Tests and Ratings of Short‐Span Steel Bridges
Publication: Journal of Structural Engineering
Volume 119, Issue 7
Abstract
A series of diagnostic tests were performed on three short‐span, two‐lane, steel‐girder bridges. Tests were performed with stationary and moving test trucks placed on the bridges one at a time and side by side. Wheel‐load distribution factors were calculated from results of the stationary‐truck test, and impact factors were calculated from results of the moving‐truck test. Girder strains were calculated using the American Association of State Highway and Transportation Officials' simplified bridge analysis with the measured wheel‐load distribution factors. The calculated girder strains were consistently larger than measured values. The results illustrate some of the inaccuracies of the wheel‐load distribution‐factor approach. Impact factors are calculated by various methods. Comparisons are made between impact factors for the most critically loaded girder and impact factors determined from the combined response of all the girders. The impact factors based on the combined response of all the girders tend to be larger. Impact factors calculated from side‐by‐side truck test results tend to be larger than those calculated from single‐truck tests. Bridge ratings based on the test results are presented and discussed.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
A guide for the field testing of bridges. (1980). Working Committee on Safety of Bridges, ASCE, New York, N.Y.
2.
Bakht, B., and Csagoly, P. F. (1980). “Diagnostic testing of a bridge.” J. Struct. Div., ASCE, 106(7), 1515–1529.
3.
Bakht, B., and Jaeger, L. G. (1990). “Bridge testing—A surprise every time.” J. Struct. Engrg., ASCE, 116(5), 1370–1383.
4.
Bakht, B., and Moses, F. (1988). “Lateral distribution factors for highway bridges.” J. Struct. Engrg., ASCE, 114(8), 1785–1803.
5.
Chan, T. H. T., and O'Connor, C. (1990). “Wheel loads from highway bridge strains: Field studies.” J. Struct. Engrg., ASCE, 116(7), 1751–1771.
6.
Darlow, M. S., and Bettigole, N. H. (1989). “Instrumentation and testing of bridge rehabilitated with exodermic deck.” J. Struct. Engrg., ASCE, 115(10), 2461–2480.
7.
Ghosn, M., Moses, F., and Gogieski, J. (1986). “Structural design of bridges.” Transp. Res. Record, 1072, 71–78.
8.
Guide specifications for strength evaluation of existing steel and concrete bridges. (1989). Am. Assoc. of State Highway and Transp. Officials, Washington, D.C.
9.
Hays, C. O., Jr., Sessions, L. M., and Berry, A. J. (1986). “Structural design of bridges.” Transp. Res. Record, 1072, 6–14.
10.
Manual for maintenance inspection of bridges. (1983). Am. Assoc. of State Highway and Transp. Officials, Washington, D.C.
11.
Moses, F., Ghosn, M., and Gobieski, J. (1985). “Weigh‐in‐motion applied to bridge evaluation.” Final Report No. FHWA/OH‐85/012, Dept. of Civ. Engrg., Case Western Reserve Univ., Cleveland, Ohio.
12.
O'Connor, C., and Pritchard, R. W. (1985). “Impact studies on small composite girder bridge.” J. Struct. Engrg., ASCE, 111(3), 641–653.
13.
Pinjarkar, S. G., Guedelhoefer, O. C., Smith, B. J., and Kritzler, R. W. (1990). “Nondestructive load testing for bridge evaluation and rating.” Final Report of NCHRP Project 12‐28(13), Transp. Res. Board, Washington, D.C.
14.
Schilling, C. G. (1982). “Impact factors for fatigue design.” J. Struct. Div., ASCE, 108(9), 2034–2044.
15.
Shepard, R., and Sidwell, G. K. (1973). “Composite road bridges.” Highways and Road Constr., 41(1767), 20–25/65.
16.
Standards specifications for highway bridges. (1989). 14th Ed., Am. Assoc. of State Highway and Transp. Officials, Washington, D.C.
17.
Walker, W. H. (1987). “Lateral load distribution in multigirder bridges.” Engrg. J., 24(1), 21–28.
18.
Yoo, C. H., and Stallings, J. M. (1991). “Bridge testing.” Draft Final Report, Project Number ST 2019‐12, Highway Res. Ctr., Auburn Univ., Auburn, Ala.
Information & Authors
Information
Published In
Journal of Structural Engineering
Volume 119 • Issue 7 • July 1993
Pages: 2150 - 2168
Copyright
Copyright © 1993 American Society of Civil Engineers.
History
Received: Apr 16, 1991
Published online: Jul 1, 1993
Published in print: Jul 1993
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.