Shaking‐Table Study of Base Isolation for Masonry Buildings
Publication: Journal of Structural Engineering
Volume 117, Issue 11
Abstract
Results of an experimental study are presented that help illustrate the effectiveness of using base isolators for reducing the lateral‐force demand for engineered masonry building structures in areas of high seismicity. Two structures of identical configuration were each subjected to a similar series of three base motions that increased progressively in intensity. One structure was fixed to the platform of an earthquake simulator while the other was mounted on a set of four isolator pads that were attached to the simulator platform. Test structures were constructed at one‐quarter scale using model concrete blocks and annealed wire for reinforcement. Measured accelerations of the isolated structure were notably less than that of the fixed‐base structure for the same input motion. By isolating the structure, essentially no cracking occurred even for a base motion that caused significant cracking and yielding of reinforcement for the fixed‐base structure. Measured response correlated well with estimates computed on the bases of newly proposed Structural Engineers Association of California (SEAOC) design requirements for base isolated structures.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Abrams, D. P. and Paulson, T. J. “Modeling earthquake response of concrete masonry building structures.” ACI Structural J., 88(5), 475–485.
2.
Arya, A. S. (1984). “Sliding concept of mitigation of earthquake disaster to masonry buildings.” Proc. of Eighth World Conference on Earthquake Engrg, V, 951–958.
3.
Blondet, M., and Esparza, C. (1988). “Analysis of shaking table—Structure interaction effects during seismic simulation tests.” Earthquake Engrg. and Struct. Dynamics, 16(4), 473–490.
4.
Buckle, I. G., and Mayes, R. L. (1990). “Seismic isolation: History, application, and performance—A world view,” Earthquake Spectra, 6(2), 161–201.
5.
Dooley, C. T., and Robison, R. (1990). “Seismic surgery,” Civ. Engrg., ASCE, 60(9), 72–75.
6.
General requirements for the design and construction of seismic‐isolated structures. (1989) October. Ad Hoc Base Isolation Subcommittee of the Seismology Committee, Struct. Engrs. Assoc. of California.
7.
Li, L. (1984). “Base isolation measure for aseismic buildings in China.” Proc. of Eighth World Conference on Earthquake Engrg., VI, 791–798.
8.
Li, Z., Rossow, E. C., and Shah, S. P. (1989) “Forced vibration of base‐isolated masonry system.” J. Struct. Engrg., ASCE, 115(7), 1741–1755.
9.
Mayes, R. L., Jones, L. R., and Kelly, T. E. (1990). “The economics of seismic isolation in buildings.” Earthquake Spectra, 6(2), 245–263.
10.
Qamaruddin, M., Qadeer, A., and Ali, S. (1990). “Response of masonry building with seismic base isolation.” Proc. of Fifth North American Masonry Conference, University of Illinois at Urbana‐Champaign, I, 189–200.
11.
Rasheeduzzafar, M. Q., Arya, A. S., and Chandra, B. (1986). “Seismic response of masonry buildings with sliding substructure.” J. Struct. Engrg., ASCE, 112(9), 2001–2011.
Information & Authors
Information
Published In
Copyright
Copyright © 1991 ASCE.
History
Published online: Nov 1, 1991
Published in print: Nov 1991
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.