RC Bridge Decks Under Pulsating and Moving Load
Publication: Journal of Structural Engineering
Volume 114, Issue 3
Abstract
Tests were conducted on 1/6.6‐scale reinforced‐concrete bridge deck slabs under static load, pulsating load applied at a fixed point, and moving constant wheel‐load. Both isotropic and orthotropic reinforcing arrangements were considered. The current AASHTO design approach (orthotropic reinforcement) appears to be overconservative. The moving wheel‐load results in far more damage than the fixed pulsating load, and the cracking pattern due to the former loading is segmental (gridlike) and more extensive. The failure mode for all reinforced model decks is that of punching shear and not flexure. It is concluded that the reinforcement content in a bridge deck can be reduced significantly and satisfy both serviceability and strength requirements.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
AASHTO. (1983). Standard specifications of highway bridges. 13th Ed., American Assoc. of State Highway and Transportation Officials, Washington, D.C.
2.
Beal, D. B. (1982). “Load capacity of concrete bridge decks.” J. Struct. Div., ASCE, 108(ST4), 814–832.
3.
Beim, S. (1986). “Behavior of R/C highway bridge deck slabs,” thesis presented to the Department of Civil Engineering, Case Western Reserve University, at Cleveland, Ohio, in partial fulfillment of the requirements for the degree of Master of Science.
4.
Braestrup, M. W. (1980). “Dome effect in R/C slabs: rigid‐plastic analysis.” J. Struct. Div., ASCE, 106(ST6), 1237–1253.
5.
Braestrup, M. W., and Morley, C. T. (1980). “Dome effect in R/C slabs: elastic‐plastic analysis.” J. Struct. Div., ASCE, 106(ST6), 1255–1262.
6.
Fang, I. K. (1985). “Behavior of Ontario‐type bridge decks on steel girders,” thesis presented to the Department of Civil Engineering, The University of Texas at Austin, Austin, Tex., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
7.
Gvozdev, A. A. (1960). “The determination of the value of the collapse load for statically indeterminate systems undergoing plastic deformation.” Int. J. Mech. Sci., 1, 322–335.
8.
Hewitt, B. E. (1972). “An investigation of the punching shear strength of restrained slabs with particular reference to the deck slabs of composite I‐beam bridges,” thesis presented to the Department of Civil Engineering, Queens University, at Kingston, Ontario, Canada, in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
9.
Hewitt, B. E., and Batchelor, B. deV. (1975). “Punching shear strength of restrained slabs.” J. Struct. Div., ASCE, 101(ST9), 1837–1853.
10.
Johansen, K. W. (1948). “The ultimate strength of reinforced concrete slabs, final report.” Proc., 3rd Congress, International Association for Bridge and Structural Engineering, Liege, Belgium, Sep.
11.
Kinnunen, S., and Nylander, H. (1960). “Punching of concrete slabs without shear reinforcement.” Trans. Royal Inst. of Technology, Stockholm, Sweden, No. 158.
12.
Ockleston, A. J. (1955). “Load tests of a three‐story reinforced concrete building in Johannesburg.” Struct. Engr., London, England, 33, Oct., 304–322.
13.
Ockleston, A. J. (1958). “Arching action in reinforced concrete slabs.” Struct. Engr., London, England, 36, 197–201.
14.
Ontario highway bridge design code. (1983). 2nd Ed., Ministry of Transportation and Communications, Highway Engineering Division, Ontario, Canada.
15.
Perdikaris, P. C., Beim, S., and Bousias, S. “Slab continuity effect on ultimate and fatigue strength of R/C bridge deck models,” ACI Struct. Engrg. J., (in press).
16.
Perdikaris, P. C., and Beim, S. (1986). “Fatigue strength of R/C bridge decks,” presented at the ACI Fall Convention, Physical Models in Engineering Education and Practice, Baltimore, Md., Nov.
17.
Sabnis, G. (1983). Structural modeling and experimental techniques, Prentice‐Hall, Inc., Englewood Cliffs, N.J.
18.
Sonoda, K., and Horikawa, T. (1982). “Fatigue strength of reinforced concrete slabs under moving loads.” Proceedings of the IABSE Colloquium, Fatigue of Steel and Concrete Structures, Lausanne, Switzerland, 37, 455–462.
19.
Tong, P. Y., and Batchelor, B. deV. (1971). “Compressive membrane enhancement in two‐way bridge slabs.” Special Publication SP‐30‐12, ACI, 271–286.
20.
Westergaard, H. M., and Slater, W. A. (1921). “Moments and stresses in slabs.” ACI Proc., 17, 415–538.
Information & Authors
Information
Published In
Copyright
Copyright © 1988 ASCE.
History
Published online: Mar 1, 1988
Published in print: Mar 1988
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.