Instability of Longitudinal Bars in RC Columns
Publication: Journal of Structural Engineering
Volume 114, Issue 2
Abstract
The collapse of reinforced concrete structural elements subjected to compression is linked to the instability of the reinforcement bars. This phenomenon may occur in the longitudinal region between two consecutive hoops, or may involve a number of hoops, deforming them through tension until they fail. A criterion is given which makes it possible to determine the unknown length of the region of longitudinal reinforcement involved, in relation to the geometrical and mechanical characteristics of the column. The critical load is then calculated assuming the configuration of a compressed straight bar with built‐in ends, bound on unilateral elastic supports. A comparison with the results obtained experimentally by other authors makes it possible to assess the reduction coefficient to apply to the theoretical values deduced.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bertero, V. (1979). “Seismic behavior of structural concrete linear elements (beams, columns) and their connections.” CEB Bulletin d'Information, 131, Rome, Italy 123–212.
2.
“Building code requirements for reinforced concrete.” (1983). ACI 318‐83, American Concrete Institute, Detroit, Mich.
3.
“Code of practice for design of concrete structures.” (1982). NZS 3101, New Zealand Standard, Standard Association of New Zealand, Auckland, New Zealand.
4.
Fafitis, A., and Shah, S. P. (1985). “Predictions of ultimate behavior of confined columns subjected to large deformations.” J. Am. Concr. Inst., 82(4), 423–433.
5.
Gerard, G. (1962). Introduction to structural stability theory. McGraw‐Hill Book Co., Inc., New York, N.Y.
6.
Kaar, P. H., and Corley, W. G., (1977). “Properties of confined concrete for design of earthquake resistant structures.” Proc. 6th World Conf. on Earthquake Engrg., Indian Society of Earthquake Technology, Vol. 1.
7.
“Model code for seismic design of concrete structures.” (1983). Bulletin d'information No. 160, Comité Euro‐International du Beton, Paris, France.
8.
Moehle, J. P., and Cavanagh, T. (1985). “Confinement effectiveness of crossties in RC.” J. Struct. Engrg., ASCE, 111(10), 2105–2120.
9.
Park, R., and Paulay, T. (1975). Reinforced concrete structures. John Wiley and Sons, New York, N.Y.
10.
Scott, B. D., Park, R., and Priestly, M. J. N. (1982). “Stress‐strain behavior of concrete confined by overlapping hoops at low and high strain rates.” J. Am. Concr. Inst., 79, Jan.–Feb., 13–27.
11.
Sheikh, S. A. (1982). “A comparative study of confinement models.” J. Am. Concr. Inst., 79, Jan.–Aug., 296–306.
12.
Sheikh, S. A., and Uzumeri, S. M. (1980). “Strength and ductility of tied concrete columns.” J. Struct. Div., ASCE, 106(5), 1079–1102.
13.
Timoshenko, S. P., and Gere, J. M. (1961). Theory of elastic stability. McGraw‐Hill Book Co., Inc., New York, N.Y.
14.
Vallenas, J., Bertero, V. V., and Popov, E. P. (1977). “Concrete confined by rectangular hoops and subjected to axial loads.” Report No. UCB/EERC‐771/13, Earthquake Engineering Research Center, University of California, Berkeley, Calif.
Information & Authors
Information
Published In
Copyright
Copyright © 1988 ASCE.
History
Published online: Feb 1, 1988
Published in print: Feb 1988
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.