Probabilistic Descriptions of Wind Effects and Wind-Load Factors for Database-Assisted Design
Publication: Journal of Structural Engineering
Volume 131, Issue 3
Abstract
Database-assisted design (DAD) for wind results in structures with reduced material consumption and failure risks, i.e., in improved safety and sustainability. The paper presents a DAD-compatible probabilistic procedure for estimating: (1) Wind effects corresponding to any mean recurrence interval of the wind speeds, and (2) wind-load factors. Unlike the ASCE 7 Standard and earlier structural reliability estimates, the procedure accounts for the inherent randomness in the estimation of peaks and for relevant wind-related knowledge uncertainties. On the basis of a selection of uncertainty parameters believed to be reasonable, it is concluded that: (1) The extreme wind speed distribution type significantly affects the estimates of the load factors. Our estimates, based on the Extreme Value Type III Reverse Weibull distribution, yield load factors consistent with values specified in the ASCE 7 Standard—in contrast to estimates published in the 1980’s. (2) The variability of the ratio between wind speeds averaged over different time intervals can significantly affect the estimated wind-load factor. (3) An increase in size of the extreme wind data set from, say, , has a marginal effect on load factor estimates. (4) For low-rise buildings in open terrain, wind-load factors are typically affected weakly by even large uncertainties with respect to terrain roughness length. Additional research on the effect of terrain roughness uncertainties for buildings in built-up terrain may require an expansion of the aerodynamic databases currently available. It is noted that consideration of uncertainties in isolation, as commonly performed by some analysts and wind tunnel operators, especially for peak effects estimation, can be misleading; for structural applications, uncertainties need to be considered collectively.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers thank Professor M. Grigoriu of Cornell University for helpful and stimulating interactions. During her work on this paper S. Diniz served as a guest researcher at the Building and Fire Research Laboratory, NIST.
References
American Society of Civil Engineers (ASCE). (1998). “Minimum Design Loads for Buildings and Other Structures.” Standard ASCE 7-98, Reston, Va.
Diniz, S. M. C., Sadek, F., and Simiu, E. (2003). “Wind speed estimation uncertainties: Effects of climatological and micrometeorological parameters.” Proc., 4th Computational Stochastic Mechanics Conf., G. Deodatis and P. Spanos, eds., pp. 169–178. Millpress Science Publishers, Rotterdam, The Netherlands.
Ellingwood, B. R., Galambos, T. V., MacGregor, J. C., and Cornell, C. A. (1980). “Development of a probability-based load criterion for American National Standard A58.” NBS Special Publication No. 577, National Bureau of Standards, Washington, D.C.
Gioffrè, M., Grigoriu, M., Kasperski, M., and Simiu, E. (2000). “Wind-induced peak bending moments in low-rise building frames.” J. Eng. Mech., 126(8), 879–881.
Heckert, N. A., Simiu, E., and Whalen, T. (1998). “Estimates of hurricane wind speeds by ‘peaks over threshold’ method.” J. Struct. Eng., 124(4), 445–449.
Holmes, J. D., and Moriarty, W. W. (1999). “Application of the generalized Pareto distribution to extreme value analysis in wind engineering.” J. Wind. Eng. Ind. Aerodyn., 83, 1–10.
Lin, J., and Surry, D. (1997). “Simultaneous time series of pressures on the envelope of two large low-rise buildings.” BLWT-SS7-1997, Boundary Layer Wind Tunnel Laboratory, Univ. of Western Ontario, London, Ontario, Canada.
Minciarelli, F., Gioffrè, M., Grigoriu, M., and Simiu, E. (2001). “Estimates of extreme wind effects and wind-load factors: Influence of knowledge uncertainties.” Probab. Eng. Mech., 16, 331–340.
Sadek, F., and Simiu, E. (2002). “Peak non-Gaussian wind effects for database-assisted low-rise building design.” J. Eng. Mech., 128(5), 530–539.
Sadek, F., Diniz, S. M. C., Kasperski, M., Gioffrè, M., and Simiu, E. (2004). “Sampling errors in the estimation of peak wind-induced internal forces.” J. Eng. Mech., 130(2), 235–239.
Simiu, E., and Heckert, N. A. (1996). “Extreme wind distribution tails: A ‘peaks over threshold’ approach.” J. Struct. Eng., 122(5), 539–547.
Simiu, E., Heckert, N. A., and Whalen, T. M. (1996). “Estimates of hurricane wind speeds by the ‘peaks over threshold’ method.” NIST Technical Note 1416, U.S. Department of Commerce, National Institute of Standards and Technology, Gaithersburg, Md.
Simiu, E., and Scanlan, R. H. (1996). Wind effects on structures, Wiley, New York.
Whalen, T. M., Shah, V., and Yang, J.-S. (2000). “A pilot project for computer-based design of low-rise buildings for wind loads—The WiLDE-LRS user’s manual.” NIST∕TTU∕Purdue Univ. Contractor Report, National Institute of Standards and Technology, Gaithersburg, Md.
Whalen, T., Simiu, E., Harris, G., Lin, L., and Surry, D. (1998). “The use of aerodynamic databases for the effective estimation of wind effects in main wind-force resisting systems: Application to low buildings.” J. Wind. Eng. Ind. Aerodyn., 77–78, 685–693.
Whalen, T., Sadek, F., and Simiu, E. (2002). “Database-assisted design for wind: Basic concepts and software development.” J. Wind. Eng. Ind. Aerodyn., 90, 1349–1368.
Information & Authors
Information
Published In
Copyright
© 2005 ASCE.
History
Received: Nov 20, 2002
Accepted: Sep 24, 2004
Published online: Mar 1, 2005
Published in print: Mar 2005
Notes
Note. Associate Editor: Sashi K. Kunnath
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.