Internal Pressures and Cladding Net Wind Loads on Full-Scale Low-Rise Building
Publication: Journal of Structural Engineering
Volume 126, Issue 4
Abstract
Wind-induced internal pressures have been measured at the Wind Engineering Research Field Laboratory full-scale low-rise test building at Texas Tech University, Lubbock, Tex., and compared with theoretical analysis. The pressure inside the building was controlled by the external pressure distribution, position and size of openings, volume of the building, and the flexibility of the envelope. The mean and fluctuating internal pressures in the nominally sealed building were smaller than the pressures on the external surfaces, and they increase with increasing windward/leeward open area ratio. Internal pressure resonance occurs close to the Helmholtz frequency in the building with a dominant opening. Effects of the flexibility of the envelope on the internal pressure fluctuations were accounted for by increasing the volume of the building by a factor of the bulk modulus of air KA to the bulk modulus of the building KB. External pressures on selected parts of the building and measured internal pressures were combined to study the characteristics of the net pressures acting on cladding elements, and they were compared with data derived from the AS1170.2 wind load standard. AS1170.2 generally provides satisfactory net pressure estimates for design of cladding on a nominally sealed building but can underestimate net cladding design pressures on some small tributary areas of a building with a dominant windward wall opening.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
“Australian Standard SAA loading code. Part 2, Wind Loads.” (1989). AS1170.2, Standards Australia.
2.
Ginger, J. D., and Letchford, C. W. (1999). “Net pressure on a low-rise full scale building.” J. Wind Engrg. and Industrial Aerodyn., accepted for publication.
3.
Ginger, J. D., Mehta, K. C., and Yeatts, B. B. (1997). “Internal pressures in a low-rise full scale building.” J. Wind Engrg. and Industrial Aerodyn., 72, 163–174.
4.
Ginger, J. D., Yeatts, B. B., and Mehta, K. C. (1995). “Internal pressures in a low-rise full scale building.” Proc., 9th Int. Conf. on Wind Engrg., Retrospect and Prospect, Vol. 1, 512–523.
5.
Harris, R. I. (1990). “The propagation of internal pressures in buildings.” J. Wind Engrg. and Industrial Aerodyn., 34, 169–184.
6.
Holmes, J. D. (1979). “Mean and fluctuating internal pressures induced by wind.” Proc., 5th Int. Conf. on Wind Engrg., Vol. 1, 435–450.
7.
Holmes, J. D. ( 1981). “Wind loads on low-rise buildings.” Course Notes on The structural and environmental effects of wind on buildings and structures—Chapter 12, Facu. of Engrg., Monash University.
8.
Kawai, H. (1983). “Pressure fluctuations on square prisms—Applicability of strip and quasi-steady theory.” J. Wind Engrg. and Industrial Aerodyn., 13, 197–208.
9.
Kramer, C., Gerhardt, H. J., and Scherer, S. (1979). “Wind pressure on block type buildings.” J. Industrial Aerodyn., 4, 229–242.
10.
Levitan, M. L., and Mehta, K. C. (1992a). “Texas Tech field experiments for wind loads. Part I. Building and pressure measurement system.” J. Wind Engrg. and Industrial Aerodyn., 43, 1565–1588.
11.
Levitan, M. L., and Mehta, K. C. (1992b). “Texas Tech field experiments for wind loads. Part II: Meteorological instrumentation and terrain parameters.” J. Wind Engrg. and Industrial Aerodyn., 43, 1565–1588.
12.
Liu, H. (1978). “Building code requirements on internal pressure.” Proc., 3rd U.S. Conf. of Wind Engrg. Res., VI–7.
13.
Liu, H., and Rhee, K. H. (1986). “Helmholtz oscillation in building models.” J. Wind Engrg. and Industrial Aerodyn., 24, 95–115.
14.
Liu, H., and Saathoff, P. J. (1981). “Building internal pressure: Sudden change.”J. Engrg. Mech. Div., ASCE, 107(12), 309–321.
15.
“Minimum design loads for buildings and other structures.” (1995). ASCE 7-95, ASCE, New York.
16.
Stathopoulos, T., Surry, D., and Davenport, A. G. (1979). Internal pressure characteristics of low-rise buildings due to wind action.” Proc., 5th Int. Conf. on Wind Engrg., Vol. 1, 451–463.
17.
Vickery, B. J. (1986). “Gust factors for internal pressures in low-rise buildings.” J. Wind Engrg. and Industrial Aerodyn., 23, 259–271.
18.
Vickery, B. J. (1991). “Comments on `The propagation of internal pressure in buildings' by R. I. Harris.” J. Wind Engrg. and Industrial Aerodyn., 37, 209–212.
19.
Vickery, B. J. (1994). “Internal pressures and interactions with the building envelope.” J. Wind Engrg. and Industrial Aerodyn., 53, 125–144.
20.
Vickery, B. J., and Bloxham, C. (1992). “Internal pressure dynamics with a dominant opening.” J. Wind Engrg. and Industrial Aerodyn., 41, 193–204.
21.
Yeatts, B. B., and Mehta, K. C. (1993). “Field experiments for building aerodynamics.” J. Wind Engrg. and Industrial Aerodyn., 50, 213–224.
Information & Authors
Information
Published In
Journal of Structural Engineering
Volume 126 • Issue 4 • April 2000
Pages: 538 - 543
History
Received: Nov 17, 1998
Published online: Apr 1, 2000
Published in print: Apr 2000
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.