Sprinkler Head Maintenance Effects on Water Application Uniformity
Publication: Journal of Irrigation and Drainage Engineering
Volume 126, Issue 3
Abstract
The effects of wear on the ability of hand-move and side-roll sprinkler irrigation systems to maintain the designed water application rate and uniformity are of concern with regards to crop performance, water use efficiency, and environmental impact. Six hand-move and six side-roll sprinkler irrigation systems used under commercial crop production in Lane County, Oreg., were evaluated for equipment wear and performance. Individual sprinkler nozzle size and discharge rates were measured for each system and used in a computer model to estimate field application rate and uniformity. New nozzles were installed on six systems to compare potential application rate and uniformity with existing performance. Despite reducing the coefficient of variation in discharge between sprinklers from 10 to 2%, little increase in water application uniformity was attained. A 13% decrease in mean water application rate was documented after nozzle replacement. Ignored overapplication due to worn or mismatched nozzles results in overirrigation in both rate and total amount, which gives rise to the potential for increased surface redistribution and deep percolation, resulting in water and nutrient losses.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Allen, R. G. ( 1992). Catch-3D sprinkler pattern analysis software; user's manual. Dept. of Biol. and Irrig. Engrg., Utah State University, Logan, Utah.
2.
Bean, A. G. M. (1965). “Water distribution by irrigation sprinklers.” J. Agric. Engrg. Res., 10(4), 314–321.
3.
Bilanski, W. K., and Kidder, E. H. (1958). “Factors that affect the distribution of water from a medium-pressure rotary irrigation sprinkler.” Trans. ASAE, 1(1), 19–28.
4.
Branscheid, V. O., and Hart, W. E. (1968). “Predicting field distributions of a sprinkler system.” Trans. ASAE, 11(6), 801–803, 808.
5.
Center for Irrigation Technology (CIT). ( 1996). Irrigation equipment performance index. CATI Publ. 960801, California State University at Fresno, Fresno, Calif.
6.
Chen, D., and Wallender, W. W. (1984). “Economic sprinkler selection, spacing, and orientation.” Trans. ASAE, 27(3), 737–743.
7.
Christiansen, J. E. ( 1942). “Irrigation by sprinkling.” Agric. Experiment Station Bull. 670, University of California, Berkeley.
8.
Cuenca, R. H. (1989). Irrigation system design—an engineering approach. Prentice-Hall, Englewood Cliffs, N.J.
9.
Elliott, R. L., Hart, W. E., Loftis, J. C., and Nelson, J. D. (1980). “Comparison of sprinkler uniformity models.”J. Irrig. and Drain. Div., ASCE, 106(4), 321–330.
10.
Fukui, Y., Nakanishi, K., and Okamura, S. (1980). “Computer evaluation of sprinkler irrigation uniformity.” Irrig. Sci., Berlin, 2(1), 23–32.
11.
Griffin, S. G. ( 1978). “Computer programming solid set systems.” ASAE Paper No. 78-2012, ASAE, St. Joseph, Mich.
12.
Hart, W. E. (1961). “Overhead irrigation pattern parameters.” Agric. Engrg., 42(7), 354–355.
13.
Hart, W. E. (1963). “Sprinkler distribution analysis with a digital computer.” Trans. ASAE, 6(2), 206–208.
14.
Hart, W. E., and Reynolds, W. N. (1965). “Analytical design of sprinkler systems.” Trans. ASAE, 7(4), 83–85, 89.
15.
Li, J., and Kawano, H. (1996). “Sprinkler rotation nonuniformity and water distribution.” Trans. ASAE, 39(6), 2027–2031.
16.
Nderitu, S. M., and Hills, D. J. (1993). “Sprinkler uniformity as affected by riser characteristics.” Appl. Engrg. in Agr., 9(6), 515–521.
17.
Oliphant, J. C. ( 1993). SPACE for Windows;ot; software update. CATI Publ. 930403, Ctr. for Irrig. Technol., California State University at Fresno, Fresno, Calif.
18.
Seginer, I., and Kostrinsky, M. (1975). “Wind, sprinkler patterns, and system design.”J. Irrig. and Drain. Div., ASCE, 101(4), 251–264.
19.
Seginer, I., Nir, D., and von Bernuth, R. D. (1991). “Simulation of wind-distorted sprinkler patterns.”J. Irrig. and Drain. Engrg., ASCE, 117(2), 285–306.
20.
Seginer, I., Kantz, D., Nir, D., and von Bernuth, R. D. (1992). “Indoor measurement of single-radius sprinkler patterns.” Trans. ASAE, 35(2), 523–533.
21.
Vories, E. D., and von Bernuth, R. D. (1986). “Single nozzle sprinkler performance in wind.” Trans. ASAE, 29(5), 1325–1330.
Information & Authors
Information
Published In
History
Received: Jul 6, 1999
Published online: May 1, 2000
Published in print: May 2000
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.