Dynamic Characteristics of Wood and Gypsum Diaphragms
Publication: Journal of Structural Engineering
Volume 113, Issue 6
Abstract
Wood diaphragms are used in low‐rise, wood‐framed buildings to resist the lateral forces produced by wind and earthquakes. Since wood buildings are known to be efficient in absorbing the energy produced by these loadings, it is of importance to more fully understand the dynamic behavior of their components. Presented in this paper are the results from an experimental study performed to measure the dynamic characteristics of ten plywood and gypsumboard‐sheathed diaphragms. Four walls, three floors, and three ceilings were tested to determine natural frequencies and damping ratios. Results indicate that natural frequencies for the diaphragms proportions tested range from 8–29 Hz and vary depending on diaphragm displacement level. Using results of regression analysis, natural frequencies for various diaphragms may be predicted. Damping ratios were calculated and were found to range from 0.09–0.34.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Atherton, G. H. (1981). “Strength and stiffness of structural particleboard diaphragms.” Report of Project 818‐151A, Forest Research Laboratory, Oregon State University, Corvallis, Oreg.
2.
Carney, J. M. (1975). “Bibliography on wood and plywood diaphragms.” J. Struct. Engrg., ASCE, 101(11), 2423–2436.
3.
Easley, J. T., Foomani, M., and Dodds, R. H. (1982). “Formulas for wood shear walls.” J. Struct. Div., ASCE, 108(11), 2460–2478.
4.
Ewing, R. D., Healey, T. J., and Agbabian, M. S. (1980). “Seismic analysis of wood diaphragms,” presented at the April 11–19 ASCE Spring Convention and Exhibit held at Portland, Oreg.
5.
Freeman, S. A. (1977). “Racking tests of high righ building partitions.” J. Struct. Engrg., ASCE, 103(8), 1673–1685.
6.
GangaRao, H., Luttrell, L. D., and Putcha, C. (1980). “Seismic studies of timber diaphragms in low rise buildings,” presented at the ASCE Spring Session, Portland, Oreg.
7.
Gupta, A. K., and Kuo, G. P. (1985). “Behavior of wood‐framed shear walls.” J. Struct. Engrg., ASCE, 111(8), 1722–1733.
8.
Itani, R. Y., and Cheung, C. K. (1984). “Nonlinear analysis of sheathed wood diaphragms.” J. Struct. Engrg., ASCE, 110(9), 2137–2147.
9.
Kallsner, B. (1983). “Windaussteifung von Wandkonstruktionen im Holzskelettbau mit Plattenwerkstoffen.” Bauen mit Holz, 374–377, (in German).
10.
Kamiya, F. (1981). “Theoretical studies on racking stiffness and strength of wooden sheathed walls.” Trans. Architect. Inst. of Japan, 309, 86–92.
11.
Patton‐Mallory, M. Gutkowski, R. M., and Soltis, L. A. (1984). “Racking performance of light‐frame walls sheathed on two sides.” FPL 448, USDA Forest Products Lab., Madison, Wisc.
12.
Penzien, J. (1965). “Applications of random vibration theory.” Bull. Int. Inst. Seismology and Earthquake Engrg. (Tokyo, Japan), 2, 47–69.
13.
Peterson, J. (1983). “Bibliography on lumber and wood panel diaphragms.” J. Struct. Engrg., ASCE, 109(12), 2838–2852.
14.
Polensek, A. (1975). “Damping capacity of nailed wood‐joist floors.” Wood Sci., 8(2), 141–151.
15.
Soltis, L. A., Wolfe, R. W., and Tuomi, P. L. (1981). “Design approaches for light‐frame racking walls.” Proceedings of Wall and Floor Systems: Design and Performance of Light Frame Stucture Conference, Denver, Colo., 101–111.
16.
Tissell, J. R. (1967). “1966 horizontal diaphragm tests.” Laboratory Report 106, Amer. Plywood Assoc.
17.
Tissell, J. R. and Elliott, J. R. (1977). “Plywood diaphragms.” Research Report 138, Amer. Plywood Assoc.
18.
Tuomi, R. L., and McCutcheon, W. J. (1978). “Racking strength of light‐frame nailed walls.” J. Struct. Div., ASCE, 104(7), 1131–1140.
19.
Yasumura, M., and Sugiyama, H. (1983). “Rigidity and strength of plywoodsheathed wall panels under reversed cyclic loading.” Trans. of A.I.J., 329, 64–71.
20.
Yasumura, M., and Sugiyama, H. (1984). “Shear properties of plywood‐sheathed wall panels with openings.” Trans. of A.I.J., 338, 88–96.
21.
Yeh, C. T., Hartz, B. J., and Brown, C. B. (1971). “Damping sources in wood structures.” J. Sound and Vibration, 19(4), 411–419.
22.
Young, D. H. and Medearis, K. (1962). “An investigation of the structural damping characteristics of composite wood structures subjected to cyclic loading.” Technical Report No. 11, Department of Civil Engineering, Stanford Univ.
Information & Authors
Information
Published In
Copyright
Copyright © 1987 ASCE.
History
Published online: Jun 1, 1987
Published in print: Jun 1987
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.