Ductility, Snapback, Size Effect, and Redistribution in Softening Beams or Frames
Publication: Journal of Structural Engineering
Volume 113, Issue 12
Abstract
A layered finite element model with strain‐softening material properties, whose applicability to reinforced concrete was corroborated by comparisons with experimental data in the preceding paper, is used in a parametric study aimed at the effect of several factors: structure size, finite element size, downward slope of strain‐softening stress‐strain relation, length of the plastic yield plateau before the onset of strain softening (if any), and end‐restraint stiffness. To quantify the response, several new response characteristics are introduced: the ductile strengthening factor, characterizing how strain softening reduces the maximum load compared to the plastic limit load; the redistribution ratio, characterizing the degree of bending moment redistribution in comparison to that in plastic limit analysis; the energy safety factor, describing the energy to deform the structure to the peak load; and the ductility factor, characterizing the deflection increase at maximum load relative to the deflection from elastic analysis. The condition of snapback instability, which determines the ductility factor, is derived analytically for an elastically restrained beam. Finally, it is shown that strain‐softening segments in beams cannot be modeled as softening hinges except for sufficiently slender beams.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
ACI 328–83 (1983). “Building code requirements for reinforced concrete.” American Concrete Institute, Detroit, Mich.
2.
Baker, A. L. L., and Amarakone, A. M. N. (1964). “Inelastic hyperstatic frames analysis.” Proc. Int. Symp. on the Flexural Mech. of Reinforced Concrete, American Concrete Institute Special Publication No. 12, Miami, Fla., 85–142.
3.
Barnard, P. R. (1965). “The collapse of reinforced concrete beams.” Proc. Int. Symp. Flexural Mech. of Reinforced Concrete, held in Miami, Fla. American Concrete Institute Special Publication No. 12, Detroit, Mich., 5‐1‐520.
4.
Bažant, Z. P. (1976). “Instability ductility and size effect in strain‐softening concrete.” J. Engrg. Mech. Div., ASCE, 102(2), 331–334,
with closure Vol. 103, pp. 357–358, 775–777;
based on Struct. Eng. Report No. 74‐8/640 Northwestern University, August 1974.
5.
Bažant, Z. P. (1984). “Size effect in blunt fracture: Concrete, rock, metal,” J. of Engrg. Mech., ASCE, 110(4), 518–535.
6.
Bažant, Z. P. (1985). “Fracture mechanics and strain‐softemng of concrete.” Proc. U.S.‐Japan Seminar on Finite Element Analysis of R. C. Struct., held in Tokyo, Japan, ASME, New York, C. Meyer and H. Okamura, eds., American Society of Mechanical Engineers, New York, N.Y., 121–150.
7.
Bažant, Z. P. (1986). “Mechanics of distributed cracking.” Applied Mech. Rev., ASME, 40(2), 675–705.
8.
Bažant, Z. P., Belytschko, T. B., and Chang, T. P. (1984). “Continuum theory for strain‐softening.” J. Engrg. Mech., ASCE, 110, 1666–1692.
9.
Bažant, Z. P., and Oh, B. H. (1983). “Crack‐band theory for fracture of concrete.” Matériaux et constructions, 16(32), 155–177.
10.
Bažant, Z. P., Pan, Y., and Pijaudier‐Cabot, G. (1986). “Softening in reinforced concrete beams and frames.” Report No. 86‐7/428s, Center for Concrete and Geomaterials, Northwestern Univ., Evanston, Ill.
11.
Bažant, Z. P., and Panula, L. (1978). “Statistical stability effects in concrete failure.” J. Engrg. Mech., ASCE, 104(5), 1195–1212.
12.
Bažant, Z. P., and Pijaudier‐Cabot, G. (1987). “Modeling of distributed damage by nonlocal continuum with local strain.” Proc., 4th Int. Conf. on Numer. Meth. Fracture Mech., A. P. Luxmoore, R. J. Owen and M. F. Kanninen, eds., held in San Antonio, Tex., Pineridge Press, Swansea, U.K., 411–423.
