Performance of New Sandwich Tube under Axial Loading: Experiment
Publication: Journal of Structural Engineering
Volume 121, Issue 12
Abstract
The strength of steel tubes used in offshore construction is often limited by local and global stability considerations. We propose a new composite tube, which consists of two concentric steel tubes with polymer concrete sandwiched in between them. The increase in section modulus will enhance the global stability in long tube applications. The interaction of the three components of the composite tube will have a positive impact on the local stability of the tube. This study concentrates on the local stability issue and quantifies the strength and ductility enhancement due to the interaction. Twenty-six small-scale models of short composite tubes were tested under uniaxial compression and six were tested under cyclic semireversal axial loading. Test results showed that the new composite tubes generally had a compressive strength 10–30% higher than the sum of the individual components. The ductility of the composite tube was also much improved. The prediction of strength by an analytical model and an empirical formula is reported in a companion paper.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
American Petroleum Institute (API). (1989). “Draft recommended practice for planning, designing and constructing fixed offshore platforms—load and resistance factor design.”API, RP2A-LRFD, 1st Ed., Washington, D.C.
2.
Batterman, S. C.(1965). “Plastic buckling of axially compressed cylindrical shells.”AIAA J., 3(2), 316–325.
3.
Bushnell, D. (1982). “Plastic buckling.”Pressure vessels and piping: design technology, S. Y. Zamrik and D. Dietrich, ed., Am. Soc. of Mech. Engrs. (ASME), New York, N.Y., 47–113.
4.
Goode, C. D., and Fatheldin, Y. T.(1980). “Sandwich cylinders (steel-concrete-steel) subjected to external pressure.”ACI J., 77(2), 109–115.
5.
Goode, C. D., and Shukry, M. E.(1988). “Effect of damage on composite cylinders subjected to external pressure.”ACI Struct. J., 85(4), 405–413.
6.
Mebarkia, S., and Vipulanandan, C. (1992). “Compressive strength and characterization of failure modes for polymer concrete.”Proc., 9th Conf. of Engrg. Mech., ASCE, New York, N.Y., 988–991.
7.
Montague, P.(1975). “A simple composite construction for cylindrical shells subjected to external pressure.”J. Mech. Engrg. Sci., 17(2), 105–112.
8.
Montague, P.(1978a). “The experimental behavior of double-skinned, composite, circular cylindrical shells under external pressure.”J. Mech. Engrg. Sci., 20(1), 21–34.
9.
Montegue, P.(1978b). “The failure of double-skinned, composite circular cylindrical shells under external pressure.”J. Mech. Engrg. Sci., 20(1), 35–48.
10.
Montegue, P. (1979). “The theoretical behavior of steel-concrete circular cylindrical shells subjected to external pressure.”Proc., Inst. of Civ. Engrg., London, England, Part 2, Vol. 67, 483–499.
11.
Montegue, P.(1986). “Composite vessels for deepwater operation: the influence of shell strength and severe damage.”Proc., Inst. of Civ. Engrs., London, England Part 2, 81(6), 191–219.
12.
Montegue, P., and Choo, Y. S. (1981). “Double-skin construction of large pressure vessels for sub-sea systems.”Proc., Off-Shore Technol. Conf., Off-Shore Technol. Conf. (OTC) Richardson, Tex., 361–369.
13.
Nash, T., and Montegue, P. (1984). “The strength-instability interaction of double-skinned composite circular shells under external pressure.”Proc., Inst. of Mech. Engrs., London, England, Vol. 16, 293–301.
14.
Vipulanandan, C., and Paul, E.(1990). “Performance of epoxy and polyester polymer concrete.”ACI Mat. J., 87(3), 241–251.
15.
Wei, S. (1993). “Structural behavior of steel-polymer concrete-steel sandwich hollow cylinders under uniaxial compression,” PhD dissertation, Dept. of Civ. and Envir. Engrg., Univ. of Houston, Houston, Tex.
Information & Authors
Information
Published In
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: Dec 1, 1995
Published in print: Dec 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.