Three-Dimensional Inelastic Response of an RC Building during the Northridge Earthquake
Publication: Journal of Structural Engineering
Volume 127, Issue 5
Abstract
The three-dimensional inelastic earthquake response of a seven-story reinforced-concrete building during the 1994 Northridge earthquake is studied herein. The objectives of this investigation are as follows: (1) to understand the inelastic behavior of the building using recorded motions; and (2) to propose a simplified inelastic model that could explain the lateral-torsional coupling observed in this nominally symmetric building. Because several two-dimensional inelastic models of the building have been reported by other researchers, this paper focuses on the three-dimensional behavior of the structure. Response results of a simplified inelastic stick model that uses the story-shear and torque surfaces are compared with the results obtained from a conventional elastic three-dimensional building model. These results suggest that damage in the building occurred in the first few cycles of the response, and that the building showed markedly inelastic torsional behavior in spite of its nominal symmetry in plan. Such torsional behavior could also occur in other symmetric-plan buildings with strong perimeter frames, and constitutes a rather new phenomenon that should be studied further. It is proposed herein that such behavior be foreseen in design by using the concept of the ultimate story-shear and torque surface.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
American Concrete Institute (ACI). ( 1985). “Building code requirements for structural concrete.” ACI 318-95, Detroit.
2.
De la Llera, J. C., and Chopra, A. K. ( 1997). “Evaluating seismic code provisions using strong motion building records from the 1994 Northridge earthquake.” EERC Rep. UCB/EERC-97/16, Earthquake Engineering Research Center, University of California, Berkeley.
3.
Islam, M. S. ( 1996). “Analysis of the Northridge earthquake response of a damaged non-ductile concrete frame building.” The structural design of tall buildings, Vol. 5, 151–182.
4.
John A. Blume and Associates. ( 1973). “San Fernando, California, earthquake of February 9, 1971—Holiday Inn (29).” Rep. of the U.S. Dept. of Commerce, National Oceanic and Atmospheric Administration, Washington, D.C., 1, Part A, 359–393.
5.
Juang, J-N. ( 1994). Applied system identification, Prentice-Hall, Englewood Cliffs, N.J.
6.
Loh, C. H., and Lin, H. M. ( 1996). “Applications of off-line and on-line identification techniques to building seismic response data.” Earthquake Engrg. and Struct. Dyn., 25(3), 269–290.
7.
Lynn, A., Moehle, J., Holmes, W., and Mahin, S. ( 1996). “Seismic evaluation of existing RC building columns.” Earthquake Spectra, 12(4), 715–739.
8.
MATLAB reference guide. (1997). The Mathworks, Natick, Mass.
9.
Moehle, J., Browning, J., Li, Y. R., and Lynn, A. ( 1997). “Performance assessment for a reinforced concrete frame building.” Preprints, Workshop on Seismic Des. Methodologies for the Next Generation of Codes, Bled, Slovenia.
Information & Authors
Information
Published In
History
Received: Jan 28, 1998
Published online: May 1, 2001
Published in print: May 2001
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.