Analytical Moment‐Curvature Relations for Tied Concrete Columns
Publication: Journal of Structural Engineering
Volume 118, Issue 2
Abstract
The research reported here is a follow‐up on experimental work in which 16 12 in. (305 mm) square and 9 ft (2.74 m) long columns were tested under flexure to large inelastic deformations while simultaneously subjected to axial load that remained constant throughout the test. The main variables included the distribution of longitudinal and lateral steel, amount of lateral steel, tie spacing, and axial load level. In this paper, the predictions for the behavior of these specimens from the available stress‐strain models for confined concrete are compared with the test results. After a critical examination of the analytical models and the variables that affect the behavior of the specimens, a model originally proposed for concentric compression was modified to include the effects of strain gradient and the level of axial load. As a result of strain gradient, the concrete is able to sustain additional deformation at and beyond the peak stress. The effect of increased axial load is incorporated with reduced concrete strength. A numerical example is presented in which the use of a rectangular stress block representing the actual stress‐strain curve of concrete obtained from the confinement model is demonstrated.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
“Building code requirements for reinforced concrete.” (1989). ACI 318‐89, American Concr. Inst., Detroit, Mich.
2.
Chan, W. W. L. (1955). “The ultimate strength and deformation of plastic hinges in reinforced concrete frameworks.” Mag. Concr. Res., 7(21), 121–132.
3.
Elwi, A. A., and Murray, D. W. (1979). “A 3D hypoelastic concrete constitutive relationship.” J. Engrg. Mech. Div., ASCE, 105(4), 623–641.
4.
Fafitis, A., and Shah, S. P. (1985). “Predictions of ultimate behavior of confined concrete columns subjected to large deformations.” ACI J., 82(4), 423–433.
5.
Fafitis, A., and Shah, S. P. (1983). “Discussion of ‘A comparative study of confinement models.’” ACI J., 80(3), 261–263.
6.
Hognestad, E., Hanson, N. W., and McHenry, D. (1955). “Concrete stress distribution in ultimate strength design.” ACI J., 52(4), 455–480.
7.
Karsan, I. D., and Jirsa, J. O. (1969). “Behavior of concrete under compressive loading.” Proc., J. Struct. Div., ASCE, 95(12), 2543–2563.
8.
Kent, D. C., and Park, R. (1971). “Flexural members with confined concrete.” J. Struct. Div., ASCE, 97(7), 1969–1990.
9.
Mander, J. B., Priestley, M. J. N., and Park, R. (1988). “Theoretical stress‐strain model for confined concrete.” J. Struct. Engrg., ASCE, 114(8), 1804–1826.
10.
Park, R., Priestley, M. J. N., and Gill, W. D. (1982). “Ductility of square confined concrete columns.” J. Struct. Div., ASCE, 108(4), 929–950.
11.
Paulay, T. (1980). “Deterministic design procedure for ductile frames in seismic areas.” ACI Special Publication No. SP63: Reinforced concrete structures subjected to wind and earthquake forces, American Concrete Institute, Detroit, Mich., 357–381.
12.
Popovics, S. (1973). “A numerical approach to the complete stress‐strain curves for concrete.” Cem. Concr. Res., 3(5), 583–599.
13.
Sargin, M. (1971). “Stress‐strain relationships for concrete and the analysis of structural concrete sections.” Study No. 4, Solid Mech. Div., Univ. of Waterloo, Waterloo, Ontario, Canada.
14.
Schickert, G., and Winkler, H. (1979). Results of tests concerning strength and strain of concrete subjected to multiaxial compressive stresses. Deutscher Ausschuss fur Stahlbeton, Berlin, West Germany, Heft 277.
15.
Sheikh, S. A. (1982). “A comparative study of confinement models.” ACI J., 79(4), 296–306.
16.
Sheikh, S. A., and Uzumeri, S. M. (1982). “Analytical model for concrete confinement in tied columns.” J. Struct. Div., ASCE, 108(12), 2703–2722.
17.
Sheikh, S. A., and Yeh, C. C. (1982). “Flexural behavior of confined concrete columns.” ACI J., 83(3), 389–404.
18.
Sheikh, S. A., and Yeh, C. C. (1990). “Tied concrete columns under axial load and flexure,” J. Struct. Engrg., ASCE, 116(10), 2780–2800.
19.
Sturman, G. H., Shah, S. P., and Winter, G. (1965). “Effect of flexural strain gradient on microcracking and stress‐strain behavior of concrete.” ACI J., 62(7), 805–822.
20.
William, K. J., and Warnke, E. P. (1975). “Constitutive model for the triaxial behavior of concrete.” Proc., Int. Association for Bridge and Struct. Engrg., Int. Association for Bridge and Struct. Engrg., 19, 1–30.
21.
Yeh, C.‐C, and Sheikh, S. A. (1988). “Behavior of confined concrete columns under axial load and flexure.” Res. Report No. UHCE 88‐2, Univ. of Houston, Houston, Tex.
Information & Authors
Information
Published In
Copyright
Copyright © 1992 ASCE.
History
Published online: Feb 1, 1992
Published in print: Feb 1992
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.