Estimation of Inelastic Deformation Demands of SDOF Systems
Publication: Journal of Structural Engineering
Volume 127, Issue 9
Abstract
Two recently proposed and closely related approximate methods to estimate the maximum lateral inelastic deformations demands of single-degree-of-freedom (SDOF) systems subjected to earthquake ground motions are investigated. In both methods, maximum inelastic displacements are estimated from maximum elastic displacements through the use of parameters that relate the response of elastic and inelastic SDOF systems. In the first method, the maximum inelastic displacement is estimated from the maximum elastic displacement through mean strength reduction factors derived from statistical studies. In the second method, the maximum inelastic displacement is estimated from the maximum elastic displacement through inelastic displacement ratios also derived from statistical studies. It is shown that the first method is actually a first-order approximation of the second method and that only in the absence of variability the two methods provide the same result. Furthermore, it is shown that the systematic error introduced by the first method leads to underestimations of maximum inelastic displacement demands. The error is evaluated and examples using results from statistical results of the seismic response of SDOF systems are presented.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Applied Technology Council (ATC). ( 1996). “Seismic evaluation and retrofit of concrete buildings.” Rep. ATC-40, Redwood City, Calif.
2.
Báez, J. I., and Miranda, E. ( 2000). “Amplification factors to estimate inelastic displacement demands for the design of structures in the near field.” Proc., 12th World Conf. on Earthquake Engrg.
3.
Benjamin, J. R., and Cornell, C. A. ( 1970). Probability, statistics, and decision for civil engineers, McGraw-Hill, New York.
4.
Bertero, V. V. ( 1995). “Tri-services manual methods.” Vision 2000 performance based seismic engineering of buildings, Structural Engineers Association of California, Vol. 1, Part 2, Appendix J, J1–J8.
5.
Bertero, V. V., Anderson, J. C., Krawinkler, H., and Miranda, E. ( 1991). “Design guidelines for ductility and drift limits.” Rep. No. EERC/UCB-91/15, Earthquake Engrg. Res. Ctr., University of California, Berkeley, Berkeley, Calif.
6.
Chopra, A. K., and Goel, R. K. ( 1999). “Capacity-demand-diagram methods based on inelastic design spectrum.” Earthquake Spectra, 15(4), 637–656.
7.
Chopra, A. K., and Goel, R. K. (2000). “Evaluation of NSP to estimate seismic deformation: SDF systems.”J. Struct. Engrg., ASCE, 126(4), 482–490.
8.
Fajfar, P. ( 1999). “Capacity spectrum method based on inelastic demand spectra.” Earthquake Engrg. and Struct. Dyn., 28(9), 979–993.
9.
Fajfar, P. ( 2000). “A nonlinear analysis method for performance-based seismic design.” Earthquake Spectra, 16(3), pp. 573–592.
10.
Federal Emergency Management Agency (FEMA). ( 1997a). “NEHRP guidelines for the seismic rehabilitation of buildings.” Rep. FEMA 273 (Guidelines) and Rep. 274 (Commentary), Washington, D.C.
11.
Federal Emergency Management Agency (FEMA). ( 1997b). “NEHRP recommended provisions for seismic regulations for new buildings and other structures.” Rep. FEMA 302 (Provisions) and Rep. 303 (Commentary), Washington, D.C.
12.
Freeman, S. A. ( 1998). “Development and use of the capacity spectrum method.” Proc., 6th U.S. Nat. Conf. Earthquake Engrg., Earthquake Engineering Research Institute, Oakland, Calif. (on CD-ROM).
13.
Freeman, S. A., Nicoletti, J. P., and Tyrell, J. V. ( 1975). Evaluations of existing buildings for seismic risk—A case study of Puget Sound Naval Shipyard.” Proc., 1st U.S. Nat. Conf. Earthquake Engrg., Earthquake Engineering Research Institute, Berkeley, Calif.
14.
International Conference of Building Officials (ICBO). ( 1997). Uniform building code, Whittier, Calif.
15.
Krawinkler, H. ( 1995). “New trends in seismic design methodology.” Proc., 10th Eur.-Conf. Earthquake Engrg., Vol. 2, Balkema, Rotterdam, The Netherlands, 821–830.
16.
Krawinkler, H., and Nassar, A. A. ( 1992). “Seismic based design on ductility and cumulative damage demands and capacities.” Nonlinear seismic analysis and design of reinforced concrete buildings, P. Fajfar and H. Krawinkler, eds., Elsevier Science, New York.
17.
Miranda, E. ( 1991). “Seismic evaluation and upgrading of existing buildings.” PhD thesis, University of California, Berkeley, Berkeley, Calif.
18.
Miranda, E. (1993). “Site-dependent strength-reduction factors.”J. Struct. Engrg., ASCE, 119(12), 3503–3519.
19.
Miranda, E. (2000). “Inelastic displacement ratios for structures on firm sites.”J. Struct. Engrg., ASCE, 126(10), 1150–1159.
20.
Miranda, E., and Bertero, V. V. ( 1994). “Evaluation of strength reduction factors for earthquake resistant design.” Earthquake Spectra, 10(2), 357–379.
21.
Moehle, J. P. ( 1992). “Displacement-based design of RC structures subjected to earthquakes.” Earthquake Spectra, 8(3), 403–428.
22.
Priestley, M. J. N. ( 1996). “Displacement-based seismic assessment of existing reinforced concrete buildings.” Bull. New Zealand Nat. Soc. for Earthquake Engrg., Waikanae, New Zealand, 29(4), 256–272.
23.
Reinhorn, A. M. ( 1997). “Inelastic analysis techniques in seismic evaluations.” Seismic design methodologies for the next generation of codes, P. Fajfar and H. Krawinkler, eds., Balkema, Rotterdam, The Netherlands, 277–287.
24.
Seneviratna, G. D. P. K., and Krawinkler, H. ( 1997). “Evaluation of inelastic MDOF effects for seismic design.” Rep. No. 120, The John A. Blume Earthquake Engrg. Ctr., Stanford University, Stanford, Calif.
25.
Vidic, T., Fajfar, P., and Fischinger, M. ( 1994). “Consistent inelastic design spectra: Strength and displacement.” Earthquake Engrg. and Struct. Dyn., 23(5), 507–521.
Information & Authors
Information
Published In
History
Received: Sep 26, 2000
Published online: Sep 1, 2001
Published in print: Sep 2001
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.