Behavior of Single‐Angle‐Compression Members
Publication: Journal of Structural Engineering
Volume 117, Issue 12
Abstract
Published research indicates a lack of test results for single‐angle‐compression members with low slenderness ratio. In order to bridge this gap, 50 stocky single‐angle struts were tested as part of a truss. The test procedure and the results from these tests are given and discussed. The behavior of these members varies depending on their end connection detail, their slenderness ratio, and the width/thickness ratio of the angle leg. Six possible modes of failure were identified. The design rules for single‐angle‐compression members given in the AISC Design Specification, and the ASCE Manual 52 for the Design of Steel Transmission Towers are evaluated.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Allwarden, J. M. (1987). “Statistical strength properties for single angle struts,” thesis presented to the University of Maine, at Orono, Me., in partial fulfillment of the requirements for the degree of Master of Science.
2.
Kennedy, J. B., and Murty, M. K. S. (1972). “Buckling of steel angle and tee struts.” J. Struct. Div., ASCE, 98(11), 2507–2522.
3.
Kitipornchai, S., and Lee, H. W. (1984). “Inelastic experiments on angles and tee struts.” Res. Report No. CE54, Dept. of Civ. Engrg., Univ. of Queensland, St. Lucia, Australia.
4.
Load and resistance factor design specification for structural steel buildings. (1986). Amer. Inst. of Steel Constr.
5.
Manual52, guide for design of steel transmission towers. (1988). Second Ed., (1988). New York, N.Y.
6.
Mueller, W. H., and Erzurumlu, H. (1983). Limit state behavior of steel angle columns. Civil‐Structural Engineering Division of Engineering and Applied Science, Portland State University, Portland, Oreg.
7.
Mueller, W. H., and Wagner, A. L. (1983). Plastic behavior of steel angle columns. Civil‐Structural Engineering Division of Engineering and Applied Science, Portland State University, Portland, Oreg.
8.
“Standard methods and definitions for mechanical testing of steel products.” (1977). ANSI/ASTM A 370‐77. Amer. Society for Testing and Materials.
9.
Stang, A. H., and Strickenberg, L. R. (1922). “Results of some compression tests of structural steel angles.” Technologic Paper of the United States Bureau of Standards No. 218, Government Printing Office, Washington, D.C.
10.
Usami, T., and Galambos, T. V. (1971). “Eccentrically loaded single angle columns.” IABSE Publications, Vol. 31‐II, Zurich, Switzerland, 153–184.
11.
Wood, A. B. (1975). “Buckling tests on crossed diagonals in lattice towers.” Electra, 89–99.
12.
Yokoo, Y., Wakabayashi, M., and Nonaka, T. (1968). “An experimental study on the buckling of angles.” Yawata Tech. Report No. 265, Yawata Iron and Steel Co., Ltd., Tokyo, Japan, 8543–8563, 8759–8760.
Information & Authors
Information
Published In
Journal of Structural Engineering
Volume 117 • Issue 12 • December 1991
Pages: 3720 - 3741
Copyright
Copyright © 1991 ASCE.
History
Published online: Dec 1, 1991
Published in print: Dec 1991
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.