. of Civil Engineering, Stanford Univ., Stanford, Calif.
Somerville, P., Smith, N., Graves, R., and Abrahamson, N. (1997). “Modification of empirical strong ground motion attenuation relations to include the amplitude and duration effects of rupture directivity.” Seismol. Res. Lett., 68, 180–203.
Teran-Gilmore, A. (2004). “On the use of spectra to establish damage control in regular frames,” Earthquake Spectra, 20(3) 995–1020.
Vamvatsikos, D., and Cornell, C. A. (2002). “Incremental dynamic analysis.” Earthquake Eng. Struct. Dyn., 31(3), 491–514.
Whittaker, A., Constantinou, M., and Tsopelas, P. (1998). “Displacement estimates for performance-based seismic design.” J. Struct. Eng., 124(8), 905–912.
Information & Authors
Information
Published In
Copyright
© 2005 ASCE.
History
Received: Jan 13, 2004
Accepted: Jul 15, 2004
Published online: Jul 1, 2005
Published in print: Jul 2005
Notes
Note. Associate Editor: Rakesh K. Goel
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.