Probabilistic Approach to Estimation of Urban Storm-Water Total Maximum Daily Loads: Unregulated Catchment
Publication: Journal of Irrigation and Drainage Engineering
Volume 134, Issue 5
Abstract
This work examines the basic processes and functions behind urban storm-water pollution delivery into surface waters and develops a set of tools that allow the estimation of pollutant load dynamics on receiving waters. In particular, the group of expressions developed in this paper allows the calculation of runoff parameters (volume, discharge rate and pollutant load) on an event average basis for an unregulated catchment. Using Monte Carlo simulation techniques, the runoff pollutant concentration probability distribution (as event averages) are obtained. Merging these runoff statistics with the stream parameters allows the receiving water pollutant concentration characteristics to be obtained as well as the probability of exceeding threshold pollutant concentrations in the mixing zone of a stream. The simulation can be performed with allowance for different levels of complexity with respect to catchment hydrologic representation and pollutant load functions. As a result, the magnitude of influence of urban runoff on a surface water body can be determined, pollutants of concern can be identified, and certain remedial measures recommended.
Get full access to this article
View all available purchase options and get full access to this article.
References
Adams, B. J., and Papa, F. (2000). Urban stormwater management planning with analytical probabilistic models, Wiley, New York.
Behera, P. K. (2001). “Urban stormwater quality control analysis.” Ph.D. dissertation, Dept. of Civil Engineering, Univ. of Toronto, Toronto.
Bumgarder, J., Ruby, A., Walker, M., and Brent, D. (1994). “Discharge characterization of urban stormwater runoff using continuous simulation.” Current practices in modelling the management of stormwater impacts, W. James, ed., Lewis, Boca Raton, Fla., 243–256.
Chen, J. (2003). “Integrated urban stormwater management modeling.” Ph.D. dissertation, Dept. of Civil Engineering, Univ. of Toronto, Toronto.
DiToro, D. M. (1984). “Probability model of stream quality due to runoff.” J. Environ. Eng., 110(3), 607–628.
Eagleson, P. S. (1972). “Dynamics of flood frequency.” Water Resour. Res., 8 (4), 878–897.
Guo, Y., and Adams, B. J. (1998). “Hydrologic analysis of urban catchments with event-based probabilistic model. I: Runoff volume.” Water Resour. Res., 34(12), 3421–3431.
Huber, W. C. (1986). “Deterministic modeling of urban runoff quality.” Proc., Urban Runoff Pollution, H. C. Torno et al., eds., Springer, Berlin, 167–242.
Huber, W. C., and Dickinson, R. E. (1988). SWMM version 4 user’s manual, U.S. Environmental Protection Agency. Environmental Research Laboratory, Office of Research and Development. Athens, Ga.
Kerby, W. S. (1959). “Time of concentration for overland flow.” Civ. Eng. (N.Y.), 29(3), 174.
Novotny, V. (2003). Water quality: Diffuse pollution and watershed management, 2nd Ed., Wiley, New York.
Novotny, V., Feizhou, L., and Wawrzyn, W. G. (1994). “Monte Carlo modeling of water and sediment contamination by toxic metals at the North Avenue Dam, Milwaukee, WI, USA.” Water Sci. Technol., 30(2), 109–119.
Novotny, V., and White, J. (1997).“Ascertaining aquatic ecological risks of urban stormwater discharges.” Water Res., 31(10), 2573–2585.
Papadakis, C. N., and Kazan, M. N. (1987), “Time of concentration in small rural watersheds.” Proc., 1987 ASCE Engineering Hydrology Symp., 633–638.
Pratt, C. J., and Harrison, J. J. (1986). “Development and assessment of a runoff simulation model for Clifton Grove Catchment, Nottingham, UK.” Urban Drainage Modelling. Proc., Int. Symp. on Comparison of Urban Drainage Models with Real Catchment Data, UDM’86, Pergamon, New York.
Roesner, L. R. (1982). “Quality of urban runoff.” Urban stormwater hydrology, AGU, water resources monograph 7, Washington, D.C.
U.S. Army Corps of Engineers (USACE). (1974). Storage, treatment, overflow, runoff model: STORM, 723-S8-L2520, Hydrologic Engineering Center, Davis, Calif.
U.S. Environmental Protection Agency (USEPA). (1992), “Dynamic toxics waste load allocation model (DYNTOX).” Version 2.1, user’s manual, EPA#440/4-84-035, ⟨http://www.epa.gov/waterscience/library/modeling/dyntox.pdf⟩ (May 1, 2007).
U.S. Environmental Protection Agency (USEPA). (2006). “River and stream water quality model (QUAL2K): Fact sheet.” ⟨http://www.epa.gov/athens/wwqtsc/QUAL2K.pdf⟩ (Dec. 18, 2006).
U.S. Environmental Protection Agency (USEPA). (2007). “BASINS 3.0 user manual.” Section 9. BASINS utilities, ⟨http://www.epa.gov/waterscience/basins/b3docs/sec9.pdf⟩ (Apr. 9, 2007).
U.S. Geological Survey (USGS). (2006). “Water resources application software.” Summary of HSPF, ⟨http://water.usgs.gov/cgi-bin/man_wrdapp?hspf⟩ (Dec. 15, 2006).
U.S. Geological Survey (USGS). (2007). “Water resources application software.” Summary of PRMS, ⟨http://water.usgs.gov/cgi-bin/man_wrdapp?prms(1)⟩ (Apr. 5, 2007).
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Jun 9, 2007
Accepted: Oct 24, 2007
Published online: Oct 1, 2008
Published in print: Oct 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.