Performance Study of SPAW Model with Temperature-Derived as Input in Place of Pan Evaporation under Wheat Crop in a Semiarid Subtropical Climate
Publication: Journal of Irrigation and Drainage Engineering
Volume 134, Issue 6
Abstract
In this study, we have attempted to enhance the utility of soil–plant–atmosphere–water (SPAW) model that has been used successfully by various workers in different countries for soil moisture prediction under different cropping conditions. One of the major climatic inputs for SPAW model is pan evaporation, which in many places is not readily available. To address the above, and to get the benefit of this model in regions characterized by limited weather data availability, this study was undertaken using computed from air temperature by the 1985 Hargreaves equation, as one of the inputs in place of pan evaporation. For the purpose, actual air temperature collected from experimental farm area, as well as forecast air temperature collected from National Centre for Medium Range Weather Forecasting, Government of India, were used. First, the SPAW model was calibrated and its performance was evaluated under wheat, taking layerwise and profile soil moisture as the variables for comparison between the predicted and observed values. The results showed that the root-mean-square error (RMSE) varied from for measured values ranging between 2.24 and . The index of agreement varied from 0.81 to 0.92 and coefficient of determination from 0.46 to 0.73 for 0–15, 15–30, 30–45, and soil depths. For the whole profile, the RMSE was with and values of 0.94 and 0.85 respectively. The RMSE and varied from and 0.77 to 0.89 respectively when computed from actual air temperature was used in place of pan evaporation, where as when computed from forecast air temperature data was used, the corresponding values were and 0.68–0.85 respectively for the four soil layers. There was a tendency of the models to underestimate when the computed was used as input in place of pan evaporation. In general, performance of the models were better at lower depths.
Get full access to this article
View all available purchase options and get full access to this article.
References
Arora, V. K., and Gajri, P. R. (1996). “Performance of simplified water balance models under maize in a semiarid subtropical environment.” Agric. Water Manage., 31(1), 51–64.
Bassett, D. L., Saxton, K. E., and Bluhm, G. C. (1983). “Simulating crop water use and stress under irrigation.” Proc., American Society of Agriculture Engineering, Paper No. 83, 2097.
Blake, G. R. (1965). “Methods of soil analysis,” American Society of Agronomy, Madison, Wis., 374–390.
Bouyoucos, G. J. (1962). “Hydrometer method improved for making particle size analysis of soils.” J. Inf. Storage Process. Syst., 54, 454–465.
De Jong, R., and Zentner, R. P. (1985). “Assessment of the SPAW model for semiarid growing conditions with minimal local calibration.” Agric. Water Manage., 10, 31–46.
Gupta, S. (1992). “Modeling soil water and studies on soil temperature under different management practices in pearl millet and chickpea.” Ph.D. thesis, Indian Agricultural Research Institute, New Delhi.
Hargreaves, G. H., and Samani, Z. A. (1985). “Reference crop evapotranspiration from temperature.” Appl. Eng. Agric., 1, 96–99.
Jensen, M. E., Burman, R. D., and Allen, R. G., eds. (1990). “Evapotranspiration and irrigation water requirements.” ASCE Manual No. 70, ASCE, New York.
Kumar, A., Maini, P., Rathore, L. S., and Singh, S. V. (2000). “An operational medium range local weather forecasting system developed in India.” Int. J. Climatol., 20, 73–87.
Kushwaha, H. S., and Rai, H. K. (1999). “Simulation of profile soil moisture using SPAW model for scheduling irrigation in wheat.” Proc., National Workshop on Dynamic Crop Simulation Modeling for Agrometeorological Advisory Services, National Centre for Medium Range Weather Forecasting, New Delhi, 223–227.
Rai, H. K., and Kushwaha, H. S. (2001). “Verification and validation of SPAW model for wheat under humid subtropical climate of Tarai.” Int. J. Tropical Agric., 19, 163–172.
Rathore, L. S., Mendiratta, N., and Singh, K. K. (1998). “Soil moisture prediction under maize in sandy loam.” Ann. Arid Zone, 37(1), 47–52.
Rathore, L. S., Srinivasan, G., and Singh, K. K. (1994). “Soil moisture and evapotranspiration simulations for irrigated wheat using the soil–plant–atmosphere–water (SPAW) model.” Mausam, 45(1), 63–68.
Richards, L. A. (1949). “Methods of mounting porous plate used in soil moisture measurements.” Agron. J., 41, 489–490.
Ritchie, J. T. (1972). “Model for predicting evaporation from a row crop with incomplete cover.” Water Resour. Res., 8, 2104–2113.
Ritchie, J. T. (1985). “A user-oriented model of the soil water balance in wheat.” Wheat growth and modeling, NATO ASI Series, W. Day, and R. K. Atkin, eds., Plenum, New York.
Saxton, K. E. (1989). “A soil–plant–atmosphere–water model.” Version 3.1 PC, United States Department of Agriculture (USDA)–Science and Education Administration (SEA)–Agriculture Research (AR), Pullman, Wash.
Saxton, K. E., and Bluhm, G. C. (1982). “Regional prediction of crop water stress by soil water budgets and climatic demand.” Trans. ASAE, 25, 105–110.
Saxton, K. E., Johnson, H. P., and Shaw, R. H (1974). “Modeling evapotranspiration and soil moisture.” Trans. ASAE, 17(4), 673–677.
Willmott, C. J. (1982). “Some comments on the evaluation of model performance.” Bull. Am. Meteorol. Soc., 63, 1309–1313.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Nov 2, 2007
Accepted: Jan 31, 2008
Published online: Dec 1, 2008
Published in print: Dec 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.