Finite-Element Bond-Slip Model for Concrete Columns under Cyclic Loads
Publication: Journal of Structural Engineering
Volume 128, Issue 12
Abstract
The hysteretic behavior of reinforced concrete structures depends in large measure on the transfer mechanism between reinforcing steel and concrete through bond and the resulting slip. This paper presents a finite-element model developed to investigate the response of reinforced concrete columns subjected to cyclic loading, considering in an explicit way the relative displacement at the interface. The novel aspect of the model is its capability of modeling three-dimensional effects as concrete confinement, the softening response of concrete, and to take into account the gradual deterioration of the bond between reinforcing bars and concrete. Numerical results are compared to experimental results on rectangular bridge columns with lapped starter bars subjected to cyclic loading. The numerical model reproduces the physical phenomena observed experimentally, as the gradual stress transfer from one bar to the other. The numerical results show the effect of damage in concrete on the steel stress distribution, as long as the coupled effect of damage in concrete and bond-slip constitutive law on the general behavior of the structural element.
Get full access to this article
View all available purchase options and get full access to this article.
References
American Concrete Institute (ACI) Committee 446. (1991). “Fracture mechanics of concrete: Concepts, models and determination of material fracture properties.” ACI 446.1R-91, Detroit.
Bouzaiene, A. H. (1995). “Caractérisation et modélisation du comportement non linéaire d’éléments en béton armé et non armé sous sollicitations multiaxiales.” PhD thesis, École Polytechnique de Montréal, Quebec (in French).
Chai, Y. H., Priestley, M. J. N., and Seible, F.(1991). “Seismic retrofit of circular bridge columns for enhanced flexural performance.” ACI J., 88(5), 572–584.
Darwin, D., and Pecknold, D. A.(1977). “Nonlinear biaxial stress-strain law for concrete.” J. Eng. Mech., 103(2), 229–241.
Desjardins, R., and Fafard, M. (1992). “Développement d’un logiciel pour l’analyse des structures par éléments finis utilisant l’approche de la programmation orientée objets.” Rep. No. GCT-92-05, Dept. of Civil Engineering, Université Laval, Quebec.
Eligehausen, R., Popov, E. P., and Bertero, V. V. (1983). “Local bond stress-slip relationships of deformed bars under generalized excitations.” Rep. No. UCB/EERC-83/23, Earthquake Engineering Research Center, Univ. of California, Berkeley, Calif.
Girard, C. (2000). “Modélisation de colonnes de pont en béton armé sous sollicitations cycliques.” PhD thesis, Dept. of Civil Engineering, Université Laval, Quebec (in French).
Lukose, K., Gergely, P., and White, R. N.(1982). “Behavior of reinforced concrete lapped splices for inelastic cyclic loading.” ACI J., 79(5), 355–365.
Lutz, L. A., and Gergely, P.(1967). “Mechanics of bond and slip of deformed bars in concrete.” ACI J., 64(11), 711–721.
Massicotte, B., Bouzaiene, A. H., and Loulou, R. (1996). “Analyse par éléments finis du comportement en service et à l’ultime d’un pont en béton armé.” Rep. No. EPM/GCS-1996-08, Dept. of Civil Engineering, École Polytechnique de Montréal, Quebec (in French).
Mirza, S. M., and Houde, J.(1979). “Study of bond stress-slip relationships in reinforced concrete.” ACI J., 76(2), 19–46.
Monti, G., Filippou, F., and Spacone, E.(1997). “Finite element for anchored bars under cyclic load reversals.” J. Struct. Eng., 123(5), 614–623.
Ngo, D., and Scordelis, A. C.(1967). “Finite element analysis of reinforced concrete beams.” ACI J., 64, 152–163.
Okamura, H., and Kim, I. H.(2000). “Seismic performance check and size effect FEM analysis of reinforced concrete.” Eng. Fract. Mech., 65(2), 369–389.
Pochanart, S., and Harmon, T.(1989). “Bond-slip model for generalized excitations including fatigue.” ACI Mater. J., 86(5), 465–474.
Priestley, M. J. N., Seible F., and Calvi, G. M. (1996). Seismic design and retrofit of bridges, Wiley, New York.
Salençon, J. (1988). Mécanique des milieux continus. Tome II: Élasticité-Milieux curvilignes. Ellipses, Paris (in French).
Sivakumar, B., Gergely, P., and White, R. N.(1983). “Suggestions for the design of R/C lapped splices for seismic loading.” Concr. Int.: Des. Constr., 5(2), 46–50.
Sun, Z., Seible, F., and Priestley, M. J. N. (1993a). “Flexural retrofit of rectangular reinforced concrete bridge columns by steel jacketing. Experimental studies.” Rep. No. SSRP-93/01, Dept. of Applied Mechanics and Engineering Sciences, Univ. of California, San Diego.
Sun, Z., Seible, F., and Priestley, M. J. N. (1993b). “Diagnostics and retrofit of rectangular bridge columns for seismic loads. Theoretical studies.” Rep. No. SSRP-93/07, Dept. of Applied Mechanics and Engineering Sciences, Univ. of California, San Diego.
Tassios, T. P., and Yannapoulos, P. J.(1981). “Études analytiques sur l’adhérence acier-béton et la fissuration du béton armé sous charges cycliques.” Annales de l’Institut technique du ba⁁timent et des travaux publics,393, 46–62 (in French).
Ulm, F.-J. (1994). “Un modèle d’endommagement plastique: application aux bétons de structure.” PhD thesis, École Nationale des Ponts et Chaussées, Paris (in French).
Vecchio, F. J.(2000). “Disturbed stress field model for reinforced concrete: Formulation.” J. Struct. Eng., 126(9), 1070–1077.
Willam, K. J., and Warnke, E. P. (1975). “Constitutive model for triaxial behavior of concrete.” IABSE Seminar on Concrete Structures Subjected to Triaxial Stresses, 19, Bergamo, Italy.
Information & Authors
Information
Published In
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Oct 31, 2000
Accepted: Apr 9, 2002
Published online: Nov 15, 2002
Published in print: Dec 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.