13.
Crisfield, M. A. (1983). “An arc‐length method including line searchers and accelerations.” Int. J. of Numer. Meth. Engrg., 19, 1269–1289.
14.
Darvall, P. LeP. (1984). “Critical softening of hinges in portal frames.” J. of Struct. Engrg., ASCE, 110(1), 157–162.
15.
Darvall, P. LeP. (1983). “Critical softening of hinges in indeterminate beams and portal frames“. Civ. Engrg. Trans., CE25(3), I. E. Australia, Clayton, Australia, 199–210.
16.
Darvall, P. LeP. (1983). “Some aspects of softening in flexural members.” Res. Report 311983, Dept. of Civ. Engrg., Monash Univ., Clayton, Australia.
17.
Darvall, P. LeP., and Mendis, P. A. (1985). “Elastic‐plastic‐softening analysis of plane frames.” J. of Struct. Engrg., ASCE, 111(4), 871–888.
18.
Ghosh, S. K., and Cohn, M. Z. (1972). “Nonlinear analysis of strain‐softening structures.” Inelasticity and nonlinearity in structural concrete. M. Z. Cohn, ed., Study No. 8, Univ. of Waterloo Pres, Waterloo, Ontario, Canada, 315–332.
19.
Hand, F. R., Pecknold, D. A., and Schnobrich, W. C. (1973). “Nonlinear layered analysis of RC plates and shells.” J. Struct. Div., ASCE, 99(7), 1491–1505.
20.
Lin, C. S., and Scordelis, A. (1975). “Nonlinear analysis of RC shells of general form.” J. Struct. Div., ASCE, 101(3), 523–538.
21.
Maier, G. (1967). “On elastic‐plastic structures with associated stress‐strain relations allowing for work softening.” Meccanica, 2(1), 55–64.
22.
Maier, G. (1967). “Extremum theorems for the analysis of elastic plastic structures containing unstable elements.” Meccanica, 2(4), 235–242.
23.
Maier, G. (1971). “Incremental plastic analysis in the presence of large displacements and physical instabilitizing effects.” Int. J. of Solids and Struct., 7, 345–372.
24.
Maier, G., Zavelani, A., and Dotreppe, J. C. (1973). “Equilibrium branching due to flexural softening.” J. of Engrg. Mech. Div., ASCE, 99(4), 897–901.
25.
Maier, G. (1971). “On structural stability due to strain‐softening.” IUTAM Symp. on Instability of Continuous Systems, held at Herrenhalb, Germany, Sept., 1969, Springer‐Verlag, West Berlin, Germany, 411–417.
26.
Mróz, Z. (1985). “Current problems and new directions in mechanics of geomaterials.” Chapter 24, Mechanics of geomaterials: Rocks, concretes, soils, Z. P. Bažant, ed., John Wiley and Sons, Chichester, England, New York, N.Y., 534–566.
27.
Pijaudier‐Cabot, G., and Bazant, Z. P. (1986). “Nonlocal damage theory.” Report No. 86‐8/428n, Northwestern Univ., Evanston, Ill.
28.
Schnobrich, W. C. (1982). “Concrete cracking.” Finite element analysis of reinforced concrete (state‐of‐the‐art report), Chapter 4, ASCE, New York, N.Y., 204–233.
29.
Warner, R. F. (1984). “Computer simulation of the collapse behavior of concrete structures with limited ductility.” Proc. Int. Conf. Computer‐Aided Analysis and Design of Concrete Struct., held in Split, Yugoslavia, F. Damjanic, E. Hinton, et al., eds., Pineridge Press, Swansea, England, 1257–1270.
30.
Wood, R. H. (1968). “Some controversial and curious developments in the plastic theory of structures.” Engineering plasticity. J. Heyman and F. A. Leckie, eds., Cambridge, Univ. Press, Cambridge, England, 665–691.
Information & Authors
Information
Published In
Copyright
Copyright © 1987 ASCE.
History
Published online: Dec 1, 1987
Published in print: Dec 1987
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.