Gable Frame Design Considerations
Publication: Journal of Structural Engineering
Volume 111, Issue 7
Abstract
A gable frame design is reviewed with regard to the modeling, load specification, and strength evaluation. It is found that the approximation used for the boundary conditions at the column bases should adequately account for the behavior of the foundation and more than one approximation may be necessary. Uneven loading is shown to be very significant, and it is recommended that gable frames always be designed for some uneven distribution of load. The question of the correct effective length for the rafter is examined, and a nonlinear analysis or an approximate, but conservative, approach is suggested for gables with significant axial load in the rafter. One method of utilizing a frame buckling analysis in a conventional AISC evaluation is presented. It is suggested that if there is significant axial stress in the rafter, caution should be exercised in the use of specification limitations, which are based on girder behavior where there may have been no axial stress considered in the derivation and testing of the specification limitations.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Manual of Steel Construction, Specification for the Design, Fabrication and Erection of Structural Steel for Buildings, AISC, 8th ed., 1980.
2.
BOCA Basic Building Code, 6th ed., 1975.
3.
Metal Building Systems Manual, 1981 ed., Metal Building Manufacturers Assoc., Cleveland, Ohio.
4.
Basler, K., and Thurlimann, B., “Plate Girders‐Strength in Bending,” Transactions ASCE, Vol. 128, Part II, 1963, pp. 655–683.
5.
Bath, K. J., Wilson, E. L., and Peterson, F. E., SAP IV, A Structural Analysis Program for Static and Dynamic Response of Linear Systems, EERC Report No. 73‐11, Rev., Apr., 1974.
6.
Gallagher, R. H., and Lee, C. H., “Matrix Dynamic and Instability Analysis with Non‐Uniform Elements,” International Journal for Numerical Methods in Engineering, Vol. 2, 1970, pp. 265–275.
7.
Hansell, W., “Single Story Rigid Frames,” Chapter 20, Structural Steel Design, Lambert Tall, ed., Ronald Press, 2nd ed., 1974.
8.
Korn, M. P., Steel Rigid Frames Manual Design & Construction, J. W. Edwards Inc., Ann Arbor, Mich., 1953.
9.
Lee, G. C., Letter, R. L., Hsu, T. L., Design of Single Story Rigid Frames, Metal Building Manufacturing Association, 1981.
10.
Lu, Le‐Wu, “Effective Length of Columns in Gable Frames,” AISC Engineering Journal, Jan., 1965, pp. 6–7.
11.
Martin, H. C., Introduction to Matrix Methods of Structural Analysis, McGraw‐Hill Book Co., 1966.
12.
Powell, G. H., “Theory of Nonlinear Elastic Structures,” Journal of the Structural Division, ASCE, Vol. 95, No. ST12, Dec., 1969, pp. 2687–2701.
13.
Roark, R. J., and Young, W. C., Formulas for Stress and Strain, 5th ed., McGraw‐Hill Book Co., New York, N.Y., 1975.
14.
Salmon, C. G., and Johnson, J. E., Steel Structures Design and Behavior, 2nd ed., Intext Publishers, 1980.
Information & Authors
Information
Published In
Copyright
Copyright © 1985 ASCE.
History
Published online: Jul 1, 1985
Published in print: Jul 1985
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.